Standby / Off:
There are 2 ways to switch the device off: press and hold the volume control knob
more than 3 seconds to shift into standby mode, or switch off the soundbar
completely with the On/Off switch (10) on the rear panel.
Warnings:
Use Instructions
Do not modify the hardware or software of the device; this will void your warranty.
Use the soundbar in ambient temperatures between +5°C and +35°C.
Power Supply
The soundbar works with 12VDC power supply. Connect the supplied AC power
adaptor to a power outlet to power the soundbar. To avoid the risk of electric shock
disconnect the power adaptor from mains power supply before cleaning. Do not
connect the power adaptor in damp or dusty conditions. Always use the original
power adaptor for the soundbar.
Interference
Nearly all electric devices can cause interference if they are not specially shielded.
Under certain circumstances your soundbar can be affected.
Repairs
Turn to an authorized service center if you experience problems with the soundbar.
Do not try to repair the soundbar yourself; this can damage the soundbar and cause
personal injuries.
Disposal
At the end of its useful life dispose of the soundbar in environmentally correct
manner. Some countries have regulations for the disposal of waste electric and
electronic appliances. Please respect these regulations
Miscellaneous
Protect the soundbar from water and other liquids. If accidentally water is splashed
on the soundbar, please wipe it off immediately with a dry cloth. Electronic devices
are delicate. Avoid vibrations and impacts, especially during operation. Do not press
buttons too hard and avoid the vicinity of strong magnetic fields.
Protect the soundbar from water and other liquids. Do not try to repair the soundbar
and do not modify its design. You will forfeit your warranty claims and the soundbar
can be damaged. The device may show malfunctions during electrostatic discharge
and in strong magnetic fields. In this case disconnect from mains power supply and
reconnect after a few minutes. The device should be reset and again fully functional.
Homepage: http://www.fantec.de
Forum: http://www.fantec-forum.de
