General Information and Safety Instructions: Installation:
READ THIS FIRST:
Check the pack and make sure you
have all of the parts listed on the
front of this booklet. If not, contact
the supplier where you bought this
When using an electrical appliance,
basic safety precautions should always
be observed, including the following:
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
• Extreme caution is necessary
where children or persons with
reduced physical, sensory or mental
capabilities may come into contact
with the heater when in use.
• The product is for household/offi ce
• In order to avoid overheating when in
use, do not cover or obstruct grille or
• Do nor leave the heater on overnight.
• Do not place the heater on carpets
• Always ensure that the heater is
placed on a fi rm level surface and
ensuring that the heater is not
positioned close to fl ammable
materials, such as curtains, drapes etc.
as this could create a fi re hazard.
• Never leave the heater unattended
• The heater must not be located
adjacent to or against an electrical
• Do not run the cord under carpets/
• Arrange the cord away from high
traffi c areas and where it will not
• Do not operate the heater with a
damaged cord/plug or if the heater
• If the supply cord is damaged, it must
be replaced by qualifi ed engineer.
• Avoid the use of an extension cord as
this may overheat and cause a risk of
• Use the heater in a well ventilated
• Do not use the heater in any
areas where petrol, paint or other
fl ammable liquids are stored e.g.
• Do not use this heater in the
immediate surroundings of a bath,
shower, swimming pool or where
NOTE: It is normal when the heaters are turned on for the fi rst time or when they
are turned on after having not been used for a long period of time the heaters
may smell slightly for a short while.
1. Take the unit out of the box and remove any protective wrapping.
2. Place the heater on a smooth level surface away from any obstacles.
3. Plug your fan heater into the power supply. Make sure your power supply
corresponds to the power indicated on the rating label.
4. Heat temperature setting can be regulated using the thermostat switch located
on the bottom left of the heater. This switch is used for both the fan and
heat elements. Note the fan speed cannot be altered and will always remain
constant. To turn the fan heater on:
Use right control and set as below:
