V8 Multi-Purpose Kiln
Installation and Operating Manual
North American Model
December 2015
Page 2of 18
Kiln Location Safety
The best location for the kiln is a non-combustible work surface. Work surfaces constructed entirely of metal are preferred.
Do not place or use kiln on combustible surface.
Place only on the metal stand provided by Evenheat Kiln, Inc.
For those using the kiln for vitrigraph work it is required that the kiln base be physically attached to the vitrigraph enabling structure to
prevent potential safety hazards. It is also required that the vitrigraph enabling structure be of such a design as to be stable and physically
secure.
For those wishing to use the V-8 Multi-Purpose kiln as a “Vitrigraph” Evenheat offers an accessory base intended for this purpose, part #00342.200.
This accessory based is intended for use with vitrigraph operations only and includes a 2-3/4” opening in the base. Firing the kiln on any base that has
not been provided by Evenheat Kiln, Inc. can be dangerous and is highly discouraged.
Do not use the Evenheat accessory #00342.200 vitrigraph base for any types of firing other than vitrigraph work.
The surface on which the kiln is placed shall be capable of safely supporting the combined weight of the kiln and kiln load.
Observe all building, fire and safety codes when installing the kiln.
Do not install the kiln closer than 12” (31cm) from combustible wall surface or object or 36” from any ceiling surface in all opened and closed
positions.
Install in a covered, well ventilated area.
Never place the kiln in a small, enclosed area such as a closet, cabinet or very small room. The room in which the kiln is placed into service shall be
capable of safely dissipating all heat produced by the kiln.
Do not place the kiln in any structure resembling a carport or screened in porch. Avoid areas that are subject to outdoors weather.
Never install a kiln outside. Avoid moisture.
It is the user’s responsibility to be knowledgeable regarding any and all contaminants, produced by the ware during firing, and take steps to properly
and legally contain and dispose of these contaminants.
It is the user’s responsibility to provide ventilation capable of removing all gases, fumes and other airborne contaminants produced by the ware
during firing safely from work the area and building structure.
Do not store flammable or combustible products near or in the same room the kiln such as gasoline, paint, aerosol cans, paper, curtains,
plastics, etc. Better yet, store these items in another separate structure designed for this purpose.
Position the power supply cables, power supply conduit, controller cables, pyrometer thermocouple leads and other materials in such a way as not to
create a tripping hazard around the kiln.
The area around the kiln should be free of obstructions that interfere with the proper and safe operation of the kiln.
Never place anything under or above the kiln for storage. Absolutely nothing should be propped against the kiln.
Kiln Use Safety
The surface of the kiln is hot and burn injuries are possible. Keep all children and unsupervised personnel away. Always wear protective
clothing, gloves and eyewear when operating and handling a hot kiln.
Use extreme care when accessing a functioning and/or hot kiln. Under no circumstances should you touch the heating elements with your
body or any other devises like tools. Electrical shock may result in serious injury or death.
Use care when accessing or looking into a hot kiln, this includes looking through a cracked lid or peepholes. High heat escapes quickly and
burn injury may result. When accessing or looking into a hot kiln, approach slowly and wear protective clothing and gloves designed to
withstand high heat and eyewear capable of filtering Infrared and Ultraviolet light.
