Shatal Engineering India Pvt. Ltd.
5/153/07 Poolakkadu Thottam Arasur,Coimbatore – 641407,Tamil Nadu, INDIA
8. The supporting structure, holding the winch must be stable and of load bearing
capabilities able to withstand the weights and loads listed on this page. The
support system must be designed and checked by trained and certified engineers.
9. After assembly and before operation, a certified safety regulator must check the
assembly structure and approve that the local and federal safety standards and
regulations have all been met.
10. A grounded electricity wire of at least 16 squre mm width must be used to power
the winch. The operator must ensure valid grounding.
11.Ensure that the input voltage is identical to the required winch motor voltage and
that this voltage is maintained up to a 4% drop in voltage.
12.Fence off a parimeter of 3x3 squere meters around the lifting arm only accessible
while the winch is not in operation and the lifting surface is secure.
13. Lifting loads not directly under the lifting hook is forbidden.
14.Maximum load for lifting is 120 kg
15.The winch operator must remain in direct eye contact with the load through out the
winching operation.
16.The winch operator and loading technician must wear safety helmets.
17.The winch must be protected from rain.
18. All electricity systems repair and maintenance must be operated on by a
certified electrician.
19. The winch shall not be used in a slippery or explosive envirnment.
20. The security stickers must remain on the winch at all times.
Installation instructions:
This winch must be checked by a certified safety regulator with respect to the structure
and installation of the winch support system.
Read, understand and comply with all the instructions in this manual.
Connecting lifting hook support support system:
-The winch support system must be strong enough to bear loads and requires
approval of a certified safety regulator in accordance with local and federal safety
standards before operation.
-Install the lifting arm assembly onto the winch support bar that is mounted onto a
support surface.
-Position the lifting arm opposite the center of the wire cable drum.
-Close both M12 bolts on the lifting arm.
