The FIXTURE SETUP screen is used to choose all the parameters of a fixture.The
ZONES & MEMORIES screen provides zone adjustment and memory management.
FIXTURE CONTROL
9
Fixture setup screen
Zones and memories screen
Assign a zone to the fixture.
The brightness of each zone can
be controlled on the dedicated
page (see below).
Enter the DMX address of the
fixture.
The address should match the
one set on the fixture itself.
If no address is specified, the
system will automatically assign
the first address available.
Grand master: adjust the
brightness of all fixtures
(independently of their zone
selection).
Zone adjustment: control the
brightness of all the fixtures
assigned to the zone.
Pick a memory to unlock its control:
•Erase: deletes the memory’s content.
•Save: saves all the current settings
(including zones and grand master).
•Apply: restores a saved memory.
Saves all the settings made and
go back to the main window.
Thememorystateisdefinedbyitscolour:
•Yellow: Memory currently selected.
•Grey: Memory is free, ready to be used.
•White: Memory already used.
Enable / Disable the fixture.
Go back to the main window ignoring
any changes made.
Select the profile of the fixture to
control, from the DMX library.
Using the navigation arrows,select the
brand, then select the fixture + mode.
EN
