Evolution Aqua Eamarine 600 Kurzanleitung

INSTALLATION AND INSTRUCTION MANUAL FOR

eaMarine 900 / 600 / 450 Aquariums

Evolution Aqua Ltd. - Evolution House - Kellet Close - Wigan - Lancashire - United Kingdom - WN5 0LP

t +44 (0) 1942 216554 - f+44 (0) 1942 216562 - e[email protected] - wwww.evolutionaqua.com

English

EAMAR12710141MAN

PLEASE READ all of the instruction manual before attempting

to set-up your new eaMarine Aquarium

WARNING: PLEASE READ THE FOLLOWING

SAFETY INFORMATION FIRST.

DANGER: To avoid a possible electric shock, ensure all electrical devices are

switched off when carrying out maintenance. Take extra care when handling a

wet aquarium. Do not attempt repairs yourself; return the appliance to the place

of purchase for service or dispose of the appliance.

• To avoid the possibility of the appliance plug or socket

getting wet, position the aquarium cabinet and tank to

one side of a wall mounted socket to prevent water

from

dripping onto the socket or plug. You should create

a “drip loop” for each cord connecting an aquarium

appliance to a socket. The “drip loop” is that part

of the cord below the level of the socket, or the

connector. Use an extension cord, if necessary, to

prevent water travelling along the cord and coming

into contact with the socket.

• Always unplug an appliance from an outlet when not in use, before putting on or taking off

parts, and before cleaning. Never pull the cord itself to remove the plug from the outlet.

Hold the plug and pull to disconnect.

• If the plug or socket does get wet, DO NOT unplug the cord. Disconnect the fuse or circuit

breaker that supplies power to the appliance. Then unplug the device and examine for presence

of water in the socket.

• Close supervision is necessary when any appliance is used by or near children.

• Do not use an appliance for anything other than its intended use. The use of attachments not

recommended or sold by the appliance manufacturer may cause an unsafe condition.

• Do not install or store the appliance where it will be exposed to the weather or to temperatures

below freezing point.

• Make sure an appliance mounted on a tank is securely installed before operating it.

Read carefully all the important notices on the appliance and the corresponding instruction manual.

NOTE: A cord rated for less amperes or watts than the appliance rating may overheat. Care should

be taken to arrange the cord so that it cannot be tripped over or pulled accidentally.

DRIP LOOP

CONTENTS

eaMarine parts list PAGE 4

Specifications PAGE 5

How the aquarium works PAGE 8

Installation instructions PAGE 9

Positioning the cabinet PAGE 9

Positioning the tank PAGE 9

Equipment set up PAGE 10

Starting the moving bed PAGE 12

Cleaning instructions PAGE 13

About the revolutionary K1 Micro marine filtration method PAGE 14

No protein skimmer necessary! PAGE 15

How to get the best from your ea aquarium PAGE 16

Warranty PAGE 18

Spare Parts List PAGE 21

Troubleshooting PAGE 22

INTRODUCTION

Congratulations on purchasing an Evolution Aqua aquarium. Evolution Aqua are

the global leaders in pond and aquarium filtration and innovation, and pioneers

of moving filter bed technology for ornamental fish. Building on the success of

their award-winning filters and bacterial products Evolution Aqua have designed

and manufactured an aquarium suitable for keeping tropical marine fish and

invertebrates. An eaMarine aquarium makes marine-keeping not only approachable

for beginners but also easy and enjoyable, while at the same timing combining

the right science, engineering and quality components to cater even for the most

seasoned aquarists and aquatic professionals.

Please read this instruction manual carefully from start to finish before setting up

your new eaMarine aquarium.

eaMARINE PARTS LIST

Your eaMarine Aquarium comes complete with the following items:

2) eaCabinet with

adjustable feet

5) K1 Micro®biological

filter media

8) Kessil gooseneck

IF SUPPLIED

1) eaAquarium with

built-in In Tank

Sump System

4) EA 200 Micron

filter sock(s)

7) Kessil Spectral

Controller

IF SUPPLIED

10) PURE Reef

Balance (20 Balls)

SEE PAGE 12

11) 4 x segments of

loc-line flexible hose

11) Handle for cabinet

(eaMarine900 only)

3) 2 x Eheim pumps

(hose(s) and elbows)

6) Kessil light(s)

IF SUPPLIED

9) Kessil Unit Link

cable(s)

IF SUPPLIED

SPECIFICATION eaMarine 450

Aquarium dimensions 450mm (L) x 500mm (W) x 450mm (H)

Aquarium gross volume 101.25 Litres / 22.27 Gallons

Cabinet dimensions 450mm (L) x 500mm (W) x 800mm (H)

Aquarium specification 8mm glass thickness all-round, cerium polished

with low-iron front and sides

pumps Qty 2 x Compact 600 (600 lph, 11W)

LED lighting Qty x 1 A160WE Tuna Blue (40W. 10,000K-Actinic spectrum)

Accessories Spectral Controller, Gooseneck

Filtration included 200 micron mechanical filter sock

1 litre of biological filter media

SPECIFICATIONS AND DIMENSIONS

eaMarine450 Supplied with:

A160WE TUNA BLUE

Qty x 1

(eaMarine450-A160 models only)

450mm

500mm

450mm

800mm

SPECIFICATIONS

eaMarine600

SPECIFICATION eaMarine 600

Aquarium dimensions 600mm (L) x 500mm (W) x 450mm (H)

Aquarium gross volume 135 Litres / 29 Gallons

Cabinet dimensions 600mm (L) x 500mm (W) x 800mm (H)

Aquarium specification 8mm glass thickness all-round, cerium polished

with low-iron front and sides

pumps Qty 1 x Compact 1000 (1000 lph, 23W)

Qty 1 x Compact 600 (600 lph, 11W)

LED lighting Qty x 2 A160WE Tuna Blue (40W. 10,000K-Actinic spectrum)

Accessories Spectral Controller, Goosenecks, Unit Link Cable

Filtration included 200 micron mechanical filter socks

1 litre of biological filter media

600mm

500mm

450mm

800mm

Supplied with:

A160WE TUNA BLUE

Qty x 2

(eaMarine600-A160 models only)

SPECIFICATIONS

eaMarine900

SPECIFICATION eaMarine 900

Aquarium dimensions 900mm (L) x 500mm (W) x 450mm (H)

Aquarium gross volume 202 Litres / 45 Gallons

Cabinet dimensions 900mm (L) x 500mm (W) x 800mm (H)

Aquarium specification 10mm glass thickness all-round, cerium polished

with low-iron front and sides

pumps Qty 2 x Compact 1000 (1000 lph, 23W)

LED lighting

Qty x 2 A160WE Tuna Blue (40W. 10,000K-Actinic spectrum)

Qty x 2 A360WE Tuna Blue (90W. 10,000K-Actinic spectrum)

Accessories Spectral Controller, Gooseneck, Unit Link Cable

Filtration included 200 micron mechanical filter socks

1.8 litres of biological filter media

OR CAN BE SUPPLIED WITH

Supplied with:

A160WE TUNA BLUE

Qty x 2

(eaMarine900-A160 models only)

Or supplied with:

A360WE TUNA BLUE

Qty x 2

(eaMarine900-A360 models only)

900mm

500mm

450mm

800mm

HOW THE AQUARIUM WORKS

Heater

Filter Sock

Pump

K1 Micro

Heater

Filter Sock

Pump

K1 Micro

Spare

Chamber

Heater

Spare

Chamber

Surface scavenging weir Emergency overfow slots

Filter Sock

Pump

K1 Micro

• Water enters the filter through the surface scavenging weir and solid waste is trapped by

the filter socks.

• Mechanically-cleaned water flows through the filter socks and is warmed by the heater

(not included).

• Water exits the sock chamber and flows up, through into the moving bed filter chamber.

Beneficial bacteria feed on any ammonia in the water, converting it to much less harmful

substances. The filter media spins around and around maximising its exposure to the

aquarium water in each pass. Biofilm grows on the outer surfaces of the K1 Micro media

and old biofilm is sloughed off, making room for more new biofilm growth while sending

old biofilm through to the main tank as food for corals. Protected bacteria inside K1

Micro’s specially engineered quiet zones aid de-nitrification and provide food and refuge

for higher life-forms.

• Water exits the filter chamber and is returned to the main tank via the two return pumps

and wide outlet, direction adjustable flare nozzles.

The only regular maintenance required is to clean or replace the filter socks weekly and to

top up the pump chamber with RO/DI water to replace water lost through evaporation.

Diagram above shows flow through eaMarine 900 filter system

Diagram above shows flow through eaMarine 450 filter system Diagram above shows flow through eaMarine 600 filter system

Your eaMarine cabinet comes to you pre-built by skilled tradesmen, so just needs positioning.

PLEASE NOTE: Your finished aquarium should be away from doors and radiators,

out of direct sunlight and near to, but not directly over, power sockets.

Positioning the cabinet

One litre of water weighs one kilogram (1kg) so your furnished aquarium will weigh in

excess of 100 kilograms (100kg) when filled. The cabinet must be placed on a strong,

level floor and underneath the cabinet you will find four or five adjustable feet which can be

twisted in or out to set the height and level of the aquarium. Using a spirit level, adjust all

feet until the cabinet is level both left to right and front to back.

Once this is achieved the door should also be level and need no adjustment. If further door

adjustment is necessary open the door and either turn in or out the two adjustment screws

located on the hinge itself. Make sure that the top of the door does not raise up above the

top of the cabinet, as it will then rub on the aquarium above when opened.

Positioning the tank

Your eaMarine aquarium comes supplied with a foam base mat that is pre-fitted.

This base mat will protect the underside of the tank from any pressure points.

Using the aquarium without a foam base mat will void the warranty.

Line up the glass aquarium edges with the four cabinet sides when the doors are closed.

The front of the aquarium should float over the doors with a small gap underneath to

allow the doors to open and close freely.

INSTALLATION INSTRUCTIONS

Equipment set up

Your eaMarine aquarium is supplied with socks, pumps, hoses, and flare nozzles

pre-installed within the In Tank Sump System.

STEP 1. Place the heater-thermostat (not supplied,) into the specially allocated hole in

the filter sock chamber at the back of the tank.

STEP 2. Remove the cable tie from the Eheim pump cables.

STEP 3. Pour the K1 Micro into the filter chamber.

STEP 4. Attach the Kessil lights to the goosenecks as shown in the Kessil instructions

and connect to the Spectral Controller. Clamp the goosenecks to the rear tank

rim, run all power cables down the back into the cabinet and fit the filter

lid. Cut-outs have been made in the filter dividers and lid to allow for power

cables.

STEP 5. Plug all power cables into a multi-socket and circuit breaker for safety (not

supplied,) and install a drip loop in the mains power cable before it goes to the

mains socket. Do not plug in pumps or heater until the aquarium is filled with

water.

STEP 6. Fill the aquarium with salt water of the correct temperature and salinity

for tropical marine fish and corals. When the water level is near the top,

approximately 20mm from the top of the front of the aquarium, water will

naturally fall through the surface skimming weir slots by gravity, and start to

fill the chamber. Continue filling until water has nearly filled all of the final

pump chamber.

STEP 7. Plug in the Eheim return pumps and switch them on. Water should now be

pumping into the main tank.

STEP 8. Watch the water level in the final pump chamber as it should start to drop.

Add more water until the operating water level in the final pump chamber is

50mm from the top tank rim.

STEP 9. Turn the power to the pumps off to familiarise yourself with how the In Tank

Sump System works in event of power loss. Water will be sucked back into

the main chamber via the flare nozzle outlets and also through the surface

scavenging weir. Within a few seconds water level in the final pump chamber

will rise to equalise with that of the main tank. Water level in the filter should

remain below the emergency overflow slots when power is off. If water can

pass through the overflow slots when power is off the tank is over-filled.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Evolution Aqua Tierpflegeprodukte Handbücher

Evolution Aqua

Evolution Aqua Detox Dechlorinator Bedienungsanleitung

Beliebte Tierpflegeprodukte Handbücher anderer Marken

Schwinn

Schwinn Rascal Bedienungsanleitung

K&H

K&H Small Animal Bedienungsanleitung

SHOR-LINE

SHOR-LINE 006.3230.00 Bedienungsanleitung

Petsafe

Petsafe Stubborn Dog Receiver Collar Bedienungsanleitung

Datamars

Datamars OMNI MAX Bedienungsanleitung

Trixie

Trixie 24444 Bedienungsanleitung

Roverpet

Roverpet 30DDPP Bedienungsanleitung

SportDOG

SportDOG SD-105S-C Bedienungsanleitung

Staywell

Staywell 400 Series Magnetic Bedienungsanleitung

Dogtek

Dogtek Sonic Birdhouse Bedienungsanleitung

Togfit

Togfit Deluxe Trigger Lock Door Gate Bedienungsanleitung

Girafus

Girafus 227PA Bedienungsanleitung

ubbink

ubbink KoiFeeder Solar Bedienungsanleitung

CADOCA

CADOCA Deuba 106911 Bedienungsanleitung

Dogtra

Dogtra RR Deluxe Bedienungsanleitung

Carson

Carson CONVERTIBLE PET YARD 2200 Bedienungsanleitung

Creative Cedar Designs

Creative Cedar Designs K-9 Kabin Bedienungsanleitung

Petdwell

Petdwell ON2PETS Canopies Bedienungsanleitung

Evolution Aqua eamarine 600 Kurzanleitung

Beliebte Tierpflegeprodukte Handbücher anderer Marken