Electric Ove s rev. 0_ _ _ _ _ ___ _ ___ ___ ___ ___ ___ __ _ _____ _ ___ ___ ___ ___ ___ EF 411/999/00113 – EF 464/999/00113
_________________________________________________________________________________________ page 5
4.
4. 4.
4. I structio s for the i staller
I structio s for the i stallerI structio s for the i staller
I structio s for the i staller
The followi g i structio s are aimed at the qualified i staller, to e sure that he carries out the
i stallatio , adjustme t a d mai te a ce operatio s as correctly as possible a d accordi g to
curre t legal regulatio s. A y operatio must be performed with electrical power cut to the
applia ce.
Before usi g the applia ce, carefully remove the special adhesive film protecti g the parts i
stai less steel. Do ot leave a y glue residues o the surfaces. If ecessary, remove them at o ce,
with a appropriate solve t.
Fitti g the feet
Fitti g the feetFitti g the feet
Fitti g the feet - The feet are i side the applia ce a d must be secured o the four threaded
holes o the base. If ecessary, the height of the feet ca be adjusted by screwi g or u screwi g.
Positio i g
Positio i gPositio i g
Positio i g - Positio the applia ce perfectly horizo tally o a table or similar support (the table
or support must be at least 85 cm above the floor). Positio it at a dista ce of ot less tha 10
cm from the side a d rear walls, to e able atural ve tilati g air to circulate freely arou d it. The
applia ce is ve tilated through specific ope i gs o the metal walls of the outer housi g , a d
e sures efficie cy a d lo g-life. For this reaso it is strictly forbidde to obstruct these ve tilatio
ope i gs, eve partially or for short periods. Failure to observe this specific prohibitio releases
Failure to observe this specific prohibitio releases Failure to observe this specific prohibitio releases
Failure to observe this specific prohibitio releases
the ma ufacturer of the applia ce from all respo sibility a d immediately voids a y guara tee
the ma ufacturer of the applia ce from all respo sibility a d immediately voids a y guara tee the ma ufacturer of the applia ce from all respo sibility a d immediately voids a y guara tee
the ma ufacturer of the applia ce from all respo sibility a d immediately voids a y guara tee
rights for the said applia ce,
rights for the said applia ce, rights for the said applia ce,
rights for the said applia ce, because its co structive co formity has bee volu tarily
compromised. Furthermore, the applia ce is ot suitable for embeddi g a d for grouped
positio i g with other ide tical applia ces.
Electrical co ectio
Electrical co ectioElectrical co ectio
Electrical co ectio - The applia ce must be co ected to the electrical mai s accordi g to
curre t legal regulatio s. Before maki g the co ectio , make sure of the followi g:
-the voltage a d freque cy values of the power supply system match the values o the
"tech ical data" plate affixed o the applia ce;
-the limiti g valve a d the system are able to support the applia ce's load (see the
"tech ical data" plate);
-the power supply system has a adequate earth co ectio accordi g to curre t legal
the power supply system has a adequate earth co ectio accordi g to curre t legal the power supply system has a adequate earth co ectio accordi g to curre t legal
the power supply system has a adequate earth co ectio accordi g to curre t legal
regulatio s;
regulatio s;regulatio s;
regulatio s;
-a om ipolar switch with mi imum betwee -co tacts aperture of the overvoltage category
III (4000 V), sized to the load a d co formi g to curre t legal regulatio s, is fitted
betwee the applia ce a d the mai s i the direct co ectio to the mai s;
-the om ipolar switch used for co ectio is easy to reach whe the applia ce is i stalled;
-the yellow/gree earth wire is ot i terrupted by the switch;
the yellow/gree earth wire is ot i terrupted by the switch;the yellow/gree earth wire is ot i terrupted by the switch;
the yellow/gree earth wire is ot i terrupted by the switch;
-the power supply, whe the applia ce is operati g, must ot deviate from the rated
voltage value by ±10%;
-make sure that after i serti g the power supply cord i to the termi al block it does ot
come i to co tact with a y of the cooki g ra ge's hot parts.
-if the supply cable is damaged the it must be replaced by the ma ufacturer or by your
if the supply cable is damaged the it must be replaced by the ma ufacturer or by your if the supply cable is damaged the it must be replaced by the ma ufacturer or by your
if the supply cable is damaged the it must be replaced by the ma ufacturer or by your
tech ical support or by a qualified perso to avoid a y risk.
tech ical support or by a qualified perso to avoid a y risk.tech ical support or by a qualified perso to avoid a y risk.
tech ical support or by a qualified perso to avoid a y risk.
Co ectio to the water mai s
Co ectio to the water mai sCo ectio to the water mai s
Co ectio to the water mai s - (for ove s predisposed to humidifier sole oid-valve)
The applia ce must be fed with softe ed dri ki g water, with hard ess from 0.5°F to 3°F (it is
obligatory to use a softe er to reduce the formatio of lime i side the cooki g chamber) a d
pressure i the ra ge from 100 to 200 kPa (1.0 - 2.0 bar).
Co ectio to the water mai s should be made through the threaded 3/4" sole oid-valve o the
rear (o the bottom) of the applia ce, fitti g i betwee a mecha ical filter a d a o /off tap
(before you co ect the filter, allow a certai qua tity of water to flow out i order to drai a y
waste from the pipe).
