6
ON/OFF
Note: 1. In standby working mode, press the“ON/OFF ” key
the hob switch off.
3. Every heating zone is independent each other.
Operation Instructions:
Timing function
Switch on the ceramic hob
Press the “On/Off” key, the hob go to stanby mode,all the indicator
shows “-”.If the ceramic plate is hot,the indicator shows “-” and “H”
alternately.
Press the “-” or “+“ to decrease or increase the power level. If the
power level returns to 0, the zone switch off.
2 . In the standy mode,if no any other action within 1
minutes,the hob switch off.
Cooking timer
Minute reminder
Select first one cooking zone by press the “-” or “+” of the
corresponding heating zone,then the cooking zone display flashing.
Then adjust timer by +/- of timer, after the timer indicator flashing 5
seconds, the timer is confirmed. You will find a red dot display at the
cooking zone indicator you selected. It reminds you this cooking zone
is with a timer setting. When cooking timer expire,relative cooking zone
will be swhitch off automatically. Cooking timer only works for one
cooking zone at the same time.
Timer can be used as a Minute reminder. Active timer by press “+”or ”-”
key, display shows "00", adjust timer by press +/- key, single touch
+/- key will increase or decrease 1 Minute, by press and hold +/- key
you can adjust time by 10 Minutes. After 5 seconds, display will stop
flashing, Minutes reminder start count down. Buzzer will bips for 30
seconds when setting time reached and the display shows "- -",
cooking process and power setted will not be affected by Minute reminder.
Treble loop function
The hob is fitted with double zone
Active the double zone
If you want to use bigger heating zone, press the “ ” when the hob
is in working mode .
Press the " " for the first time, it works in double loop working mode.
Press the " " for the second time, it works in treble loop working mode.
Press the " " for the third time, it returns to the single loop working
mode.
Note : 1.The function is available in the 3# heating zone.
2.You can change the power level from 1 to 9.
3. When the Double loop function is available, the corresponding
indicator shows “P”
