Epson Stylus Color C70 Bedienungsanleitung
INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70 1
Installation Manual on
Continuous ink supply system (CISS)
For printer EPSON C82/C80/C70
Thank you for using the “INKSYSTEM” Continuous ink supply system. It is the
best device for an inkjet printer, and it will definitely decrease your printing costs.
Before using this system, please read this manual carefully. The pictures in this manual
may be different with the real ones. It’s just for your reference.
Note: The pictures in this manual may be different with the real ones. Here just
for your reference.
I. Opening Guide
1. Accessories
1) Continuous ink supply system ……………………………………………1
2) Air Filter ………………………………………………………………….1
3) Sponge …………………………………………………………………….1
4) Injector …………………………………………………………………….1
5) Long needle …………………………………………………………….....1
6) Short needle …………………………………………………………….....1
7) Protection clamp …………………………………………………………..1
8) Installation Manual ………………………………………………………..1
9) Certificate on free installation………………………………………………1
Pic. 1-1 Pic. 1-2
2. Inspection before installation
A. Check whether all the accessories are present.
B. Check whether the system is retrieved normally or too much air is remained in
the connecting tubes (length over 20cm).
II. Printer test
2 INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70
1. Check printer status to see whether it is normal or not, and check its
mechanics for smooth and any damage.
2 Enter nozzle test option (2-1), print nozzle test sheet to see whether nozzle is
normal (2-2,2-3).
Pic. 2-1 Pic. 2-2, 2-3
3. If printer is alright, please print a picture to see the result.
Ill. Installation Procedures
1. Remove ink from the air balance tube
Place the system on the table, check if there is any ink in each of the air balance
tube. If yes, you need to remove the ink in the balance tubes by the following steps:
1) Pull out the sealed plug of the balance tube (3-1-1).
2) Use the injector to draw all ink out.
3) Put the sealed plug back.
4) Put the sealed plug back.
4) Pull refill plug out.
5) Inject ink to the ink tanks according to their color.
6) Put refill plug back.
7) Check all the plugs to make sure they are completely sealed.
Pic. 3-1-1 Pic.3-1-2
2. Replace the air balance plugs
INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70 3
Put this system on the right side of printer, tidy up ink flow tubes, pull out an air
balance plug and replace it with an air filter with the bigger side downwards.
3. Move out cartridge holder
Insert screwdriver like, screw screwdriver like until take cartridge cover off.
4. Install the system ink cartridges
Take cartridges out. Install CISS cartridges according to printer indication and
press cartridge down to the place.
5. Attach tubes
Tear sponge seal off. Tidy up ink tube. Stick rack onto the printer cover like.
Make sure that tube and rack will not fall off while printing. Do not twist ink tube.
6. Check wire length
Move cartridge holder to left side, then to right side, check if the tube is too long
or too short. Move cartridge holder to right side, check if ink tube will fall down during
movement, if fall down, then the holder will be blocked during printing. Generally,
before shipment, we have adjusted the tube to the right size, please double check before
printing.
7. Adjust wire length
If step 6 is ok, then there is no need to go through this step.
If the tube length is too short then lengthen it, if too long then shorten. If the tube falls
down, you need adjust the angle of sticker to prevent falling.
8. Take place meter off
Tidy up ink tube. Tear seal off, attach fixation like. Press ink tube while closing
printer cover to avoid deforming of ink tube.
9. Prepare for printing
Plug power wire on (3-9-1), turn printer on. Check whether printer and ink tube
can run normally. Close printer cover and check whether it is strange noise while
printing.
Pic. 3-9-1
10. Check printer nozzle
4 INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70
Enter printer nozzle inspection option (3-10-1), print nozzle test sheet. If it is ok
(3-10-2)), then can run printer. If line is missing (3-10-3), please clean the nozzle. If just
one color is missing (maybe there is air in nozzle). If it is still a little line missing after
several times cleaning, please turn printer off and let printer stay turned off for one hour
or more. Please contact local distributor if still have problem.
Pic.3-10-1 Pic. 3-10-2, 3-10-3
IV. Notice
It requires to change cartridges while printing (4-1-1) and ink light flash (4-1-2).
Press ink button to move out cartridge holder. Press chip reset button for 3 seconds (4-
1-3), repress ink button to move back cartridge holder, then ink amount shows 99%
again. Redo nozzle inspection and printer can run normally if it is alright. (Black and
other colors can be handled by the same method).
Note: Distinguish two kinds of chips (4-1-4). The manipulation is the same. The
difference is that the chips with transferred switch should be switched downwards (4-1-
5), otherwise, chips can not be recognized.
Pic. 4-1-1 Pic. 4-1-2 Pic. 4-1-3
Pic. 4-1-4 Pic. 4-1-5
INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70 5
V. Removing used continuous ink supply system
Replace air filters with air plugs (5-1-1).Move out cartridge holder and take the
rack off. Take the cartridges out (5-1-2) and place the cartridges on the tissue with the
ink flow nozzle downwards, and let the tissue at the same level with the system ink tank
(5-1-3).
Pic. 5-1-1 Pic. 5-1-2 Pic. 5-1-3
VI. Refill ink
During printing, if you found out that the ink level in the tank is below the red
line, please add ink according to the methods.
VII. Check air balance tube
During printing, if you find some abnormal cases, such as bad output, ink drip out
on paper, then you need to check the air balance tube to see if exist ink. If yes, please do
according to the manual of "ink pump out from balance tube”.
VIII. Warnings
1. During printing, please do not take cartridges over than the printer. Please keep
ink tank and printer in the same level.
2. During printing, do not inverse, lift up or lower ink tanks.
3. Please do not block up ink tanks for curiosity or for fear of less ink
4. Use CISS at clean environment and within the temperature range 15-35
degrees.
IX. Product Warranty
INKSYSTEM warrants its products to be free from defects in material or
workmanship. Rarely the equipment partly or completely fails within the warranty
period. In these cases we do everything possible to ensure that our customers are
satisfied with the purchase.
The INKSYSTEM CISS installation is free in any of the representative offices.
Please adhere to the following points to receive a warranty service as soon as
possible:
When accepting the product check if the warranty certificate is filled in
correctly.
6 INSTALLATION MANUAL ON CISS FOR PRINTER EPSON C82/C80/C70
Try to avoid mechanical damages when operating the product: chippings, dents,
fractures, scratches, etc.
Demonstrate the failed device to the service center managers (the warranty repair
or replacement can be provided only upon the failed product availability).
We cannot provide a warranty repair under several conditions:
If the warranty certificate is wrongly filled in.
If the device has mechanical damages: chippings, dents, fractures, scratches, etc.
If the identification information was removed or the information identification
has been complicated in any possible way: additional notes, stickers, etc.
If the user has previously performed a repair or change in the internal parts of the
device.
If the equipment has previously been repaired in a service center that is not an
«INKSYSTEM» representative center.
If the device was installed by the user.
If the defect appeared under the circumstances of insuperable forces, accidents,
intended or careless actions of the user or a third party.
If the ink used was not manufactured by “INKSYSTEM” (South Korea)
If the printing limit was exceeded –more than 100 000 prints.
The “INKSYSTEM” Company excludes for itself any liability for incidental,
consequential, indirect, special, or punitive damages of any kind to people, pets or
property if the stated damages have been affected because of rules and operational
conditions / product installation disregard. The Company also excludes any liability for
intentional or careless actions of the user or third parties, for loss of revenue or profits,
loss of business, loss of information or date, or other financial loss arising out of or in
connection with the sale, installation, maintenance, use, performance, failure, or
interruption of the possibility of such damages.
Warranty certificate
(Product)
Continuous ink supply system
(Model Name)
_____________________________________
(Serial №)
_____________________________________
(Date of Purchase)
_____________________________________
(Warranty Period)
1 year from the date of retail purchase
Seller company
SEAL
The warranty conditions are agreed and accepted. No claims against the product appearance
and the list of equipment.
Customer’s signature
Andere Handbücher für Stylus Color C70
3
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Epson Druckerzubehör Handbücher
Epson
Epson Printer Accessories Bedienungsanleitung
Epson
Epson Spectroproofer Bedienungsanleitung
Epson
Epson T079320 Betriebsanleitung
Epson
Epson 802.11g Bedienungsanleitung
Epson
Epson T059320 Bedienungs- und Wartungsanleitung
Epson
Epson T602500 Bedienungs- und Wartungsanleitung
Epson
Epson T079220 Betriebsanleitung
Epson
Epson T033220 Betriebsanleitung
Epson
Epson T088120 Betriebsanleitung
Epson
Epson T606600 Bedienungs- und Wartungsanleitung
Epson
Epson T078320 Betriebsanleitung
Epson
Epson T059820 Bedienungs- und Wartungsanleitung
Epson
Epson Stylus Color C60 Bedienungsanleitung
Epson
Epson T034720 Bedienungs- und Wartungsanleitung
Epson
Epson T464011 Bedienungs- und Wartungsanleitung
Epson
Epson C83202 Bedienungsanleitung
Epson
Epson T034220 Bedienungs- und Wartungsanleitung
Epson
Epson T077120 Betriebsanleitung
Epson
Epson Stylus Color C80 Bedienungsanleitung
Epson
Epson T036120 Betriebsanleitung
