Page 3
INSTALLATION INSTRUCTIONSSTUDIO Freestanding Bath
INSTALLATION
ENGLEFIELD
1) Unpack the bath and check for any transit damage prior to installation.
2) Carefully place the bath upside down on a soft surface, ensuring no damage to the rim
or surfaces. Loosen off and screw the adjustable feet so that the bottom of each foot is
protruding approximately 25mm from the underside of the bath. Tighten the nuts with an
adjustable wrench or spanner. Next, overturn the bath and place a spirit level across the
rim. Adjust the feet until the bath is level with the floor.
3) Position the bath in the desired location in the bathroom. If the bath is to be placed
against a wall, orient it so that the long side with logo badge is adjacent to the wall.
4) Check that the plumbing can be connected to the bath when in the desired location and
that the positioning of the bath does not interfere with other bathroom fixtures.
5) Carefully place the installation template on the floor directly underneath the bath.
The bath feet should roughly align with the “located foot position” on the template. If the
bath is to be installed against a wall, position the template so that the edge with logo
and arrows is touching the wall.
25mm
Outer edge of bath (1500 & 1800) Outer edge of bath (1500 & 1800)
Studio 1800 bath
located foot position
Studio 1800 bath
located foot position
Studio 1800 bath
located foot position
Studio 1800 bath
located foot position
This side up
Studio 1500 bath
located foot position
Studio 1500 bath
located foot position
Studio 1500 bath
located foot position
Studio 1500 bath
located foot position
Engleeld Studio Freestanding Bath
1500 & 1800 Installation Template
PN 1249068-A April 2015
Engleeld Studio Freestanding Bath
1500: 2589A-0 1800: 2590A-0
Direction of push to lock
bath feet into brackets
Please ensure this template is printed at 100% size (i.e: no scaling).
For reference:
1500 feet centres: 590mm x 210mm
1800 feet centres: 700mm x 360mm
Bath outline
over template
