MECHA IR Remote Commander and Receiver v.01
7
© 2021 FANOTEC
Menu Button
●=With C2 Controller, use this button to show the C2’s menus on the
display and also to switch from a menu to another.
Directional Buttons
●<> Use the left and right buttons to rotate the system manually to
the left and to the right, respectively, and also to specify the direction
when launching a preset using the IR Commander’s buttons, as
terminator for codes (similar to the Enter key).
●/\ The up and down buttons control the up and down movement of
the upper rotator, when two rotators are used.
Trigger Button
●SThe button located in the middle of the arrow buttons has a camera
trigger or confirmation function. During a pause, pressing Son IR
Remote, or [SHOOT] on UI, MECHA will trigger the number of shots
specified by [TRG] in presets. This can be used for extra shots for a
particular position.
Pause Button
●:Pause button is the equivalent of [Pause] UI button.
If MECHA is in Pause mode and a preset is started, MECHA will pause
before every position, resulting in step by step movement.
When MECHA runs a preset and is paused, you can press >, or :on
IR Remote, or [PAUSE/NEXT] on UI, to continue to the next position.
If, instead, <is pressed on C2 or on IR Remote, MECHA will continue to
the next position and switches on/off the step by step mode.
Numerical Buttons
●1Use it to enter the number 1. Use [Save 1] button in UI to save a
preset and assign it to this button.
