10
1. Click the button to automatically detect the network’s IP address
range (Auto Detect)
2. A conguration window will open
3. Select one of the address lines with a single click
4. Press the “OK” button
5. Press the “Start Scanning”
6. Wait for the scanning process to nish and the progress line to
reach the end
7. When the scan ends, the program will show you a table of IP
addresses belonging to the devices connected to the network
The speakers are usually called “Amati. linea” in the “Host Name”
column. If this name is not in the list, then the speakers’ IP is likely
to be the last in the list. If this is not the case, you must nd the
speakers’ IP by testing the addresses: copy one of the IP addresses
at a time into your browser’s address bar and press “Enter” until the
browser displays the speakers’ control interface.
Launch the program
SOFTPERFECT NETWORK SCANNER
1
2
3
4
5
6
7
Attention:
Write down the device’s MAC address – you will need it to set up IP address reservation.
1. Press the “Scan” button to start scanning the network
2. Wait for the scan to nish. When the process nishes, the program will display
the message “Scan nished!”
3. When the scan ends, the program will show you a table of IP addresses belong-
ing to the devices connected to the network
The speakers are usually called “Amati. linea” in the list. If this name is not in the
list, then the speakers’ IP is likely to be the last in the list.
Launch the program
If this is not the case, you must nd the speakers’ IP by testing the addresses:
Copy one of the IP addresses at a time into your browser’s address bar and press “Enter” until the browser displays the
speakers’ control interface.
Attention: Write down the device’s MAC address (shown directly below the IP address) – you will need it to set up IP address
reservation.
8. Copy the IP address into your browser’s address bar and press the “Go” button
Due to the fact that the IP address is usually set dynamically, meaning it changes whenever the device turns on, we recommend
setting up IP address reservation (to prevent the device’s IP address from changing). This will allow you to avoid going through
the process of nding the device’s IP address again in the future. See the “Conguring IP address reservation” section.
NETWORK SCANNER
1
2
3
4
