EMP Tek EMS Leitfaden
ON-WALL SPEAKERS
Model EMS
SPEAKER STANDS
USER & INSTALL ATION MANUAL
Instructions
Step 1. Attach the Bottom Post (BP) to the Base with the Long Joining Screw (LJS) and Allen Key (AK)
supplied. NOTE: Please make sure that the wire management hole faces to the back of the base.
(see diagram 1)
Step 2. Attach the Rubber Bumpers (RB) to the underside of the base. (see diagram 1)
Step 3. Insert the Top Post (TP) into the Bottom Post (BP). Make sure that the Wire Management Hole
is to the top. (see diagram 2)
Step 4. Install the Locking Screw (LS) into the threaded hole in the top of the Bottom Post (BP), and
tighten. (see diagram 2)
Step 5. Attach the Mounting Bracket (MB) to the Top Post (TP) using the Short Joining Screws (SJS)
and Allen Key (AK), make sure the back of the mounting bracket faces the wire management
hole. (see diagram 3).
OPTIONAL: Attach the Mounting Plate (MP) to the Top Post (TP) using the Counter Sink
Screws (CS) and Allen Key (AK). Use the Double-Sided Tape to prevent the speaker from
sliding by adhering the tape in between the mounting plate and the speaker. Using the tape is
optional as it may not be removable later.
Step 6. Attach the speakers to the Mounting Bracket (MB) using the appropriate Mounting Screw
(MS) and Washer (W) for your speaker. Tighten rmly, using the Allen key (AK) supplied. (see
diagram 3)
Step 7. Adjust the stand height by loosening the Locking Screw (LS), adjusting the height of the
speaker to the desired height and then re-tightening the Locking Screw (LS) fully. Feed the
speaker wire through the post and connect to the system. (see diagram 4)
Step 8. Repeat steps 1 through 7 for other stand.
Kit Contents
Warranty
Your EMS Speaker Stands are covered by a limited warranty against defects in materials
and workmanship for a period of 1 year from the original date of purchase. is warranty
is provided by the authorized EMP Tek dealer where the speaker was purchased. Warranty
repair will be performed only when your purchase receipt is presented as proof of ownership
and date of purchase. Defective parts will be repaired or replaced without charge by your
dealer’s store or the location designated by your dealer authorized to service EMP Tek products.
Charges for unauthorized service and transportation cost are not reimbursable under this
warranty. is warranty becomes void if the product has been damaged by alteration, misuse
or neglect. e warrantor assumes no liability for property damage or any other incidental
or consequential damage whatsoever which may result from the failure of this product. Any
and all warranties of merchantability and tness implied by law are limited to the duration of
this express warranty. Some states do not allow limitations on how long an implied warranty
lasts, so the above limitations may not apply to you. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
382 Marshall Way, Layton, Utah • USA • 84041
Toll Free: (800) 543-2205 • Fax: (801) 543-3300
www.emptek.net
It is EMP Tek policy to continuously incorporate improvements into products; all specications are subject to change without notice.
Copyright © 2007 EMP Tek. All Rights Reserved.
Inhaltsverzeichnis
Andere EMP Tek Sprecher Handbücher
EMP Tek
EMP Tek EF50 SERIES Bedienungsanleitung
EMP Tek
EMP Tek E3c Leitfaden
EMP Tek
EMP Tek 41-SE Bedienungsanleitung
EMP Tek
EMP Tek EW25 Leitfaden
EMP Tek
EMP Tek CS100 Bedienungsanleitung
EMP Tek
EMP Tek IMPRESSION SERIES Bedienungsanleitung
EMP Tek
EMP Tek EF30 SERIES Bedienungsanleitung
EMP Tek
EMP Tek E41-B Bedienungsanleitung
EMP Tek
EMP Tek ECA4 Leitfaden
EMP Tek
EMP Tek ER8 Bedienungsanleitung
Beliebte Sprecher Handbücher anderer Marken
Bowers & Wilkins
Bowers & Wilkins 4 Bedienungsanleitung
Sonance
Sonance SONOS OUTDOOR Series Bedienungsanleitung
Electro-Voice
Electro-Voice EVID FM4.2 Bedienungsanleitung
Pioneer
Pioneer XW-HTD630 Bedienungsanleitung
Onn
Onn BWA16AA002 Bedienungsanleitung
HP
HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung