FeherGuard FG-AR Bedienungsanleitung

STEP 2: TUBE ASSEMBLY

STEP 1: SOLAR REEL PLACEMENT:

ASSEMBLY INSTRUCTIONS

AUTO REEL

Automatic Rollup

FG-AR

PLEASE READ ENTIRE INSTRUCTIONS CAREFULLY BEFORE PROCEEDING

REEL SYSTEMS COMPONENTS AND PREPARATION:

Getting started:

Ensure that your system has two cartons consisting of one end carton and

one tube set carton.

Tools required for assembly:

·Portable drill

·Tape measure

·Pencil and Scissors

Tube Carton Parts List:

2 end tubes and 1 center tube

AUTO REEL Parts List:

1 Bracket End

1 Handle

1 Bearing

2 Plugs for L16M, L18M & L20M Tubes

1 Water Discharge Hose

Hardware Kit: 10 Strap Plates

10 Straps

10 Plastic Screws

29 Self-drilling Metal Screws

Determine the best location for the reel system. The widest point of the pool is the preferred locations (see Fig. 1 below).

At the determined location, measure the width of the pool and add 6“ (15 cm).

Ensure minimum of each end tube is inside center tube (see table below right).

Less than minimum insert causes screws to loosen and/or tubes to split.

Insert both end tubes equal distance into center tube

and mark on center tube where inner tubes end

Fig. 2

Fig. 1

Recommended Solar Cover is 12 mil with round bubbles.

Allow an extra 4“ (10 cm) on cover length if installing the reel at mid-point or off-center.

Before starting assembly, trim cover so it does not touch the sides of your pool when rolling up.

Above-Ground

pools with deck

Insert Width Cover Cover

Tube Min. Max. Max. Wet Max.

Weight

L18M 9“ 18’6“ (5.7 m) 60# (27.3kg) 18x36

L20M 12“ 20’6“ (6.3 m) 60# (27.3kg) 20x40

L16M 9“ 16’6” (5.0 m) 60# (27.3kg) 16x32

Mill tubes tarnish over time. This does not affect tube integrity.

Four Easy Steps:

If you need additional assistance, contact us at [email protected] or call 905-876-4766 Monday to Friday 8:30 a.m. to 5:00 p.m. Eastern Time.

Recommend Safety Glasses

1 Auto End

Optional Locking Casters are available: Part Name FG-CK1

Lock tubes together by rotating the center tube in the opposite direction to end tube. HOLD TUBES LOCKED WHILE YOU

INSTALL FIRST SELF-DRILLING SCREW ON A DRILL LINE, 1“ (2.5 cm) back from end of center tube at Location ”C1”

(see Fig. 3 & 4).

Place 2 more self-drilling screws at Location “C2” & “C3” - 1 screw at every second drill line

around tubes (see Fig. 3).

At “D” locations install 3 screws around the center tube at every second drill line, 1“ (2.5 cm)

back from where you marked the end of the inner tube from Fig. 2A (see also Fig. 3).

Repeat for other end tube.

End tube End tube

Center tube

Drill lines DO NOT

line up when

tubes are locked

Tubes Must be in Locked Position

Drill Lines DO NOT line up when tubes are locked

THIS STEP REQUIRES A TOTAL OF 12 SELF-DRILLING SCREWS DO NOT pre-drill holes or over-tighten screws.

Fig. 3

Fig. 4

End Tube End Tube

Center Tube

Tube

Fig. 10

Strap

Square corner Radius corner

First strap is placed 6“ (15 cm) in from inside edge of pool or at start of radius corner.

Place system across widest point of pool or if radius corners are greater than 6”.

Pool

6“ (15 cm)

(Optional) FG-CK1

1. FG-PLG

Plug

Space all straps evenly between outside marks

Fig. 5

3. End

Bracket

4. FG-HANC

Handle

Insert Plug (#1) into End Tube.

Place Bearing (#2) inside End Bracket

Push Handle (#4) through Bearing and fully into Tube with Plug.

Insert 3 self-drilling screws (#5) through tube in line with bumps on plug

rim (at Long Prongs) and 1“ (2.5 cm) from tube end. (see Fig. 7).

2. FG-BEA005

Bearing

Attach remaining straps (Evenly Spaced) on a drill line with

metal screws (see Fig. 10).

or over-tighten screw.

Mark two outside strap location on tube DRILL LINES.

These two straps are placed 6“ (15 cm) in from inside edges

of pool or at the start of the radius corner (see Fig. 9).

Use all straps provided.

DO NOT pre-drill holes

STRAP ATTACHMENT - TO TUBE

Fig. 9

(Optional)

FG-CK1

STEP 3B: ASSEMBLE AUTO END

Push Water Discharge Hose onto right side of Auto End (Fig. 6)

Insert Plug (#1) into End Tube.

Push Tube with Plug fully onto Auto End shaft.

Insert 3 self-drilling screws (#5) through tube in line with a bumps

on plug rim (at Long Prongs) and 1“ (2.5 cm) from tube end. (Fig. 7)

IMPORTANT:

5. AUTO REEL END When

ends are assembled insert

3 screws through tube in

line with bumps on plug

rim (at long prongs), 1“

(2.5 cm) from tube end.

Insert

Screws

Fig. 7

AUTO END

Fig. 6

For Systems Placed at Pool End (RECTANGULAR Pools) (Fig.11)

Cover

(Bubbles

Down)

Fig. 11

Fig. 12

For Systems placed at Mid-Pool or Off Center (ROUND, OVAL or IRREGULARLY SHAPED Pools) (Fig. 12)

Strap end

Cover is

folded

“Pinched Fold”

(Bubbles In)

Strap end

Fold cover where system will be placed

(bubbles in). Pierce hole through both sides of

cover, 1“ (2.5 cm) back from the fold and

straight down (perpendicular) from a strap

already attached to tube. Push threaded plastic

screw through holes in cover then tighten

snugly into plate. Repeat for remaining straps.

Place straps evenly

along fold.

Pinched

Fold

Pierce hole through cover, 1“ (2.5 cm) back from

edge of cover and straight down (perpendicular)

from a strap already attached to tube. Push

threaded plastic screw through hole in cover

then tighten snugly into plate. Repeat for

remaining straps.

Choose either Fig. 11 OR Fig. 12 - the appropriate instructions below for your pool shape. If you have determined a mid-pool or

off-center placement, it may be easier if you move the cover away from the pool and fold it (Bubbles In) on a flat surface.

Strap Plate to Cover

STRAP ATTACHMENT - TO COVER

PLASTIC Screw

When you start to roll up the cover, all straps must take hold of the cover at the same time. Adjust the strap length at strap plate if necessary.

Water Discharge Hose

Screw

Drill Line)

Metal

Self-Drilling

(attach straps

along a

Strap end

Fig. 8

Attach this end

to Solar Cover

Strap

STEP 4: STRAP ATTACHMENT

Attach a Strap Plate (extras included)

to one end of all Straps provided

(see Fig. 7).

Attach this end

to Tube

Strap end

Strap Plate

(Side View)

BRACKET END

5. Insert 3 Screws, 1“ (2.5 cm) from

tube end (See Fig. 7)

Assemble in numerical order (see Fig. 5):

STEP 3A: ASSEMBLE BRACKET END

CARE AND STORAGE:

PLACING COVER ON POOL:

Move Reel System (with cover attached) across the pool to the exact location where you determined in Step 1.

(Optional Locking Casters (FG-CK1) are available.) *

IMPORTANT: Auto End Lever MUST be in the “REST” (Neutral) position - to the right.

Using handle at the Bracket End, unroll the cover 5 turns (releases any water pressure in Auto End) then “walk” cover

slowly on pool.

REMOVING COVER FROM POOL:

Attach your garden hose onto left side of Auto End (Fig. 13).

Turn on the water then move the Auto End Lever to the left - “REWIND”. The cover will roll up automatically.

Adjust cover if necessary.

IMPORTANT: When the cover is completely rolled, return Lever to “REST” (Neutral) position on the right.

Turn off water at tap. Failure to do so will void Warranty.

Disconnect Garden Hose from Auto End.

USING YOUR AUTO REEL

Hose

Discharge

Water

Garden Hose

attachment

AUTO END

In order to protect the warranty on your Solar Cover, it is essential to use a protective cover when it is rolled up on the

reel. In the summer use a Protective Sheet with UV inhibitors and in Winter, a Winter Jacket. If not provided, they can

be purchased from your pool retailer.

DO NOT ALLOW AUTO END TO FREEZE !

IF THERE IS A DANGER OF FREEZING TEMPERATURES, REMOVE AUTO END FROM SYSTEM, TURN TUBE SHAFT

AND ENSURE ALL WATER HAS DRAINED THEN STORE IN A LOCATION ABOVE FREEZING.

When re-assembling, check all screws and tighten, if necessary

in a pool partially covered by the solar cover.

FROM THE POOL BEFORE SWIMMING.

Under no circumstances, should one swim

SAFE USE OF YOUR SOLAR REEL:

COMPLETELY REMOVE REEL SYSTEM / COVER

Solar Reel systems are designed solely to remove solar covers

and are not made to support people or any other weight.

Fig. 13

* Other FeherGuard Accessories available through Pool Retailer:

FG-FASKIT Tube & Blanket Fastening Kit (10 sets tube & blanket fasteners & 10 - 26” straps / package)

FG-RS26 Reel Strapping (10 - 26” Straps / package)

FG-MPR Mid-Grip Pull Rope (helps pull Solar Blanket on to Pool - 35’ Rope, 2 clips, 2 plates, 2 fasteners / package)

FG-PFS Tube & Blanket Fasteners (10 sets / package)

FG-BPS Protective Sheet with UV Inhibitors (Wrap to protect solar blanket on the reel 24’ x 3 1/2’ / package)

FG-BS2X6 Blanket Straps (secures rolled up Solar Blanket on Reel - 2 x 54” straps with buckles / package)

FG-CK1 Package of 4 - 2" Locking Casters

FG-RS50 Reel Strapping (1 Roll 50’ Strapping / package)

*Quick-Connect recommended

(not supplied)

Thank you for buying the AUTO REEL System.

We know it will make solar cover handling easy for you.

FeherGuard “Three Year” Warranty Registration

Please Print

PURCHASER: ______________________________________________________________________________

ADDRESS: __________________________________________________________ CITY: _________________

STATE/PROVINCE/COUNTRY:

____________________________________ ZIP/POSTAL CODE: __________________________

___________________________________

________________________________ ______________________

MODEL # PURCHASE DATE

STORE LOCATION

Any implied warranties are limited in duration to the three-year period from the date of delivery to

the original consumer purchaser. Excluded from this warranty are all consumables (bearings,

straps, strap plates, screws). Tarnishing or discoloration of mill aluminum tubes can occur.

This is not a warranty issue as tarnishing does not affect tube performance.

Three Year Warranty:

FeherGuard at its option shall supply free of charge any part found to be defective in workmanship

or material.

This warranty is void if there is evidence of purchaser abuse, improper installation or normal wear.

Disassembling AUTO END may void warranty.

FeherGuard will not be liable for incidental or consequential damages resulting from any defects in

workmanship or material. Some States/Provinces/Countries do not allow the exclusion or limitation

of incidental or consequential damages, so the foregoing limitations or exclusions may not apply.

FeherGuard warrants for a period of three years from the date of delivery to the original consumer

purchaser, that the AUTO REEL System shall be free from defects in workmanship or material,

under normal use and in accordance with FeherGuard’s written installation and use instructions.

To validate Warranty, return this registration form within 30 days of purchase. You may also register

your warranty online on our Home Page at www.feherguard.com.

Warranty claims should be processed through your Dealer and include your proof of purchase.

This Warranty gives the claimant specific legal rights. The provisions of this Warranty are in

addition to and not a modification of or a subtraction from the statutory warranties and other rights

and remedies contained in applicable local legislation.

AUTO REEL

FeherGuard Products Ltd.

Milton, Ontario CANADA

Specifications subject to change without notice. 04 21

04 21

Andere FeherGuard Beleuchtungsausrüstung Handbücher

FeherGuard

FeherGuard Surface Rider Bedienungsanleitung

FeherGuard

FeherGuard PREMIUM Bedienungsanleitung

FeherGuard

FeherGuard FG3 Bedienungsanleitung

FeherGuard

FeherGuard Wheels Reel Bedienungsanleitung

FeherGuard

FeherGuard PREMIUM Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung