Fanvil I30 Bedienungsanleitung

SIP Video Door Phone

Quick Installation Guide

i30 WWW.FANVIL.COM

Table of Contents

1. Package Contents ............................................................................... 4

2. Physical Specifications ....................................................................... 4

3. Installation ......................................................................................... 8

4. Searching Door Phone ..................................................................... 11

5. SIP Door Phone Setting .................................................................... 12

6. Door Unlocking Setting .................................................................... 14

1. Package Contents

2. Physical Specifications

Device size 160 x 93 x 35 mm

Weight 330g

1) Front Panel

Door Phone

Connectors

Quick Installation

Guide

RFID Cards

Screw and

Wrench

MIC

RFID Reader

Numeric Keyboard

DSS Key

Lock

Call & Ring

Network/SIP Registration

Speaker

Camera

Interface Description

Speaker

The door phone has a built-in speaker for convenient communication

and alert use.

MIC

The door phone has a built-in microphone hidden in the pinhole

located on the front panel.

RFID Reader Use RFID cards to unlock the door by touching RFID reader of device.

Button Definition

Button Description

DSS Key Press the button, to make a call or request to open the door.

Numeric Keyboard Input password to open the door or make a call.

LED Definition

LED Status Description

Lock

Steady blue Door unlocking

off Door locking

Call & Ring

Blinks per second Call holding or ringing

off On hook

Blinks every 3 seconds Device in the issuing state

Steady blue Online talking

Network & SIP

Registration

Blinks per second Network error

off Network is normal, SIP is not registered

Blinks every 3 seconds SIP Registration failed

Steady blue SIP Registration succeeded

2) Port Definition

After removing the Back Panel of i30, there are one terminal block connectors for power and lock control connection

as shown in the picture below.

JP1 Jumper

Power and lock

connector

Network port

Network Connector

Power and Electric-lock Connectors

1 2 3 4 5 6 7

+DC12V VSS NC COM NO S-IN S-OUT

12V DC Input Electric-lock switch Indoor switch

JP1 Jumper

There are two modes for power supply of electric-lock as shown in the picture below.

(The default is “Active Mode”).

Passive Mode: When the electric-lock starting current is more than 12V/700mA, i30 needs to use the external

drive mode, the electric lock interface with short circuit output control.

Active Mode : When the electric-lock starting current is less than 12V/700mA, i30 can use the internal drive

mode, the electric lock interface with 12V DC output.

Wiring instructions

NO: Normally open contact

COM: Relay contact

NC: Normally closed contact

Driving Mode Electric-lock Mode

JP1

Jumper

Connections

Active Passive

No electricity

when open

Electrify

when open

√ √

3. Installation

Main Part of Intercom Back Panel Wall-mounted Shell

Figure 1 Three Major Parts of i30

Step 1: Installation preparation

A. Check the following contents:

 Hex wrench x 1

 RJ45 plugs x 2 (1 spare)

 KA4 x 25mm screws x 4

 25mm screw anchors x4

B. Tools that may be required:

 Hex wrench

 Phillips screwdriver (Ph2 or Ph3), hammer, RJ45 crimper

 Electric impact drill with an 6mm drill bit

Step 2: Drilling

Figure 2 Wall Mounting

A. Place the mounting template with dimensions on the surface of a wall in a desired flat position.

B. Use an electric drill to drill the 4 holes marked on the mounting template. It is recommended to drill about

30mm deep. Remove the template when you finished drilling.

C. Push or hammer screw anchors into the drilled holes.

Step 3: Removing hanging shell

A. Remove the hanging shell as shown in Figure 3 and Figure 4.

Figure 3 Figure 4

B. With Phillips screwdriver, unpack the back panel and the main part of intercom as shown in Figure 5.

Figure 5

Step 4: Hanging shell fixing and cabling

Figure 6

A. Select the hole for cable supply; cable length of 15cm to 20cm is recommended.

B. With 4 KA4 x 25mm screws, tighten the wall-mounted shell as shown in Figure 6.

Step 5: Connection line

Figure 7 Figure 8

A. Select the hole for cable supply.

B. Connect the cables of RJ45, power, and electric-lock to the motherboard socket as mentioned in connectors

description (refer to Section 2).

C. Test whether there is electricity by doing the following:

Press the # button for 3 seconds to get the IP address of intercom by voice.

Input access password or press the indoor switch to check electric-lock installation.

Note: Do not proceed mounting until you have finished the electric checking.

Step 6: Mounting

Figure 9 Figure 10

A. Use the 4 screws to tighten the main part of intercom on the back panel as shown in Figure 9.

B. Push the device into the wall-mounted shell and tighten it with 1 screw as shown in Figure 10.

C. Make sure the screws have been tightened properly for better waterproof effect.

4. Searching Door Phone

There are two methods as shown below to search the i30.

Method 1:

Open the iDoorPhone Network Scanner. Press the Refresh button to search the i30 and find the IP address.

Method 2:

Press and hold the “#” key for 3 seconds and the door phone will report the IP address by voice.

Default Setting

Default DHCP Client On

Static IP Address 192.168.1.179

Default Web Port 80

Default Login User Name admin

Default Login Password admin

Display IP Address Hold # for 3 seconds to display by voice

Search Tools iDoorPhone Network Scanner

Andere Handbücher für i30

Inhaltsverzeichnis

Andere Fanvil Gegensprechanlage Handbücher

Fanvil

Fanvil i23 Bedienungsanleitung

Fanvil

Fanvil i16V Bedienungsanleitung

Fanvil

Fanvil i12-01 Bedienungsanleitung

Fanvil

Fanvil i31 Bedienungsanleitung

Fanvil

Fanvil i10 Bedienungsanleitung

Fanvil

Fanvil A10 Bedienungsanleitung

Fanvil

Fanvil i10 Bedienungsanleitung

Fanvil

Fanvil i20 Bedienungsanleitung

Fanvil

Fanvil I20-T Bedienungsanleitung

Fanvil

Fanvil A10 Bedienungsanleitung

Fanvil

Fanvil I20-T Bedienungsanleitung

Fanvil

Fanvil i66 Bedienungsanleitung

Fanvil

Fanvil i20S IP DoorPhone Bedienungsanleitung

Fanvil

Fanvil i23S Bedienungsanleitung

Fanvil

Fanvil i16S Bedienungsanleitung

Fanvil

Fanvil i30 Bedienungsanleitung

Fanvil

Fanvil i31S Bedienungsanleitung

Fanvil

Fanvil i12 Bedienungsanleitung

Fanvil

Fanvil i55A&i55A-Z Bedienungsanleitung

Fanvil

Fanvil i56A Bedienungsanleitung

Fanvil

Fanvil i10S Bedienungsanleitung

Fanvil

Fanvil i33V Bedienungsanleitung

Fanvil

Fanvil i12-02 Bedienungsanleitung

Fanvil

Fanvil i21 Bedienungsanleitung

Beliebte Gegensprechanlage Handbücher anderer Marken

Bticino

Bticino LINEA 3000 Bedienungsanleitung

MSI

MSI MSI-140 Bedienungsanleitung

golmar

golmar Stadio Plus Bedienungsanleitung

CyberData

CyberData 011211 series Handbuch

Vidos

Vidos duo M1021 Bedienungsanleitung

Vimar

Vimar ELVOX 7539/E Bedienungsanleitung

SSS Siedle

SSS Siedle BTSV 850-03 Bedienungsanleitung

Dahua

Dahua VTO Series Bedienungsanleitung

Elvox

Elvox 5651 Bedienungsanleitung

Videx

Videx VIDEOKIT Series Bedienungsanleitung

Safeguard Supply

Safeguard Supply LRA-EX1000 Bedienungsanleitung

SSS Siedle

SSS Siedle BFCV 850 Series Bedienungsanleitung

GRD

GRD MAX V2 Bedienungsanleitung

Alecto

Alecto ADI-250 Bedienungsanleitung

Aiphone

Aiphone IE-8MD Bedienungsanleitung

Perel

Perel EDB4 Bedienungsanleitung

Bticino

Bticino Classe 300 Bedienungsanleitung

LG L5142 Bedienungsanleitung