5 of 16
V1.0
Heated or Cooled air is
distributed evenly
How it works
The Thermovec is supplied by hot or cold water from your ASHP. It draws air in from the room in
which it is installed, blows that air over a heat exchanger and exhausts the air into that room. The
temperature of the room is controlled by the Thermovec and the water flow is controlled by a
three-way valve. The air is distributed across the room in a much more efficient manner than a
traditional radiator.
Note: if the Thermovec is used for cooling, the condensate drain must be connected.
Unit characteristics:
Whisper Technology
The use of a cross-flow fan combined with wind-guiding technology make the
Thermovec quiet as a whisper.
Slimline
The Thermovec is only 130mm thick –thinner than traditional radiators of similar
output saving space.
Elegant Design
The rounded and clean outline ensures that the Thermovec will blend into any room.
Easy to use
With a simplified control menu, the Thermovec can be controlled via the touch-
screen panel or the remote control. Note: if you are using a high-temperature
source, the Thermovec should be controlled with the remote control because the
glass whole unit can achieve a temperature of up to 70°C to the touch.
Installation
Installation precautions
To ensures that the installation is performed correctly and safely and to conform to the warranty
conditions the Thermovec must be installed by a suitably qualified technician and in accordance
with this manual.
The electrical aspects of the installation must be carried out in accordance with current regulations.
The Thermovec must be correctly earthed.
The unit must be installed in a position that allows routine maintenance such as cleaning the filter.
