Esse-ti GSM500 Bedienungsanleitung

7IS-80395 06/03/2020

User’s manual

TABLE OF CONTENTS

GENERAL INSTALLATION INSTRUCTIONS .............................. 4

General Notes ................................................................................. 4

Making the installation ................................................................... 4

DESCRIPTION .................................................................................. 5

Features .................................................................................................... 6

LED .......................................................................................................... 7

GSM500 hardware description ................................................................ 8

3G hardware description .......................................................................... 9

INSTALLATION ............................................................................. 10

Installation recommendations ................................................................ 10

EU declaration of conformity ................................................................ 10

Inserting the SIM card ........................................................................... 11

Inserting the antenna .............................................................................. 11

Connection to the telephone line ........................................................... 12

Connection to the power supply ............................................................ 12

Turning the gateway on ......................................................................... 13

Gateway mounting operations ............................................................... 14

GSM500 absorption chart ...................................................................... 15

3G absorption chart ................................................................................ 15

PROGRAMMING............................................................................ 16

Programming by telephone .......................................................... 16

(1) SIM card expiration check ................................................................. 21

(2) Battery check ...................................................................................... 22

(3) External power failure control............................................................ 22

(4) Relay-based notification of external power failure and/or mobile

network loss ........................................................................................... 23

(5) Automatic converter of selected telephone number........................... 23

Programming via SMS ................................................................. 26

Message format ...................................................................................... 26

Notification message format .................................................................. 28

SERVICES ....................................................................................... 30

Incoming calls .............................................................................. 30

Outgoing calls .............................................................................. 30

Measuring the signal level ........................................................... 31

Reading SIM card expiration ....................................................... 32

Reading the battery status ............................................................ 32

Activation relay ............................................................................ 33

SENDING SMS THROUGH DB-9 ................................................. 34

Sending received SMS text messages.................................................... 35

Sending SMS from device wired in the DB-9 connector ...................... 36

DATA TRANSMISSION ................................................................ 37

FEMALE DB-9 CONNECTOR ....................................................... 40

SIGNALS ......................................................................................... 41

Tones ............................................................................................ 41

Call signals ................................................................................... 42

LED .............................................................................................. 42

GSM/UMTS signal indicator LED (GREEN) ....................................... 42

Status indicator LED (RED) .................................................................. 43

Line status indicator LED / Data transmission indicator LED (WHITE)

................................................................................................................ 43

Power supply status indicator LED (BLUE) ......................................... 44

PROBLEM-DETECTION GUIDE .................................................. 45

Page 4

GENERAL INSTALLATION

INSTRUCTIONS

GENERAL NOTES

Carefully read the notes contained in this section as they provide important

information on safe correct installation, use and maintenance of the product.

 The product must be EXCLUSIVELY used for the purpose it was designed for.

Esse-ti shall not be responsible for damages arising from improper use.

 The product has been designed in compliance with the regulations in force and

must be installed in systems that comply with the provisions of law.

 Always disconnect power supply before performing internal or external operations

on the product (cleaning, maintenance, etc.).

 Always refer to an authorized service centre for repair.

 The device must be installed in a ventilated place, making sure that the ventilation

slots are never obstructed.

 Do not install the product in environments with risk of explosion.

 Make sure that the product has been installed as required.

 Do not introduce objects, liquids or powders inside the product. Do not use sprays

inside the product.

 Packing components (such as plastic bags, foam polystyrene, etc.) must be kept out

of the reach of children because potentially dangerous.

MAKING THE INSTALLATION

Internal telephone installations must be carried out by specialised personnel.

The installation and connection of telephone terminals to the telecommunications

network that do not comply with the regulations in force is not permitted.

Page 5

DESCRIPTION

GSM500

GSM500 is a gateway that, connected to a fixed telephone or to the PSTN

input terminals of a PABX or autodialer, allows you to make and receive

calls over the GSM network. For correct operation, a GSM SIM card is

required.

GSM500 GC

The GSM500 GC gateway comes with built-in backup batteries.

GSM500 R2R

The GSM500 R2R gateway comes with built-in backup batteries and a

relay output which can be activated either locally or remotely via SMS.

GSM500.net

The GSM500.net gateway comes with built-in backup batteries and

female DB-9 connector for data transmission (through standard RS-

232/RS-485/CAN-bus) and SMS forwarding (through standard RS-

232/CAN-bus). For correct operation, a GSM (voice + data) SIM card is

required (GPRS data connection).

3G.next Voice

3G.next Voice is a gateway that, connected to a fixed telephone or to the

PSTN input terminals of a PABX or autodialer, allows you to make and

receive calls over the UMTS/GSM network. The 3G.next Voice gateway

comes with built-in backup batteries and a relay output which can be

activated either locally or remotely via SMS.

3G.next

The 3G.next gateway comes with a female DB-9 connector for data

transmission and SMS forwarding and a micro USB A/B port for direct

connection to the UMTS/GSM module (optional). For correct operation

the SIM card must be enabled for voice and data traffic.

Page 6

Features

 Local programming via DTMF tones

 Remote programming via SMS

 Display of caller identification

 Automatic country setting

 CLIP / CLIR

 Roaming setting

 SIM card expiration check

 Battery check (only available on models: GC, R2R, .net and 3G)

 External power failure control (only available on models: GC, R2R,

.net and 3G)

 Relay-based notification of external power failure (only available on

models: R2R and 3G)

 Relay-based notification of GSM network loss (only available on

GSM500 R2R)

 Relay-based notification of UMTS/GSM network loss (only

available on models: 3G)

 SMS notifications (SIM card expiration, low-battery, dead battery,

replaced battery, external power failure/restore, GSM/UMTS

network restore)

 Measurement of GSM/UMTS signal level

 Automatic converter of selected telephone number

 Receiver and transmitter gain adjustment

 Remote reboot function

 Data transmission through standard RS-232, RS-485 and CAN-bus

(only available on GSM500.net)

 Data transmission through standard RS-232 and CAN-bus (optional

RS-485; only available on 3G.next)

 Incoming text messages transmission towards devices wired in the

DB-9 connector under RS-232 standard (only available on

GSM500.net and 3G.next)

Page 7

 Text messages transmission by devices wired into the DB-9

connector under RS-232 or CAN-bus standard (only available on

GSM500.net and 3G.next)

 Remote firmware update

 GSM/UMTS signal indicator LED

 Status indicator LED

 Line status indicator LED / Data transmission indicator LED (only

available on GSM500.net and 3G.next)

 Power supply status indicator LED

 Quad Band GSM module (GSM500 all versions)

 Dual Band UMTS/GSM module (3G all versions)

 2 W transmission power

 12 Vdc power supply input

 230 Vac external adapter input

 Female DB-9 connector (only available on GSM500.net and 3G.next)

 Micro USB A/B port (optional, only available on 3G.next)

 Relay output (1 A, 24 V; only available on models: R2R and 3G)

 External antenna (cable length = 2 m)

 External adapter (230 Vac 50 Hz input; 12 Vdc 500 mA output; CE

mark; only available on models: GC, R2R, .net and 3G)

LED

The gateway is equipped with 4 outer LEDs.

LEDs flashing is described at chapter “SIGNALS” (see page 42).

Green LED: GSM/UMTS signal indicator LED

Red LED: Status indicator LED

/ White LED: Line status indicator LED / Data transmission

indicator LED (only available on GSM500.net and 3G.next)

Blue LED: Power supply status indicator LED

Page 8

GSM500 hardware description

 Remove the cover by pressing the upper side.

A ANTENNA cable connector

B SIM CARD housing with front panel

C LED indicating signal strength (green), LED indicating device operation status

(red), LED indicating line status / data transmission (white) and LED indicating

power supply status (blue)

D Female DB-9 connector (.net models only)

E Jumper (.net model only)

F Telephone line output (RJ11 connector) for telephone set connection or PABX

analogue line connection

G 230Vac external adapter input

H Telephone line output (terminal block) for connection of autodialer/PABX

analogue line

I 12Vdc power supply terminal block

L Relay terminal block (R2R model only)

M Backup battery connector (GC, R2R and .net models only)

Page 9

3G hardware description

 Remove the cover by pressing the upper side.

A Micro USB A/B port (optional, 3G.next)

B ANTENNA cable connector

C SIM CARD housing with front panel

D LED indicating signal strength (green), LED indicating device operation status

(red), LED indicating line status / data transmission (white) and LED indicating

power supply status (blue)

E Female DB-9 connector (3G.next)

F RS-485 termination jumper (3G.next)

G CAN-bus termination jumper (3G.next)

H Telephone line output (RJ11 connector) for telephone set connection or

autodialer/PABX analogue line connection

I 230 Vac external adapter input

L Telephone line output (terminal block) for telephone set connection or

autodialer/PABX analogue line connection

M 12 Vdc power supply terminal block

N Relay terminal block

O Backup battery connector

Page 10

INSTALLATION

Installation recommendations

 The gateway must be installed in a location where the radio signal

allows for using the GSM/UMTS system.

 It is advisable to leave plenty of space around the gateway for

maintenance operations.

 Do not install the gateway outdoors, since it lacks protection devices

against weather conditions that can damage the gateway (water,

humidity, etc.).

 Do not install the gateway near electronic (radio or TV sets, Personal

Computers, wired radio systems, etc.) or magnetic (credit cards, floppy

disks, etc.) devices that could be subjected to RF interference from the

module: recommended distance from the antenna is min. 2,5 m.

 Do not install the gateway near medical devices. Its operation may cause

damage to hearing aids or pacemakers.

 Always make sure that the device operation is permitted in the place of

installation (e.g. installation is not allowed in hospitals, airplanes, etc.).

EU declaration of conformity

Hereby, Esse-ti S.r.l. declares that the equipment type GSM500/3G.next

is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available from the

following Internet address:

https://www.esse-ti.it/en/dichiarazioni-di-conformita

Andere Handbücher für GSM500

Inhaltsverzeichnis

Andere Esse-ti Tor Handbücher

Esse-ti

Esse-ti GSM500 M2M Bedienungsanleitung

Esse-ti

Esse-ti GSM400 Bedienungsanleitung

Esse-ti

Esse-ti GSM 200 Bedienungsanleitung

Esse-ti

Esse-ti 4G.VoLTE Bedienungsanleitung

Esse-ti

Esse-ti 4GRouter Bedienungsanleitung

Esse-ti

Esse-ti 4G.evox Bedienungsanleitung

Beliebte Tor Handbücher anderer Marken

LST

LST M500RFE-AS Bedienungsanleitung

Kinnex

Kinnex Media Gateway Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace 2N StarGate Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Bedienungsanleitung

Telsey

Telsey CPVA 500 - SIP Bedienungsanleitung

RTA

RTA 460A-NNA4 Technisches Datenblatt

Shaw

Shaw Gateway HDPVR Bedienungsanleitung

ABB

ABB VSN900 Kurzanleitung

Commander

Commander Pulse Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Bedienungsanleitung

NETGEAR

NETGEAR C6300BD Bedienungsanleitung

Amit

Amit CDW531AM Bedienungsanleitung

HMS

HMS Netbiter EasyConnect EC150 Bedienungsanleitung

Huawei

Huawei EchoLife HG620 Bedienungsanleitung

AT&T

AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch

Logic IO

Logic IO RTCU MX2 turbo Bedienungsanleitung

Suttle

Suttle MediaMAX MXM-521 Bedienungsanleitung