Epson TC-1428 Bedienungsanleitung

14" SVGA Color

Monitor

TC-1428

Customer’s Record

The serial number of this product appears on the back of the unit.

You should note this serial number in the space provided below and retain

this manual as a permanent record of your purchase to aid in identification

in the event of theft or loss.

Model number: TC-1428

Serial number:

WARNING: To reduce the risk of fire or electric shock, do not expose this

Computer Display to rain or moisture.

CAUTION

The power cord is intended to serve as the main disconnect device. Install

the socket-outlet near the equipment and in an easily accessible place.

For 120V operation, use only with power cord plug having a parallel blade,

grounding type plug, rated 125V 10A.

For 240V operation, use only with power cord plug having a tandem blade,

grounding type plug, rated 250V 5A.

VESA DPMS Compliance Product Information

NOTE: The TC-1428 has been tested and found to comply with the

requirement of VESA DPMS standard. The power management

features are as follows:

1. The monitor will enter into the power saving state with six seconds of

time delay, in the absence of any sync. signal from PC.

-1-

2. The monitor will be automatically recovered to the on state by receiving

normal sync. signals from PC.

3. The power management states are identified below:

Power Mgmt. States H-Sync. V-Sync.

LED Color

ON ON

Green

Stand-By OFF ON

Light Amber

Power ON

Suspend ON

OFF Light Amber

Off OFF OFF Dark Amber

Power OFF OFF OFF Off

Table of Contents

Introduction..

............................................................................................

Precautions

.............................................................................................

Features

..................................................................................................

4.Specifications...........................................................................................

5.Control

Locations

and

Adjustments

........................................................

6.Connections............................................................................................

7. Pin

Assignments..

...................................................................................

8.TimingCharts.........................................................................................

9.Troubleshooting.....................................................................................

.13

Note: PC and VGA are trademarks of International Business Machines

Corporation.

-2-

1. Introduction

Congratulations on your purchase of a NEW ULTRA VGA monitor. One of

the most versatile monitors available today, the TC-1428 automatically

adjusts its vertical and horizontal scanning frequencies to those of your

computer’s graphics adapter or video chip sets. The TC-1428 provides

crisp text and vivid color graphic displays when used with NEW ULTRA

VGA compatible graphics adapters (see specifications).

2. Precautions

1. To prevent electric shock, do not remove screws or cover.

There are no user-serviceable parts inside the monitor. Refer servicing

to qualified service personnel.

DO NOT REMOVE THE TILT/SWIVEL BASE!

2. The input power source:

The TC-1428 is designed to be suitable for low input voltage (100-

125V) and high input voltage (200-240V) areas.

3. The monitor is equipped with a three-pronged grounding plug which will

only fit a grounded power outlet.

This is a safety feature. If you are unable to insert the plug into the

outlet, contact an electrician.

Do not remove

-3-

Do not put the monitor or other heavy objects on the power supply cord.

A damaged power cord may cause fire or electric shock.

5. Do not insert sharp objects into the monitor. They may cause fire or

failure.

6. Do not allow liquids to spill into the cabinet.

7. To reduce eye fatigue, avoid using the display in direct sunlight or under

bright lighting.

8. Do not operate the monitor beyond the specified temperature and

humidity range (see specifications on page 5).

9. For proper operation, keep the monitor adequately ventilated.

10. Keep the monitor away from strong magnetic fields produced by

transformers, motors, fans, or other devices.

11. If the monitor does not operate properly, turn the power switch off and

then unplug the monitor.

12. When irregular AC Voltages is supplied, a protective circuit will turn off

the monitor (the power indicator will also be turned off). If this happens,

turn off the power switch, and wait at least 30 seconds before turning it

on again.

3. Features

1. The TC-1428 monitor automatically adapts to the vertical and horizontal

frequencies of VGA, SVGA, 8514/A, VESA VGA, UVGA, and other

compatible graphics adapters.

2. The monitor features maximum resolutions of 1024 pixels (horizontal)

and 768 lines (vertical) in non-interlaced or interlaced modes.

3. Universal 100~240 Vac full-range power supply.

4. Power management complies with VESA DPMS standard, operating

states distinguished by the triple color power indicator.

5. Full scan capability allows the use of entire screen as display area.

6. The monitor compatible with the VESA DDC (Data Display Channel)

standard with DDC1 and DDC2b functionality (optional).

7. This monitor can be equiped with a built-in amplifier and stereo speakers

for multimedia environment applications (optional).

-4-

4. Specifications

Power Source:

Power Consumption:

Power Management:

Picture Tube:

Resolutions

l Horizontal:

* Vertical:

Input Signals

* Video:

* Separate Sync:

Synchronization

* Horizontal:

* Vertical:

Display Colors

* ANALOG Input:

Active Display Area

* Horizontal:

* Vertical:

Dimension

* (W)x(H)x(D):

VESA DDC Standard:

(Optional)

Environmental Conditions

* Operating Temperature:

* Operating Humidity:

* Storage Temperature:

* Storage Humidity:

Interfaces (Optional)

* Audio Input:

* Audio Output:

AC 90~264V, 50/60Hz

75W Maximum

VESA DPMS (<5W)

14 inches, 90° deflection, 0.28mm dot pitch

Viewable size 13.1 inches.

1024 pixels (interlaced)

768 lines (interlaced)

Analog 0.7 Vp-p / 75 ohm Positive

TTL Level

Horizontal . . . . . . . . . . . Positive/Negative

Vertical

. . . . . . . . . . . . . . . Positive/Negative

31.5KHz/35KHz/38KHz

50Hz~100Hz continuous

Infinite colors (262, 144 color range)

250mm typical (varies by signal timing)

188mm typical (varies by signal timing)

370mm(14.6”)x355mm(14”)x394mm(15.5”)

DDC1, DDC2b

0°C~+35°C

10%-80% (non-condensing)

-40°C~+65°C

5%~95%

Audio input port

Headphone jack

-5-

Low Radiation:

* X-ray radiation: < 100n Gylh

* Magnetic field:

Band I (5KHz-2KHz): < 250nT.

Band II (2KHz-400KHz): < 25nT.

Tilt and Swivel Operation:

The swivel range is normally limited to a range of 45 degrees to the right or

left of the front position (marked by a small molded pip on the top front

bottom of the base).

The tilt range is normally limited at an angle of -5 degrees forwards and +

15 degrees backwards. This allows you to set the screen angle to the

viewing position most comfortable to you.

Note: *When this display is operated with the vertical frequency under

55Hz, the image on the screen may flicker.

-6-

5. Control Locations and Adjustments

Note: The numbers indicate the control item whose description is found on

the following page.

-7-

Adjustments

1. POWER Switch Push to turn the display on, and push again

to turn off.

The power indicator will light when the

display is on.

2. BRIGHTNESS Control Adjusts the display to the desired brightness

level. (factory preset at the center detent of

the control knob)

3. CONTRAST Control Adjusts the display to the desired contrast

level.

4. H. WIDTH Control Adjusts the display to the desired horizontal

width. (factory preset at the center detent of

the control knob)

5. H. POSITION Control Adjusts the display to the desired horizontal

position.

6. V. HEIGHT Control Adjusts the display to the desired vertical

height. (factory preset at the center detent of

the control knob)

7. V. POSITION Control Adjusts the display to the desired vertical

position.

-8-

6. Connections

Your monitor has two connecting cables: a Power Supply Cord, which

connects to a wall outlet, surge protector or other power source, and a

Signal Cable, which connects to the graphics adapter of your computer. To

insure safety and correct operation, always follow these four steps when

connecting the monitor:

1. Disconnect the power supply cords from your computer and monitor.

2. Connect the signal cable from the monitor to the graphics adapter of

your computer. The connector is shaped so that it will only fit when

properly aligned.

3. Secure the connection by tightening the two screws on the connector.

4. Plug the power supply cords of the computer and monitor into an AC

outlet.

Power Supply Cord

-9-

Signal Cable

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Epson Monitor Handbücher

Epson

Epson EMP MONITOR OPERATION V4.30 Bedienungsanleitung

Epson

Epson KB9000 Bedienungsanleitung

Epson

Epson DM-D210 Series Gebrauchs- und Pflegehandbuch

Epson

Epson DM-D70 Gebrauchs- und Pflegehandbuch

Epson

Epson DM-D500 Series Bedienungsanleitung

Epson

Epson Monitor-17" SVGA Color Monitor .26 dot pitch Bedienungsanleitung

Epson

Epson DM-D210 Series Bedienungsanleitung

Epson

Epson DM-D110 Series Bedienungsanleitung

Epson

Epson ProSense J-57 Bedienungsanleitung

Epson

Epson CD5220 Bedienungsanleitung

Epson

Epson DP-110 Bedienungsanleitung

Epson

Epson A881371 Bedienungsanleitung

Epson

Epson A881391 Bedienungsanleitung

Epson

Epson DM-D110 Series Bedienungsanleitung

Epson

Epson A882459 Bedienungsanleitung

Epson

Epson A882181 Bedienungsanleitung

Epson

Epson EB-1485Fi Bedienungsanleitung

Epson

Epson DM-D30 Gebrauchs- und Pflegehandbuch

Epson

Epson S1D10605 Series Bedienungsanleitung

Epson

Epson DM-D310F Bedienungsanleitung

Epson

Epson DM-D30 Gebrauchs- und Pflegehandbuch

Epson

Epson DM-D110 Series Bedienungsanleitung

Epson

Epson DM-D110 Series Bedienungsanleitung

Epson

Epson P07303 Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung