ENFORCER NE-SE01-020Q Bedienungsanleitung





NE-SE01-020Q

Passive Ethernet Extender over Coax

Manual

1 Channel Ethernet over coax

10/100 Mbps Full duplex*

Transmission distance:**

-Up to 650ft (200m)@10Mbps

-Up to 325ft (100m)@100Mbps

Passive, no power required

Built-in surge protection

Fast and easy to install

Sold as a set



* Use only with 10/100 Switches

** Actual transmission range will vary depending on equipment used and cable grade.

ENFORCER Passive Ethernet Extender over Coax 

2SECO-LARM U.S.A., Inc.





Introduction:

ENFORCER Passive Ethernet Extender over Coax is designed to extend the range of any

TCP/IP device beyond the 300ft (100m) limit of Ethernet. The unit does not filter out any

protocols, codes, or applications, ensuring compatibility with any IP camera and its

software.

Specifications:

Type Passive Ethernet Extender over Coax

Range* 10Mbps (RG59) Up to 650ft (200m)

100Mbps (RG59) Up to 325ft (100m)

Input connector RJ-45

Output connector BNC

Link cable RG59/U or better

Ethernet speed 10/100 Mbps**

Standard IEEE802.3 10Base-T/100Base-T

Operating temperature -4°~158° F (-20°~70° C)

Dimensions 23/8"x11/8"x13/16" (60x29x20 mm)

(Excluding pigtail)



Parts List:

2x Passive Ethernet Extenders

1x Manual

Dimensions:

Note: Pigtail length is 5” (127mm)

Note: Both Ethernet extender units are the same size.

23/8” (60mm)

13/16” (20mm)

5/8” (16mm)

11/8” (29mm)

* Actual transmission range will vary depending on equipment used and cable grade.

** Use only with 10/100 Switches

ENFORCER Passive Ethernet Extender over Coax

SECO-LARM U.S.A., Inc. 3





Overview:

BNC Connector

RJ45

Installation:

1. Determine the location where the units will be placed as well as how much cable will be

required.

2. Connect one unit to an IP camera or other TCP/IP output device using Cat5e/6 cable of

not more than 6.5ft (2m).

3. Connect one unit to a DVR, PC or other TCP/IP receiving device using Cat5e/6 cable

Cat5e/6 cable of not more than 6.5ft (2m).

Connect via the Ethernet port found on the front of the Passive Ethernet Extender.

4. Run a coax cable between the two Passive Ethernet Extenders and connect both ends.

5. Switch on the IP source (i.e. CCTV camera) and verify that the system is functioning

properly.

Sample Application:

Passive Ethernet Extender1

NE-SE01-020Q

Coaxial cable

up to 650ft (200m)@10Mbps**

Cat5e/6 cable

(not more than 6.5ft)

IP Camera

NVR

Passive Ethernet Extender*

NE-SE01-020Q

*The passive Ethernet extender units are bidirectional transceivers. It can operate as a transmitter and receiver.

** Actual transmission range will vary depending on equipment used and cable grade.

Cat5e/6 cable

(not more than 6.5ft)

ENFORCER Passive Ethernet Extender over Coax 

4SECO-LARM U.S.A., Inc.



Troubleshooting:

IP Device does not function

correctly.

Make sure you are using the unit with 10/100 switches.

Make sure the Passive Ethernet Extender is connected

on both sides.

Make sure the IP source and DVR or PC are powered.

Test the coaxial cable between the units and make sure

it is functional.

Make sure that there are no problems with the IP

device, cables, or DVR by plugging the IP device

directly into the DVR or PC using the Cat5e/6 cables.

Make sure that the cables do not exceed the maximum

distance (see pages 2 and 3 for more details).

Also Available from SECO-LARM:

Passive VGA Balun

MVE-SV010Q

Passive 4-in-1 HD Video Baluns

EB-P101-01HQ

HDMI to VGA Converter

MVA-HV01Q

HDMI Extender over Coax

MVE-AA11-01NQ

CCTV Power Supplies

EVP-1SA4P9UL

Ethernet over Coax w/ PoE

NE-AE01-030TQ

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason,

SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible

for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners.

LIMITED WARRANTY: This SECO-LARM product is warranted against defects in material and

workmanship while used in normal service for one (1) year from the date of sale to the original customer.

SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned,

transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to acts o

God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal usage, or faulty

installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly

as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM and

the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s option.

In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal o

property damage of any kind to the purchaser or anyone else.

SECO-LARM®U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com PICFN1

Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected] MI_NE-SE01-020Q_171207.docx

Inhaltsverzeichnis

Andere ENFORCER Extender Handbücher

ENFORCER

ENFORCER MVE-AHMPM-01NQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH020Q Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH1E1-41NQ Bedienungsanleitung

ENFORCER

ENFORCER NE-AE01-030TQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH1H1-02ZQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH030AQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-WH010Q Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH1E1-01NQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AHMPM-01NQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH1T1-01YQ Bedienungsanleitung

ENFORCER

ENFORCER ENHANCED MVE-AH1H1-42YQ Bedienungsanleitung

ENFORCER

ENFORCER DE-S104Q Bedienungsanleitung

ENFORCER

ENFORCER SECO-LARM NR-P102E-TQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH030Q Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH1E1-01NQ Bedienungsanleitung

ENFORCER

ENFORCER NR-P101E-TQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH010Q Bedienungsanleitung

ENFORCER

ENFORCER Enforcer MVE-AT11-01NQ Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH010Q Bedienungsanleitung

ENFORCER

ENFORCER MVE-AH010Q Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Enable-IT

Enable-IT 824WP Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung

SECO-LARM

SECO-LARM ENFORCER EVT-PB1-V1TGQ Bedienungsanleitung