Enwork Proxi Programmable Remote Bedienungsanleitung
Proxi Remote Control
User Guide
HEIGHT-ADJUSTABLE TABLES
TI0041
Proxi Remote Control User Guide – Rev 08.29.22
2
4 – Programmable Remote Guide
1. Hold the “down” button until the base reaches its lowest
position.
2. Release the “down” button.
3. Hold the “down” button again until the display states
“RST”.
5. Hold the “down” button again until the base lowers slightly,
then raises back up.
6. Release the “down” button. The base is now ready to use.
1. Adjust the base to the desired height.
2. Press “M” followed by the desired preset number.
3. The preset is now set for that height.
1. Adjust the base to the desired maximum height.
2. Hold down the “M” button until the display states “S-”, then
release the “M” button.
3. Press the “up” button, then release. Hold the “M” button
until the display ashes “999” then
changes to display the height.
4. The maximum height is now set.
Resetting the base
Memory Control Instructions
Setting Upper Limit
3
4 – Programmable Remote Guide
1. Adjust the base to the desired minimum height.
2. Hold down the “M” button until the display states “S-”, then
release the “M” button.
3. Press the “down” button, then release. Hold the “M” button
until the display ashes “000” then
changes to display the height.
4. The minimum height is now set.
1. Hold down the “M” button until the display states “S-”, then
release the “M” button.
2. Within ve seconds, hold down the “M” button again for
two seconds.
3. The display will ash “555”, then change to display the
height.
3. The upper and lower limits are now removed.
1. Hold the “M” button until the display switches from “S-” to
“LOC”.
2. The control is now locked.
Setting Lower Limit
Removing the Upper and lower Limits
Locking the control
4
4 – Programmable Remote Guide
1. Hold the “M” button until the display switches from “LOC”
to the height display.
2. The control is now unlocked.
Unlocking the control
5 – Troubleshooting
Perform reset procedure if base is not functioning properly
or if legs are uneven.
If the display states “RST”, perform reset procedure.
If the display indicates an error message (“ER1” – “ER13”),
conrm all wired connections are secure (legs to cables,
cables to control box). Then perform reset procedure.
If the display states “HOT”, let base cool down for twenty
minutes before use.
Resetting the base will require lowering past any
set lower limit. Ensure there are no obstructions
underneath the base while resetting.
WARNING
1.800.815.7251
enwork.com
12900 Christopher Dr. Lowell, MI 49331
Specications subject to change without notice.
Rev 08.29.2022
Inhaltsverzeichnis
Andere Enwork Fernbedienung Handbücher
Beliebte Fernbedienung Handbücher anderer Marken
Panasonic
Panasonic EUR7622KB0 Bedienungsanleitung
Bang & Olufsen
Bang & Olufsen Beo4 Bedienungsanleitung
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Bedienungsanleitung
Multiplex
Multiplex PROFI TX 9 Bedienungsanleitung
One Remote
One Remote RMB4 Bedienungsanleitung
FUTABA
FUTABA 9ZAP - PART2 Bedienungsanleitung
