Control panel
1 –On/Off button
2 –Timer button
3 –Speed button
4 –Ionizer and UV button
Effect
6. Dirty, dusty air is sucked into the right side of the device.
7. The effective HEPA filter traps dust, hairs, lint, pollen, etc., and 99.97% of the remaining
contaminant particles, from 0.03 micron (=0.0000003 mm).
8. The activated carbon filter removes odours and toxic gasses with its adsorption process –
Activated carbon binds a great number of substances.
9. The PCO filter (Photo Catalytic Oxidation) and the UV lights can kill viruses and bacteria,
while simultaneously reducing the odours.
10. The device is fitted with a negative ion remover, which further perfects the purification of
the air with the electrostatic precipitation of minute particles in the air.
Use
- Remove the packaging and check the device for damage. If damage has occurred, contact
your supplier. Save the packaging.
- Place the device on a robust, flat and horizontal surface.
- Before use, check compliance with all safety regulations. Only insert the plug into the
socket after you have done this.
- Push the ON/OFF button to use the device. The device starts its filter operation
(continuous) at low power and including the ioniser. The appropriate indicator lights are lit.
- Use the Timer button to set a certain operating time: 1 x push is 2 hours, 2 x push is 4
hours, 3 x push is 8 hours, 4 x push returns the device to continuous operation. The
appropriate light is lit.
- Use the Speed button to select a ventilator speed (and a power setting). When it is
switched on the device works at low speed (L). Every time you push the button the speed
changes: from L (low) to M (medium) and from M to H (high) and then back to L. The
appropriate light is lit.
When you use the device for the first time allow it to first operate at high speed for half an
hour.
- Use the Ioniser and UV buttons to activate the Ioniser and/or the UV lights as you desire.
As standard, only the ioniser works when the device is switched on. Push x 1 to activate the
ioniser and UV lights, push x 2 to use only the UV lights and push x 3 to deactivate both the
ioniser and UV lights.
- Push the ON/OFF button again in order to switch the device off again. Always remove the
plug from the socket after switch the device off.
Cleaning and Maintenance
Always switch the device off and remove the plug from the socket before cleaning or
maintenance!
- The plastic housing can be cleaned with a soft, slightly moist cloth (not wet!) and a cleaning
agent that is mild and non-abrasive.
- The 3-in-1 filter block can be carefully cleaned with a brush or vacuum cleaner. Never make
it wet! This filter must be replaced regularly.
