FEB Easy 9314 Bedienungsanleitung
9314 - Flexì wireless button
1- Safety warning
Warning: Failure to follow the safety guidelines provided below could result in damage to your
Wireless Push Button or other property. Read all safety information below before using the Wireless
Button.
• Avoid high humidity or extreme temperatures;
• Avoid prolonged exposure to sunlight or intense UV light;
• Do not drop or do not subject the unit to strong vibrations;
• Do not disassemble or try to repair the unit;
• Do not bring into contact with ammable liquids, gases and other explosive substances.
2 - Welcome
We present your Wireless Button 9314.
This button is self-powered by a small piezoelectric circuit and allows you to control the actuators of
the FEB Easy series without ever having to worry about changing the batteries.
It is possible to use a single button to control more than one actuator and to use several buttons to
control the same actuator.
In this guide you will nd an overview of the product and instructions for installation and start-up.
3 – A detailed look at your device
Your wireless pushbutton 9314
Button: the part to press to send a signal
Flexì series snap ts: these are the snap ts that allow the button to be xed to a Flexì series
support
Key cover hooks: the button is supplied without key cover and these are the hooks to which
the Flexì series key cover of the color of your choice can be xed.
Button 9314 with key cover installed
4 - Installation
The FEB Easy 9314 button can be installed simply by snap tting it in a FEB Flexì support.
5 – Start up
To pair the pushbutton 9314 with a FEB Easy actuator, simply press the actuator pairing
button for about 3 seconds, until the LED indicator starts ashing, at this point press the
9314 button you want to pair. Just press once. You will see that the LED will stop ashing,
indicating that the two have been paired. It is possible to connect more than one button to
the same actuator, up to a maximum of 10 buttons. There are no limits, instead to the
number of actuators that can be controlled by the same button, simply repeat the pairing
procedure between the button and all the actuators that you want to be controlled by the
same button.
To reset a connection between the actuator and the buttons, press the actuator pairing
button for about 12 seconds. When the button is pressed, the LED indicator will rst begin to
ash, it will remain lit briey and then go off. When this sequence is complete and the LED is
off, the pairing button can be released and the actuator and all the buttons it was paired
with will be disconnected.
6 - Technical characteristics
Wireless network: RF 433MHz
IP rating: IP40
Operating distance: Indoor<= 25m / Outdoor <= 60 m
Operating temperature: -5 - 50°C
Dimensions: 22 x 44 x 34 mm
Inhaltsverzeichnis
Andere FEB Fernbedienung Handbücher
Beliebte Fernbedienung Handbücher anderer Marken
Panasonic
Panasonic EUR7622KB0 Bedienungsanleitung
Bang & Olufsen
Bang & Olufsen Beo4 Bedienungsanleitung
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Bedienungsanleitung
Multiplex
Multiplex PROFI TX 9 Bedienungsanleitung
One Remote
One Remote RMB4 Bedienungsanleitung
FUTABA
FUTABA 9ZAP - PART2 Bedienungsanleitung
