REMOTE METER DISPLAY:
REMOTE METER OPERATION INSTRUCTION:
the key(from left to right) is: K1-K4, or Next , Left , Right , Set .
The meter display as following order:
Solar panel, battery 1, battery 2, other data as four team data. Use K2 or K3 to check the
data between the teams. Symbol is the repeat between the team 1 and team 4. K1 is the key
for repeating the data. Data shows as picture 2.
Data setting instructions: press K4 for setting, K1 for next data and save it. K4 for next data, but
no save. K2 and K3 for modify the data, shows as picture 3.
Backlight instruction: press any key while its connected, the backlight will be on. And set the
backlight timer on setting mode. Backlight options:
OFF: backlight is off all the time On: backlight is on all the time in any case.
B: 30 backlight on for 30 seconds B: 20 backlight on for 20 seconds
B: 10 backlight on for 10 seconds B: 05 backlight on for 5 seconds
Note: backlight timer calculated as the last key press. And backlight has 2 class:
FULL: high bright
HALF: low bright
Data repeat: auto or manual, options as following:
Auto each team data will repeat every 3 seconds, K1 for next team. K2, K3 for data repeating
in the team.
OFF data will not repeat automatically, unless press K2 or K3, or K1 for the next team data.
System checking: at any time, press K3+K4, it will check and display the related data
automatically. Details as PICTURE 4. If there is NO, means there is no connection. If the
connections is correct, the related data will be displayed. If no remote temperature sensor
is connected, the meter will show thermometer and NO. if connection is correct, it will show
the data it detects. OPEn means no battery connection or over voltage, the data will be
displayed while the connection is right.
Data erase to 0: at any time, press K1+K2，the data will be erased to 0, such as max, min,
Ah. AH accumulate from 0.
