ESSL SF1000 Bedienungsanleitung

Security at Fingertips

www.esslsecurity.com

Installation Guide

All design and specification declared are subject to change withoutnotice in advance.

SF1000

Version: 2.0

Date: May 2014

I.Use Instructions

1. Panel Description

2. Precautions

(2) Do not remove batteries when matching, enrolling or deleting fingerprints because the sudden power-down may result in data

loss of fingerprint locks.

(3) It is recommended to replace the fingerprint lock batteries at least once every six months to avoid damaging the circuit due to

the battery leakage.

(4) Operations have a stand-by (idle) time limit of 10 seconds, lock will shut off after 10 seconds of no activity. Within 5 times matching

failed, the safebox will keep locking 15 minutes, then all fingerprint / password is invalid, except mechanical key.

LED Indicator

Fingerprint Collector

Key Hole

Numpad / LED Indicator

Locking Key / Start Key / Enter Key

Figure 1

Emergency Power Interface

(1) Lockcomes indefaultdemo mode,anyfingerprint or password willopenthelock, user must first change default Master Passcode (MPC:

98989). User must have registered at least one admin before enrolling an ordinary user.

Note: The method and step of changing Master Pass Code, Enroll Administrator and Enroll Ordinary user, please refer to

II.The Basic Operation.

3. Verification mode

4. Unlock with an Emergency Mechanical Key

You can open the lock using an emergency mechanical key in case the electronic component does not operate.

(1) Capping the tip of the tool into the lock flap at the bottom, a little force to pry open the lock cover.

(2) Insert the emergency key into the keyhole and rotate 90ºto unlock, as shown in Figure 2.

5. Reset

The red reset button is on the inner side of front panel（as shown in Figure 3）, it is used to restore factory setting by following steps:

Press to activate lock, then long press reset button 5 seconds until you hear a long beep.

6. Battery Low Voltage Protection

Please change the battery in time when you hear short sharp sounds five times made by buzzer.

7. Two ways to Unlock the Non-lock Status Alarm

(1) Press and at the same time push the door inward, the machine will lock automatically.

(2) Lock it by the mechanical key. The alarm will be switched off after the proper locking is done.

Successful

1 Long Beep/ LED Flashes Green

Access Mode

Green LED flashes every second

Failed

2 Short Beeps/ LED Flashes Red

User ID

Admin (995~999)

Ordinary (001~994)

Figure 2

Figure 3

II. The Basic Operation

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

Change

Master

Passcode

Enroll Admin

Fingerprint

Enroll

Admin

Password

Enroll

Ordinary

User

Fingerprint

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Enter MPC[98989]

2. Press

1. Enter MPC

2. Press

1. Enter MPC

2. Press

1. Enter MPC or Verify

Admin byFingerprint /

Password

2. Press

1. Press

2. Enter User ID

(995~999)

3. Press

1. Enter same

codeagain

2. Press

Placefinger 3

times

Placefinger 3

times

1. Enter a 6~10

digits password

2. Press

1. Enter same

password

again

2. Press

Long beep

and green

flash

Long beep

and green

flash

Long beep

and green

flash

Long beep

and green

flash

1. Press

2. Enter new

5-digitcode

3. Press

1. Press

2. Enter User ID

(995~999)

3. Press

1. Press

2. Enter User ID

(001~994)

3. Press

Enroll

Ordinary

User

Password

DeleteUser

Modify

Verification

Mode

Restore

Factory

Settings

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Press toactivate lock

2. Long press until you

hear a long beep and LED

light off

1. Enter MPC or Verify

Admin byFingerprint /

Password

2. Press

1. Enter MPC or Verify

Admin byFingerprint /

Password

2. Press

1. Enter MPC or Verify

Admin byFingerprint /

Password

2. Press

1. Enter MPC or Verify

Admin byFingerprint /

Password

2. Press

1. Enter a 6~10

digits password

2. Press

1. Enter same

User ID again

2. Press

1. Enter [111]: normal mode (all registered users)

Enter[222]: safe mode (ordinary user with

fingerprint + password, or admin)

2. Press

1. Enter [0000]

again

2. Press

1. Enter same

password

again

2. Press

Long beep

and green

flash

Long beep

and green

flash

Long beep

and green

flash

Press

1. Press

2. Enter [0000]

3. Press

1. Press

2. Enter User ID

(001~994)

3. Press

1. Press

2. Enter User ID

(001~994)

3. Press

Ⅲ. Preparations before Installation

1. Packing list

Name

Safebox

Expansion screw

Mechanical key

Buckle

Division plate

Installation guide

Quantity

2 keys+ Capping tool

2. Recommended Installation Tools

Spanner Percussion drill

Ⅳ.Install the Safebox

1. Structure Description

Four mounting holes in the back panel Four mounting holes on the baseboard Expansion screw

Expansion bolt

Expansion tube

Gasket

Split washer

Screw nut

2. Installation Procedure

(1) Drill holes.

257mm

300mm

4-Φ10mm

257mm

4-10mm

(2) Fix the expansion screw in the wall.

Put expansion bolt and expansion tube together insert into the hole.

Fit on gasket, split washer and screw nut.

Tighten screw nut by spanner until the expansion tube is expanded, which makes expansion bolt fixed on the wall.

Take out gasket, split washer and screw nut.

Back panel

Baseboard

Wall

Inhaltsverzeichnis

Andere eSSL Sicher Handbücher

eSSL

eSSL SAFE 301 Bedienungsanleitung

Beliebte Sicher Handbücher anderer Marken

Squire

Squire Stronghold Keysafe Bedienungsanleitung

Phoenix

Phoenix FS0352C Produktinformationsblatt

Phoenix

Phoenix KS0030E Series Bedienungsanleitung

Vaultek

Vaultek 10 Series Technisches Datenblatt

Arregui

Arregui CLASS Bedienungsanleitung

Beaumont

Beaumont SMART KEYBOX Bedienungsanleitung

Honeywell

Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Bedienungsanleitung

Hornady

Hornady SnapSafe Trunk Safe II Bedienungsanleitung

SPORTS AFIELD

SPORTS AFIELD SA-HD5-BIO Bedienungsanleitung

Honeywell

Honeywell 5912 Bedienungsanleitung

Phoenix

Phoenix FS1280F Bedienungsanleitung

Phoenix

Phoenix SS0992K Produktinformationsblatt

Technomax

Technomax Trony Series Handbuch

SPORTS AFIELD

SPORTS AFIELD INSTINCT BIOMETRIC Series Bedienungsanleitung

RICHTER CZECH

RICHTER CZECH LA Bedienungsanleitung

Olymp

Olymp GOsafe 110 Bedienungsanleitung

Phoenix

Phoenix SS0100E Produktinformationsblatt

Clarke

Clarke Strong-Arm CS1000K Bedienungsanleitung

eSSL SF1000 Bedienungsanleitung

Beliebte Sicher Handbücher anderer Marken