Epson EB-L30002U Systemhandbuch

Transport and Installation Handbook

Introduction

About the Manuals for this Projector

The following manualsare supplied with the projector.Make sure you read the manuals thoroughly to operate

the projector correctly and safely.

Booklet (Paper) Manual

•Transport and Installation Handbook (this handbook)

Provides instructions on carrying and installing this projector safely.

Check this handbook before carrying and installing.

Contact your local dealer or the nearest address provided in the Safety Instructions.

PDF Manuals

•Safety Instructions

Provides cautionary notes on using this projector safely and information on support and service.

Make sure you check these manuals before use.

•User's Guide

Provides information on using this projector, using the Configuration menu, troubleshooting, and maintenance.

•Specifications

Provides information on the projector specifications, external dimensions, supported lenses, and so on.

For More Information

http://epson.sn

Introduction

Notations Used in This Guide

The documentation and the projector use graphical symbols to show how to use it correctly and safely to

avoid personal injury, injury to others, and damage to property.

The indications and their meaning are as follows. Make sure you understand them properly before reading

the guide.

Symbol Meaning

Warning This symbol indicates information that, if ignored, could possibly result in serious personal

injury or even death due to incorrect handling.

Caution This symbol indicates information that, if ignored, could possibly result in personal injury or

physical damage due to incorrect handling.

Indicates Prohibited Actions Indicates Instructions that Must be Followed

Prohibited Contact pro-

hibition

Usage near

water pro-

hibited

Instructions Instructions

that must be

followed

Disconnect

plug from

electrical out-

let

Contact a

qualified

technician

Contents

Introduction

About the Manuals for this Projector . . . 1

Booklet(Paper)Manual ...................1

PDFManuals ........................... 1

ForMoreInformation ..................... 1

NotationsUsedinThisGuide ........... 2

Transport and Installation

Handbook

Notes on Carrying and Transporting

....................................... 4

WhenCarryingWithoutPacking ............. 4

WhenPackingandTransporting ............. 5

Notes on Installation .................. 6

NotesontheInstallationEnvironment ......... 6

NotesonInstalling ....................... 7

CautionsonLifting ...................... 10

NotesonConnections...................12

AttachingtheLensUnit .................. 13

Transport and Installation Handbook

Notes on Carrying and Transporting

Caution

Before carrying this projector, make sure you turn it off and disconnect all

cables.

When Carrying Without Packing

Note the following points when moving the projector by hand or by using a forklift to a close location without

packing it up.

Caution

This projector is heavy and should be carried by at least four people.

When an optional lens is attached, attach the lens cap for the lens unit being

used.

When lifting this projector with a forklift, do not insert the fork from the

front of the projector (the lens side). Otherwise, the lens unit or the projector

could be damaged.

Insert the fork from the rear or the side.

Transport and Installation Handbook

When Packing and Transporting

Note the following points when packing up this projector and transporting it on a track and so on.

Caution

Before packing, remove the lens unit from the projector, and attach the

protective cap. If you have used lens shift to move the lens position, move

the lens to the home position and then remove the lens unit.

Enclose the projector securely in packaging material to protect it from

shock, and place it into a strong container.

This projector is precision equipment. A qualified technician such as the

carrier company must transport the projector with caution.

Transport and Installation Handbook

Notes on Installation

Notes on the Installation Environment

Warning

Do not use or install the projector where it may be subject to water or rain,

or high humidity, such as outdoors, in a bathroom, or shower room, and so

on.

Otherwise, it could cause a fire or electric shock.

Do not place flammable objects in front of the lens.

If you set the schedule to turn on the projector automatically, any flammable objects placed

in front of the lens could cause a fire.

Caution

Check the following points before installing.

•

Make sure the location is not subject to vibrations or shocks.

•

Make sure the location does not shake and is not tilted at an angle.

•

Makes sure there are no high-voltage lines or magnetic devices in the surrounding environ-

ment.

Do not use or store the projector in a location that is subject to extreme

temperatures.

Also, avoid sudden temperature changes.

Make sure you use or store the projector in a place that is within the following operating or

storage temperature ranges.

•

Operating Temperature

0 to +50°C (Altitude of 0 to 2,286 m, no condensation)

0 to +45°C (Altitude of 2,287 to 3,048 m, humidity of 20% to 80%, and no condensation)

•

Storage temperature

-10 to +60°C (No condensation)

Do not install the projector in direct sunlight.

If the projector is in direct sunlight, the internal temperature increases, which could cause

parts such as the surface of the projection lens or the built-in camera to deteriorate.

Transport and Installation Handbook

Caution

When installing the projector in an environment in which a high-powered

laser beam is being used, make sure it is installed so that the laser beam

does not hit the surface of the projector's projection lens or the built-in

camera.

If the laser beams through the surface of the projection lens or the built-in camera, block the

laser beam with non-permeable or incombustible aluminum foil or metal plates such as iron

to protect the projection lens and the built-in camera. You canalso use the projector's Shutter

function to prevent the LCD panel from being damaged by laser light.

When using the projector in smoky environments such as at events and so

on, make sure you replace the air filter after approximately 240 hours of

use. (This is a guideline when using the projector in an environment with

an atmospheric concentration of ondina oil of approximately

0.000000013%. The air filter replacement time may be shorter depending

on the operating environment.)

Using the projector in a smoky environment may cause the filter's dust collection function

to decline and dust may adhere to the inside of the projector or the power supply; this may

cause a malfunction to occur.

Do not install the projector in an airtight location.

Heat exhausted from the projector will become trapped in the location which could cause

the projector to malfunction. When the projector is installed in an enclosed location so that

it cannot be seen, make sure the location is not airtight and that it can be ventilated and the

temperature can be controlled.

Notes on Installing

The projector can be installed at any angle. There is no vertical or horizontal limit to how the projector can

be installed.

You can install the projector in a portrait orientation by attaching the carrying handles to the top and bottom

of the projector. You can remove the feet from the projector and attach them to the carrying handle.

Transport and Installation Handbook

Warning

You may need dedicated installation mounts to tilt and install the projector.

Contact a specialist and prepare the mount.

•

Plan so that the mount does not fall.

•

Make sure the mount is strong enough to support the projector.

•

When attaching a mount to the projector, secure the mount with bolts using the handle

securing section (6 points) on the top or base of the projector.

Since special techniques are required to install the projector on a ceiling

(ceiling mount) or in a high location, make sure you contact a professional.

If installation work is not carried out correctly, the projector could fall down. This may result

in injury or accidents.

Note the following points when installing so that the projector's air intake

vent or air exhaust vent are not covered.

If either of the vents is covered, the internal temperature could rise and cause a fire.

•

Make sure you secure the following space around the projector.

500mm

•

When setting up multiple projectors, make sure there is a gap of at least 200 mm between the

projectors.

200mm

•

Make sure you secure the following space when installing with the air intake vent underneath.

•

A gap of at least 100 mm between the installation surface and the air intake vent.

•

A space of 800 x 350 mm around the entrance of the air intake vent.

100mm

800mm

350mm

Transport and Installation Handbook

Caution

Note the following points when installing a projector directly on top of

another. This projector can be installed on top of another projector that has

the carrying handles attached to the top.

•

Do not stack three or more projectors (you can stack up to two projectors).

•

Install the feet in the indentations on the top at the four corners.

•

Do not remove the feet on the bottom of the projector.

Except for the projector's parts, do not place anything on the projector.

Andere Handbücher für EB-L30002U

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Epson Projektor Handbücher

Epson

Epson BrightLink 425Wi Bedienungsanleitung

Epson

Epson EMP 600 - SVGA LCD Projector Bedienungsanleitung

Epson

Epson BrightLink 475Wi Bedienungsanleitung

Epson

Epson Home Cinema 880 Bedienungsanleitung

Epson

Epson EX3212 Bedienungsanleitung

Epson

Epson V11H177020 - Powerlite 76C LCD Projector Referenzhandbuch

Epson

Epson EB-G6550WUNL Bedienungsanleitung

Epson

Epson PowerLite 8150i Bedienungsanleitung

Epson

Epson EH-LS12000B Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Epson

Epson Home Cinema 2350 Bedienungsanleitung

Epson

Epson EB-L1505U Bedienungsanleitung

Epson

Epson PowerLite Pro Z8000WU Allgemeine Anweisungen

Epson

Epson EMP-S4 Bedienungsanleitung

Epson

Epson EX70 Bedienungsanleitung

Epson

Epson EMP 7600 Bedienungsanleitung

Epson

Epson 826W - PowerLite WXGA LCD Projector Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 1080 Montageanleitung

Epson

Epson EB-915W Bedienungsanleitung

Epson

Epson EB-U42 Bedienungsanleitung

Epson

Epson 1700C - PowerLite XGA LCD Projector Technisches Datenblatt

Epson

Epson PowerLite 8300i withEasyMP.net module Technisches Datenblatt

Epson

Epson EB-1720 Bedienungsanleitung

Epson

Epson PowerLite 5000 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung

BOXLIGHT

BOXLIGHT CP-322i/CP-634i Bedienungsanleitung

JVC

JVC 1108TTH-AO-AO Bedienungsanleitung