2
Safety warning and precaution
1. KEEP WORK AREA CLEAN AND DRY
Cluttered, or wet work areas can cause
injuries.
2. KEEP CHILDREN AWAY FROM
WORK AREA
Do not allow children to handle this
winch.
3. DO NOT USE THIS WINCH IF
UNDER THE INFLUENCE OF
ALCOHOL OR DRUGS
Read warning labels on the winch to
determine if your judgement of
reflexes are impaired while taking
drugs. If there is any doubt, do not
attempt to use this winch.
4. USE EYE AND HAND PROTECTION
Wear safety impact eyeglasses and
heavy duty work gloves when using
this winch.
5. DRESS SAFELY
Do not wear loose clothing or
jewelry, as they can become caught
in moving parts. Wear a protective
hair covering to prevent long hair
from becoming caught in moving
parts. If wearing a long sleeve shirt,
roll sleeves up above elbows.
6. DO NOT OVERREACH
Keep proper footing and balance at
all times to prevent tripping, falling,
back injury, etc.
7. STAY ALERT
Watch what you are doing at all times.
Use common sense. Do not use this
winch when you are tired.
8. CHECK FOR DAMAGED PARTS
Before using this winch, carefully check
that it will operate properly and
perform its intended function. Check
for damaged parts and any other
conditions that may affect the operation
of this winch. Replace or repair damaged
or worn parts immediately.
9. REPLACEMENT PARTS AND
ACCESSORIES
When servicing, use only identical parts.
Only use accessories intended for use
with this winch.
10.MAINTENANCE
For your safety, service and maintenance
should be performed regularly by a
qualified technician.
WARNING:
The warnings, precautions and
instructions discussed in this Manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
Special warnings and
precautions
1. CAUTION: Never exceed the
maximum load capacity specified
for each model.
3. AVOID SIDEWAYS CABLE SLIP
The cable under a load should
only be wound on to the drum to
such an extent that a minimum
space of 2 times the cable diameter
remains on the drum flange
(see Figure 1). Winch overloading
and a sideway cable slip will here
be avoided.
2. AUTOMATIC MECHANICAL
BRAKE REQUIREMENT
The minimum tractive force (pulling
load) required for a proper braking
function on the winch is 55 lbs
(25kgs). Without this minimum
load, the braking function will
not take place.
Figure 1
4. ALWAYS LEAVE AT LEAST 5
WRAPS OF THE CABLE ON
THE DRUM
Failure to do so may break cable
connection to drum and may
result in serious accident.
(see Figure 2)
Figure 2
5. DO NOT OIL OR GREASE THE
BRAKE MECHANISM
Oil or grease will make the winch
reduce or lose brake function.
6. ALWAYS USE PROPER
COUPLINGS WHEN CONNECTING
THE WINCH CABLE HOOK TO A
LOAD.
7. MAKE SURE THE WINCH BASE
IS PROPERLY BOLTED TO A
STRUCTURE (OR VEHICLE)THAT
CAN HOLD WINCH AND WINCH
LOAD
Failure to bolt down the winch
properly can result in personal
injury and/or property damage.
8. DO NOT USE ANY ATTACHMENTS
to extend the length of the winch
cable.
9. AFTER MOVING AN OBJECT WITH
THE WINCH, SECURE THE OBJECT.
DO NOT RELY ON THE WINCH TO
HOLD AN OBJECT FOR AN
EXTENDED PERIOD OF TIME.
RWP2000-01 and RWP2000-02
5 wraps
m=freeboard≥2d(mm)
D
d
m
F
W
