Basic Tools Detail:
Item Description Factory
set
ID Code
If only one door station is installed in this building, set to
0;
If multi door stations are installed, primary door station
must be set to 0, and other slave door stations must
be set from 1 to 3. Note that max. 4 door stations are
available in one building
[0]
Single
Unlock Timing To set the time that how long the door keeps open when
door is released. Range from 01 to 99 seconds.
[01]
1 seconds
Unlock Output
To set the unlock mode to match the corresponding lock.
Range from 0 to 1.
0:Power-on-to-Unlock Mode(Normally Open Mode)
1:Power-off-to-Unlock Mode(Normally Closed Mode)
0
Monitor Timing To show the monitor time,Range from 6s to 600s 600s
Auto Call:
Doorplate Mode Range from 0 to 1. 0:after a complete input
the call codes, automatically dialing; 1:required to input
"#" to confirm dialing after input a complete call codes.
Building No.: 0~4 digit for the Building No., 0 means
without Building No. the door station will be only call to
local monitor.
Room No.: 2~4 digit for the Room No., at least 2 digit
for the Room No. to call.
Input No.: 2~8 maximum digit for input codes, at least
2 digit.
Call Mode: Reserve, always set it to 2.
[1]
Waiting Timing To show the calling wait time,Range from 6s to 600s 40s
Talking Timing To show the limitation time of talking, Range from 6s to
600s 90s
Installer Code ... To change door station administrator code [66666666]
Default ...
Note this operation is irreversible. Once restore is
activated, all parameters will return to factory default
setting except the information of access card.
Table 2(Installer Setup):
