Esse-ti GSM200 C Bedienungsanleitung

7IS-80146

Installation and User’s manual

Thank you for choosing

an Esse-ti product

This product has been especially designed for easy

operation. It has been manufactured with perfect

workmanship using suitable materials for long-lasting

performance.

All Esse-ti products are subjected to extensive reliability

and operational testing in our laboratories in order to

provide total guarantee for the user.

The User shall be responsible for defects arising from the use of the product. Esse-ti shall only be

responsible for defects according to and within the limitations set by the Presidential Decree dated

24/05/1988 no. 224 (fulfilling the EEC directive no. 85/374 on the harmonisation of statutory and

administrative regulations of the Member States on the liability for damages arising from defective

products under art. 15 of Law no. 183 of 16 April 1987).

Esse-ti reserves the right to modify the characteristics of the products at any time without prior

notice.

TABLE OF CONTENTS

GENERAL INSTRUCTIONS FOR THE INSTALLER .................... 4

General Notes ................................................................................. 4

Making the Installation .................................................................. 4

DESCRIPTION .................................................................................. 5

INSTALLATION ............................................................................... 6

Inserting the SIM card ............................................................................. 7

Inserting the antenna ................................................................................ 8

PROGRAMMING.............................................................................. 9

CONNECTIONS .............................................................................. 10

Helpy 2W-TL / Helpy 2W-LCP ............................................................ 10

Helpy L300 / Helpy L300 TL ................................................................ 10

Helpy L200 / Helpy L200 TL ................................................................ 10

ST60 / ST61 / Helpy Quick / Helpy Quick-TL / Helpy Vox ................ 11

ST56 / Helpy Star ................................................................................... 11

STARTING ...................................................................................... 12

Test call .................................................................................................. 13

Module mounting operations ................................................................. 13

GSM200 C installation recommendations ............................................. 14

EU Declaration of Conformity .............................................................. 14

SIGNALLING .................................................................................. 15

LED indicating device operation status (RED) ..................................... 15

LED indicating GSM signal strength (GREEN) ................................... 15

Page 4

GENERAL INSTRUCTIONS FOR

THE INSTALLER

GENERAL NOTES

Carefully read the notes contained in this section as they provide important

information on the correct safe installation, use and maintenance of the product.

 The product must be EXCLUSIVELY used for the purpose it was designed for.

Esse-ti shall not be responsible for damages arising from improper use.

 The product has been designed in compliance with the regulations in force and

must be installed in systems that comply with the provisions of law.

 Always disconnect the product from the power supply mains before carrying out

any operation either inside or outside the product (cleaning, maintenance, etc.).

 Always refer to an authorised assistance centre for repair.

 Install the product in a well-ventilated place, making sure not to obstruct the

ventilation slots.

 Do not use the product in association with other electric or electronic devices that

were not especially designed to be used with it.

 Do not install the product in potentially explosive environments.

 Make sure that the product has been installed as required.

 Do not introduce objects, liquids or powders inside the product. Do not use sprays

inside the product.

 Packing components (such as plastic bags, foam polystyrene, etc.) must be kept out

of the reach of children because potentially dangerous.

MAKING THE INSTALLATION

Internal telephone installations must be carried out by specialised personnel.

The installation and connection of telephone terminals to the telecommunications

network that do not comply with the regulations in force is not permitted.

Page 5

DESCRIPTION

The GSM200 C module can be used in conjunction with the following

Esse-ti elevator alarm systems:

- Helpy 2W-TL

- Helpy 2W-LCP

- Helpy L300

- Helpy L300 TL

- Helpy L200

- Helpy L200 TL

- ST60

- ST61

- Helpy Quick

- Helpy Quick-TL

- Helpy Vox

- ST56

- Helpy Star.

For the correct operation of the module a GSM SIM card is required.

This manual describes the GSM200 C installation procedure. For other

instructions, please refer to the elevator alarm system user manual.

Page 6

INSTALLATION

 Remove the cover.

A ANTENNA connector

B SIM CARD housing

C LED indicating signal strength (green)

LED indicating device operation status (red)

D RJ45 for module connection to Esse-ti

elevator alarm systems

Page 7

Inserting the SIM card

Before inserting or replacing the SIM card, always make sure that the

module has been disconnected from the mains and take all necessary

measures to avoid electrostatic discharge.

 Shift the SIM card housing cover downward and lift it.

 Carefully slide the SIM card in its housing cover.

 Lower the SIM card housing cover and shift it upward until it

blocks.

WARNING

The SIM card must have the PIN code

DISABLED. If the Sim card has the PIN

code enabled it is necessary to disable it

by means of a normal mobile phone.

 Close the module cover.

Page 8

Inserting the antenna

 Screw the antenna cable in to the connector on the top of the

module.

WARNING

NEVER connect GSM200 C module

without having installed the antenna.

The module may damage.

WARNING

Do not install the product near other electric or

electronic devices that were not especially designed to

be used with it. They could be subjected to RF

interference from the module.

 Position the antenna with magnetic base so that any metal

surfaces do not block the signal.

Page 9

PROGRAMMING

When using the GSM200 C module for connection with any Esse-ti alarm

system, please make sure the parameter “Programming the type of

telephone line” has been adequately set in the specific alarm system.

 Lift the local telephone handset of the elevator alarm system.

 Dial:

< Installer password >

(by default: ).

 Set the type of GSM200 line:

 Exit programming:

< Installer password>

(by default: ).

Page 10

CONNECTIONS

Helpy 2W-TL / Helpy 2W-LCP

 Insert the provided cable (pin-to-pin cable) in to the two RJ45

connectors located on the Helpy 2W-TL / Helpy 2W-LCP and

GSM200 C module.

In order to reach longer distances (up to 100 m), please use a cat.5 or

higher cable.

Helpy L300 / Helpy L300 TL

 Make sure that the jumpers JP11 and JP12 located on the Helpy

L300 / Helpy L300 TL are in position 2-3 (towards the RJ45

connector).

 Insert the provided cable (pin-to-pin cable) in to the two RJ45

connectors located on the Helpy L300 / Helpy L300 TL and

GSM200 C module.

In order to reach longer distances (up to 100 m), please use a cat.5 or

higher cable.

Helpy L200 / Helpy L200 TL

 Make sure that the jumper JP5 located on the Helpy L200 / Helpy

L200 TL is in position 2-3 (towards the RJ45 connector).

 Insert the provided cable (pin-to-pin cable) in to the two RJ45

connectors located on the Helpy L200 / Helpy L200 TL and

GSM200 C module.

In order to reach longer distances (up to 100 m), please use a cat.5 or

higher cable.

Inhaltsverzeichnis

Andere Esse-ti Steuereinheit Handbücher

Esse-ti

Esse-ti GSM300FXS Bedienungsanleitung

Esse-ti

Esse-ti GSM100 Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung