1 2
INSTALLATION
WARNING: Do not exceed 10AMP total. Allow 600mm clearing from the ground or wet surface
THE REMOTE
Selected
Channel On
All Channels Off
Channels 1-6
Selected
Channel Off
Change Channel
ADDING A FIRST REMOTE
1. Select Channel 1 on the
remote by using the
select button.
2. Insert a paperclip into
the learn hole on the back of
the remote (Next to the screw)
3. The Power Point will beep
four (4) times to indicate
successful pairing.
ALL ON/OFF FUNCTION DELETE ALL REMOTES/RESET PIN
Swipe BACK of remote to the
right-hand side of the Power Point
to turn ON or OFF both Power Points
1. Select channel 1 by pressing
“Select” on both the master and
secondary remotes.
2. Insert a paper clip pin into
the reset hole at the back of
the master remote.
3. The power point will begin
to beep. Press the ‘ON’ (^)
button on the second remote.
ADDING A SECOND REMOTE TO THE POWER POINT
4. The Power Point will beep
four (4) times to indicate
successful pairing.
SS
MM
M = Master Controller (already Paired)
S = Second Remote (to be paired)
M S
1. Ensure the remote is
already learned to power
point 1 and all remotes
have been deleted from
power point 2.
2. Isolate power point 1 by cutting
the power from the mains (or
disconnecting from the wall).
PAIRING TWO POWERPOINTS TO ONE REMOTE
OFF ON
12
3. Select Channel 3 on the
remote by using the “select”
button.
4. Insert a paper clip pin into
the reset hole at the back of
the remote.
5. The Power Point will beep
four (4) times to indicate
successful pairing.
2
10
sec
1. Hold the back of the remote
to the right hand side of the power
point 10 seconds.
2. The powerpoint will have a
continuous tone then beep 4 times
to indicate completion of deletion &
PIN reset back to default (1234).
