3-wire Install Using the HR003101A Loom
The following diagram shows a basic connection for the Clarity
Connected and Clarity Solo dashcams using the HR003101A 3-
wire loom along with a basic Ehubo wiring diagram. If you are
installing a Clarity Connected camera, your Ehubo is likely to
be fused and connected already.
▪RED wire fused to vehicle DC power.
▪YELLOW/RED wire fused to Ignition.
▪BLACK wire to Ground.
Note 1 Always seal wiring connections with heat shrink
and/or electrician's tape.
Do not cut cables - Coil and tie them out of the
way.
1Connect the 12-way connector from the Dashcam to the
12-way connector on the 12-way wiring loom. Secure with
electrical tape.
2Connect the BLACK wire on the 12-way wiring loom to an
appropriate grounding location.
3Connect the RED wire on the 12-way wiring loom to a
permanent power source.
Note 2 Ensure there is a constant 12‑24 V when the
key is inserted, with the engine running, and also
when the key is not inserted and the engine is off.
4Connect the RED/YELLOW-striped wire on the 12-way
wiring loom to an ignition/switched power source.
Note 3 Ensure the ignition/switched power source
supplies 12‑24 V when the key is in the ON position
and zero volts when the key is in the accessory
(ACC) and OFF positions.
