Extron electronics SW HDMI Series Bedienungsanleitung

Product Category

SW HDMI Series • Setup Guide

The Extron SW HDMI Series are two and four input, one output, High-deﬁnition Multimedia Interface (HDMI) switchers that

allow multiple HDMI signals, including digital video, 3D signals, and embedded multi-channel digital audio to be switched

to one compatible display. These switchers support all standard single link HDMI (up to 225 MHz) and DVI 1.0 signal formats

and are compatible, at 60 Hz, with all HDTV resolutions up to 1080p and PC resolutions up to 1920x1200, with 12-bit color.

They are fully HDCP compliant. This guide provides basic instructions for an experienced installer to set up and operate

these switchers.

NOTE: For full installation, conﬁguration, and operation details, see the SW HDMI Series User Guide, available at

www.extron.com.

Rear Panel Features and Connections

0.3A MAX

POWER

12V1

Tx Rx

RS-232 AUTO

234

INPUTS OUTPUT REMOTE

aPower connector for 12 VDC, 1 A power supply bHDMI input connectors

cHDMI output connector dRemote and auto-input switching connector

Installation Steps

1. Turn off all of the equipment and disconnect it from the power source.

2. (Optional) Mount the switcher on a rack shelf or furniture.

3. Connect HDMI input sources to one or more of the SW HDMI input connectors (bon the rear panel diagram above).

NOTE: LockIt®cable lacing brackets, one for each HDMI input and output connector, are provided with the

SW HDMI. These brackets can be used to secure the HDMI cables to the rear panel connectors to reduce

stress on the HDMI connectors and prevent signal loss due to loose cable connections. For information on

attaching the LockIt brackets, see the LockIt HDMI Lacing Bracket Installation Guide card, available on the

Extron website at www.extron.com.

HDMI

Type A Receptacle

18 2

HDMI

Type A Plug

182

Pin Signal Pin Signal Pin Signal

1 TMDS data 2+ 7 TMDS data 0+ 13 CEC*

2 TMDS data 2 8 TMDS data 0 14 Reserved (NC)

shield shield

3 TMDS data 2– 9 TMDS data 0– 15 SCL

4 TMDS data 1+ 10 TMDS clock+ 16 SDA

5 TMDS data 1 11 TMDS clock 17 DDC/CEC

shield shield ground

6 TMDS data 1– 12 TMDS clock– 18 +5 V power

19 Hot plug

detect

*Not supported

4. Connect an HDMI output device to the output connector (c).

68-1317-50 Rev. B

02 12

Extron Headquarters

+1.800.633.9876 (Inside USA/Canada Only)

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.863.1794

+1.714.491.1517 FAX +1.919.863.1797 FAX

Extron Europe

+800.3987.6673

(Inside Europe Only)

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

(Inside Asia Only)

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+4000.398766

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

Inside India Only

+91-80-3055.3777

+91 80 3055 3737

FAX

5. Connect control devices: Connect your computer to one of

the following SW HDMI communication ports to conﬁgure and

control the switcher via SIS commands or the Universal Switcher

Control Program:

zRS-232 port — Connect the unterminated transmit,

receive, and ground wires of the RS-232 cable to the ﬁrst

three pins on the provided 5-pole captive screw plug, as

shown in the illustration at right. Connect the plug to the

rear panel Remote shared connector (don the rear panel

diagram on the previous page), and the other end of the

cable to your computer serial port. Protocol for the RS-232

port is 9600 baud, 8 data bits, 1 stop bit, no parity.

zCong port — USB mini-B connector (fon the front

panel diagram, below) for USB control.

6. (Optional) Enable auto-input switching. Use a jumper wire to connect pins 4 and 5

of the shared 5-pole captive screw plug. Attach the plug to the Remote

connector (don the rear panel diagram) if this was not done in

step 5for the RS-232 connection (see the illustrations at right).

7. If necessary, wire a 2-pole captive screw connector (provided) to your Extron power

supply as shown below.

Captive Screw Connector

Tie Wrap

Heat

Shrink 1/8”

(3 mm)

7/8”

(22 mm)

3/16”

(5 mm) Max.

CAUTIONS: • Thepowersupplymustnotbepermanentlyxedtothebuildingstructureorsimilarstructures.

•The power supply must not be located within environmental air handling spaces or the wall cavity.

8. Power on the output display.

9. Connect power to the switcher.

10. Power on the source devices.

Front Panel Features

SW4 HDMI

HDMI SWITCHER

CONFIG

SIGNAL

INPUTS

INPUTS OUTPUT

1 2 3 4

HDCP

2 3 4

AUTO

SWITCH

aAuto Switch LED cInput Selection buttons eHDCP Status LEDs

bIR receiver port dInput LEDs fUSB Conﬁg port

0.3A MAX

POWER

12V

Tx Rx

RS-232 AUTO

INPUTS

OUTPUT REMOTE

RS-232 Auto

Computer or

Contr

ol System

RS-232 Port

SW HDMI Series Switcher

Rear Panel

Remote Port

NOTE: If you use cable that has a drain

wire, tie the drain wire to ground

at both ends.

Tx Rx G

Ground (G)

Transmit (Tx)

Receive (Rx) Transmit (Tx)

Receive (Rx)

Andere Handbücher für SW HDMI Series

Inhaltsverzeichnis

Andere Extron electronics Schalten Handbücher

Extron electronics

Extron electronics SW HDMI LC Bedienungsanleitung

Extron electronics

Extron electronics USB HUB4 AAP Bedienungsanleitung

Extron electronics

Extron electronics SW4 ARxi Bedienungsanleitung

Extron electronics

Extron electronics USB HUB4 AAP Bedienungsanleitung

Extron electronics

Extron electronics SW12 VGA Ars Bedienungsanleitung

Extron electronics

Extron electronics YCS SW6 MX Bedienungsanleitung

Extron electronics

Extron electronics SW 4 AR MX HV Bedienungsanleitung

Extron electronics

Extron electronics IPL T SF24 Series Bedienungsanleitung

Extron electronics

Extron electronics USB HUB4 Series Bedienungsanleitung

Extron electronics

Extron electronics System 5 IP Series Bedienungsanleitung

Extron electronics

Extron electronics SW MTP T 15HD A Bedienungsanleitung

Extron electronics

Extron electronics USB HUB4 Series Bedienungsanleitung

Extron electronics

Extron electronics MLS 306 Bedienungsanleitung

Extron electronics

Extron electronics System 4LD xi Bedienungsanleitung

Extron electronics

Extron electronics SW2 VGAxi Bedienungsanleitung

Extron electronics

Extron electronics YCS SW2 A Bedienungsanleitung

Extron electronics

Extron electronics 650 UT Bedienungsanleitung

Extron electronics

Extron electronics CVEQ1 WM Bedienungsanleitung

Extron electronics

Extron electronics XTP T USW 103 4K Bedienungsanleitung

Extron electronics

Extron electronics MTPX Series Bedienungsanleitung

Extron electronics

Extron electronics MSW 4SV rs Bedienungsanleitung

Extron electronics

Extron electronics ISS 506 Series Bedienungsanleitung

Extron electronics

Extron electronics IN1508 Bedienungsanleitung

Extron electronics

Extron electronics SW2 USB Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung