Enterasys 9C306 Bedienungsanleitung
9031994-01
SmartSwitch 9000-6 Slot
9C306 System Monitor
User’s Guide
i
Notice
Notice
Cabletron Systems reserves the right to make changes in speciÞcations and other information
contained in this document without prior notice. The reader should in all cases consult Cabletron
Systems to determine whether any such changes have been made.
The hardware, Þrmware, or software described in this manual is subject to change without notice.
IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT,
SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED
TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION
CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR
SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.
© January 1999 by:
Cabletron Systems, Inc.
35 Industrial Way
Rochester, NH 03867
All Rights Reserved
Printed in the United States of America
Order Number: 9031994-01
Cabletron Systems
and
LANVIEW
are registered trademarks, and
SmartSwitch
is a trademark of
Cabletron Systems, Inc.
i960 microprocessor
is a registered trademark of Intel Corp.
Ethernet
is a trademark of Xerox Corporation.
Notice
ii
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment uses, generates, and can radiate radio frequency energy and if not installed in
accordance with the operatorÕs manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause interference in which case the user
will be required to correct the interference at his own expense.
WARNING:
Changes or modiÞcations made to this device which are not expressly approved by the
party responsible for compliance could void the userÕs authority to operate the equipment.
VCCI Notice
This is a Class A product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this equipment is used in a domestic environment,
radio disturbance may arise. When such trouble occurs, the user may be required to take corrective
actions.
Industry Canada Notice
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Le prŽsent appareil numŽrique n'Žmet pas de bruits radioŽlectriques dŽpassant les limites applicables
aux appareils numŽriques de la class A prescrites dans le R•glement sur le brouillage radioŽlectrique
ŽdictŽ par le minist•re des Communications du Canada.
iii
Notice
Declaration of Conformity
Addendum
Application of Council Directive(s):
89/336/EEC
73/23/EEC
ManufacturerÕs Name:
Cabletron Systems, Inc.
ManufacturerÕs Address:
35 Industrial Way
PO Box 5005
Rochester, NH 03867
European Representative Name:
Mr. J. Solari
European Representative Address:
Cabletron Systems Limited
Nexus House, Newbury Business Park
London Road, Newbury
Berkshire RG13 2PZ, England
Conformance to Directive(s)/Product Standards:
EC Directive 89/336/EEC
EC Directive 73/23/EEC
EN 55022
EN 50082-1
EN 60950
Equipment Type/Environment:
Networking Equipment, for use in a
Commercial or Light
Industrial Environment.
We the undersigned, hereby declare, under our sole responsibility, that the equipment packaged with
this notice conforms to the above directives.
Mr. Ronald Fotino Mr. J. Solari
____________________________________________________ ______________________________________________________
Full Name Full Name
Principal Compliance Engineer Managing Director - E.M.E.A.
____________________________________________________ ______________________________________________________
Title Title
Rochester, NH, USA Newbury, Berkshire, England
____________________________________________________ ______________________________________________________
Location Location
Notice
iv
v
Contents
Chapter 1 Introduction
Features ................................................................................................................... 1-1
Related Manuals............................................................................................................ 1-3
Getting Help .................................................................................................................. 1-4
Chapter 2 Installing the 9C306 System Monitor
Chapter 3 9C306 System Monitor Operation
Monitoring Functions................................................................................................... 3-1
Fan Status................................................................................................................ 3-1
System Voltages...................................................................................................... 3-2
LANVIEW LED...................................................................................................... 3-2
Out-of-Band Management........................................................................................... 3-3
COM1 and COM2 Ports........................................................................................ 3-4
The Ethernet Port Interface Module (EPIM)...................................................... 3-4
Chapter 4 Specifications
Safety............................................................................................................................... 4-1
EMC ................................................................................................................................ 4-1
Service............................................................................................................................. 4-1
Physical........................................................................................................................... 4-2
Environmental ............................................................................................................... 4-2
Appendix A EPIM Specifications
Introduction .................................................................................................................. A-1
EPIM-T........................................................................................................................... A-1
EPIM-F2......................................................................................................................... A-2
EPIM-F3......................................................................................................................... A-4
EPIM-A and EPIM-X (AUI Port)................................................................................ A-6
Appendix B Uninterruptible Power Supply (UPS)
Introduction ...................................................................................................................B-1
Connecting a UPS to the System Monitor Module ..................................................B-1
ConÞguring COM Port for UPS..................................................................................B-2
Monitoring UPS.............................................................................................................B-3
Contents
vi
1-1
Chapter 1
Introduction
The 9C306 System Monitor, shown in Figure 1-1, provides out-of-band
management capabilities, and environmental/power monitoring for the
SmartSwitch 9000-6 Slot System. The System Monitor Module is inserted into a
SmartSwitch 9000-6 chassis in the slot marked SM in the right side of the module
card cage.
Features
Out-of-Band Management
Out-of-band management refers to managing the SmartSwitch 9000-6 Slot via a
Local Management (LM) connection or an SNMP-based management application
which does not use the same network connection to the chassis as Òuser data.Ó
Three out-of-band management interfaces are built into the 9C306 System
Monitor. Two interfaces are serial RS232 ports. These ports support local
management via a VT100 session, Serial Line Internet Protocol (SLIP), or Point-to-
Point (PPP), or monitor an American Power Conversion Uninterruptible Power
Supply (UPS).
The remaining out-of-band management interface supports any standard
Cabletron Systems Ethernet Port Interface Module (EPIM). This interface
provides a direct connection to the internal System Management Bus-10
(SMB-10).
Environmental/Power Monitoring
The 9C306 System Monitor monitors and reports chassis power parameters, as
well as the presence of the chassis cooling fan.
Flash EEPROM
The capability of downloading future Þrmware upgrades has been built into the
9C306 System Monitor.
Introduction
1-2
Figure 1-1. The 9C306 System Monitor
STATUS
C
O
M
1
C
O
M
2
EPIM
LNK
EPIM-T
SM
9C306
Inhaltsverzeichnis
