ETI THERMA WATERPROOF T Bedienungsanleitung
THERMA
WATERPROOF
TYPE T
THERMOMETER
Operating Instructions
INSTRUMENT OPERATION - Connect a
probe via the socket located at the top of the
instrument. (The Therma Waterproof uses a
miniature type T thermocouple connector).
Switch the instrument on and apply the tip of
the probe to the substance or medium to be
measured. The instrument reading may take
a few seconds to stabilise, depending on the
nature of the measurement and sensitivity
of the probe.
HOLD - To stop measurements press the
HOLD button, press again to continue
measuring.
AUTO-OFF - The unit will switch off
automatically after 10 minutes. To disable
auto-off press the HOLD button whilst
switching on the instrument (this is reset
when the instrument is switched off).
OPEN CIRCUIT/FAULTY PROBE - If the probe
has developed an 'Open Circuit' fault the
instrument will display 'Err'.
SENSORS - Therma Waterproof should
only be used with a type T (copper/
constantan) thermocouple probe (BS EN
60584-2) tted with a miniature type T
thermocouple plug (to BS EN 50212). This
instrument is designed to be compatible
with ETI manufactured probes.
BATTERY REPLACEMENT - The instrument
will display a low battery symbol to warn that
the batteries will need changing soon. The
instrument continues to measure accurately
but after further usage the instrument will
display 'at bat' and shutdown.
Replace the three AAA batteries located
under the rear case half that is held in place
by six screws. Check the seal for damage and
carefully replace the rear case half and re-t
and tighten the screws.
MAX/MIN - Press the MAX/MIN button to
display the values. The instrument retains the
max/min values when switched off. To reset,
press the MAX/MIN button for three seconds,
'rst' will be displayed.
BACKLIGHT - Press the HOLD button for two
seconds. Please note: The backlight will not
operate if the low battery symbol is being
displayed. (Backlight timeout = 20 seconds).
TRIM - Press the MAX/MIN and ON/OFF
buttons at start-up for ve seconds to enter
('Offset' is displayed). MAX/MIN then cycles
(continuous loop) the trim value in 0.1 steps
up to ±2.0 ºC (3.6 ºF). Press ON/OFF to save the
value and exit Trim mode.
°C/°F - Press and hold ON/OFF button for ve
seconds at start-up.
WARNING: IPA and other solvents may
cause damage to the case and screen of this
instrument.
GUARANTEE - This instrument carries a
two-year guarantee against defects in either
components or workmanship. During this
period, products that prove to be defective
will, at the discretion of ETI, be either repaired
or replaced without charge. This guarantee
does not apply to probes, where a
six-month period is offered. The product
guarantee does not cover damage caused
by fair wear and tear, abnormal storage
conditions, incorrect use, accidental
misuse, abuse, neglect, misapplication
or modication. Full details of liability are
available within ETI's Terms & Conditions
of Sale at etiltd.com/terms. In line with our
policy of continuous development, we reserve
the right to amend our product specication
without prior notice.
SPECIFICATION -Full specication details of
all products are available at etiltd.com
This instrument has been checked or
calibrated against reference instrument(s)
calibrated by a UKAS Accredited Calibration
Laboratory.
INSTRUMENT RECORD CARD
Manufactured by
Electronic Temperature Instruments Ltd
Worthing · West Sussex · BN14 8HQ
01903 202151 · sales@etiltd.com · etiltd.com
serial no. _______________________________
calibrated by___________date ___________
model order code
Therma Waterproof 232-107
0 °C 100 °C 400 °C
thermocouple
545-721/15.06.20
Inhaltsverzeichnis
Andere ETI Thermometer Handbücher
ETI
ETI ThermaData Logger Bedienungsanleitung
ETI
ETI Super-Fast Mini Bedienungsanleitung
ETI
ETI THERMAQ WIFI Bedienungsanleitung
ETI
ETI THERMA 20 Bedienungsanleitung
ETI
ETI FoodSafe 803-900 Bedienungsanleitung
ETI
ETI Precision Bedienungsanleitung
ETI
ETI 810-031 Bedienungsanleitung
ETI
ETI Raytemp 28 Bedienungsanleitung
ETI
ETI CHEFALARM Bedienungsanleitung
ETI
ETI Saf-T-Log Bedienungsanleitung
ETI
ETI FLOW CUP Bedienungsanleitung
ETI
ETI Precision Bedienungsanleitung
ETI
ETI Mini RayTemp Bedienungsanleitung
ETI
ETI ChefAlarm 810-041 Bedienungsanleitung
ETI
ETI 810-421 Bedienungsanleitung
ETI
ETI THERMAPEN IR BLUE Bedienungsanleitung
ETI
ETI Thermapen Blue with Bluetooth IE Wireless... Bedienungsanleitung
ETI
ETI 810-287 Bedienungsanleitung
ETI
ETI ECOTEMP Bedienungsanleitung
ETI
ETI THERMALITE 2 Bedienungsanleitung
