It is recommended to find an object to slide under the base to lift it slightly. Once the simulator has
been lifted you can attach the rotation module, before sliding it into place make sure you attach the
cables. They should go through the hole showed in the picture. Use [P02] bolts on the side.
Step 1 – Place the rotation module in the slider as showed and connect the connectors, ensure
everything is tight and connected properly. The hole on the rotation module is quite small, it is to
ensure the cables will not get in the way for the actuators. (There is a hole for each cable on the
newest models).
Before assembling the rest of the simulator, it is recommended to place the rotation plate
where you intent to place it after assembling. Once you have found a good spot, place the
simulator base on the rotation plate and continue assembling.
Rotation Module
