Faro FaroArm Quantum S Kurzanleitung
Connecting to the FaroArm Quantum S
Connecting
1. Download and install the FaroArm USB driver from the Faro website here (download instructions
also included):
https://knowledge.faro.com/Hardware/FaroArm_and_ScanArm/Gage/Driver_for_the_USB_FaroAr
m-ScanArm-Gage
On selecting the link for download, a new tab will open up where you can download your driver.
2. Make sure the FaroArm is plugged in and switched on.
3. Insert the FaroArm’s USB cable into the USB port of your computer.
4. First you will need to select the protocol to use. To do this, navigate to the ‘Tools’ tab and select
‘Configure’.
4.1. The following configuration box will open, and you will need to select the correct protocol. To
do this click the ‘select’ button.
The parameters button, as suggested, allows you to change some of the parameters associated
with the device i.e.: scan density etc
4.2. From the list, select ‘Faro Devices’, and then ‘OK’.
5. Finally, you need now just to connect to the machine.
5.1. If there is not a document open, from the ‘Tools’ tab, select ‘Connect’. This will connect your
computer to the machine using the protocol you have just selected.
5.2. If you have a document open, go into the ‘Tools’ tab, but this time select ‘Attach’. This
connects the machine to your open document using the protocol you have just selected.
6. You are now ready to enjoy your FaroArm
Selecting Probes
The correct probe must be selected before taking a measurement.
1. As before, navigate to the ‘Tools’ tab. Next select ‘Probes’.
2. Select either the iProbe (on left) or Scanner (on right) depending on what item you are
playing.
The pencil icon in the bottom left of each probe allows you to change some of the
parameters for that probe. This is especially useful for the scanner, where you can edit
the scan density.
2.1. If you get the following display it means you need to “wake-up” the FaroArm.
To do this simply rotate all 7 of its joints as shown in the picture below.
3. On activating the desired probe by clicking on it, close the probe selector box.
Taking Measurements
1. To take measurements, simply ‘play’ any item.
2. To manually probe a point or start a scan, press the green button.
2.1. To stop a scan, press the green button again.
3. To accept your measurement (scan or probed points), press the red button.
Troubleshooting
If connection is lost with the FaroArm, simply navigate to the ‘Tools’ tab and select ‘Connect’ (if you do
not have a document open) or ‘Attach’ (if you do have a document open).
Inhaltsverzeichnis
Andere Faro Robotik Handbücher
Beliebte Robotik Handbücher anderer Marken
STEMCenter USA
STEMCenter USA Pi-Bot v2.00 Bedienungsanleitung
SunFounder
SunFounder PiDog Bedienungsanleitung
Universal Robots
Universal Robots UR5 Bedienungsanleitung
Universal Robots
Universal Robots E Series Bedienungsanleitung
YASKAWA
YASKAWA MOTOMAN-MPL80 II Bedienungsanleitung
EFORT
EFORT ECR5 Gebrauchsanweisung
