Fender Reflecting Pool Bedienungsanleitung

REFLECTING POOL

LEDs

9V DC

INPUT

BYPASS

REFLECTING POOL

TYPE

EXTRA RATE DEPTH TYPE SUBD QUALITYVARIATION

REVERB DELAY

DELAYTAPREVERB

MIXLEVELDAMP TIME FEEDBACK LEVELDECAY

L/MONO

IN OUT

R L/MONO R

TAP

USB

6 7

3 4 5 8 9 10 11

2523222120 24

26 27

1. Reverb Footswitch & LED

2. Extra

3. Decay

4. Damp

5. Level (Reverb)

6. Reverb Type Switch

7. Variation Switch

8. Time

9. Feedback

10. Mix

11. Level (Delay)

12. Rate

13. Rate LED Indicator

14. Depth

15. Delay Type Switch

16. Subdivision Switch

17. Quality Switch

18. Delay Footswitch & LED

19. Delay Tap Tempo Footswitch & LED

Delay Controls Rear Panel ControlsReverb Controls

20. L/Mono Input Jack

21. Right Input Jack

22. L/Mono Output Jack

23. Right Output Jack

24. Tap Footswitch Jack

25. USB Jack

26. Bypass Mode Switch

27. LED Kill Switch

28. DC Power Connector

12 13 14 15 16 17

Thanks for purchasing the Reﬂecting Pool delay-reverb pedal. This highly

sophisticated digital effect uses advanced DSP technology to create lush

and complex time-based effects. Featuring independently switchable

delay and reverb, dedicated tap tempo footswitch, stereo I/O and a wide

selection of different algorithms and variations — including modulation,

shimmer, gated, and reverse sounds.

REFLECTING POOL

DESIGNED IN CALIFORNIA, U.S.A.

Reverb Bypass Footswitch & LED

Footswitch bypasses reverb effect. LED Illuminates when reverb is active.

Decay

This control adjusts the reverb decay time, or length of the reverb signal.

Counterclockwise settings produce smaller room and ambient sounds, while

settings closer to fully clockwise can produce the sound of huge spaces.

Damp

Attenuates high frequencies and “darkens” reverb tail.

Level (Reverb)

Controls “wet/dry” reverb signal mix.

Reverb

Type Switch

HALL

1: small hall

2: medium hall

3: large hall

1: small room

2: medium room

3: large room

1: Shimmer

2: Gated/

Reverse

3: Modulated

ROOM

SPECIAL

Variation

Switch

Description

Classic diffuse space with a

sense that walls are far apart.

Smaller, more lively feel

than HALL.

Very large space with some pitch

modulation. Ideal for ambient pads and

swells.

Small-space reverb, plus gated and

reverse reverb. Set EXTRA and LEVEL

control knobs at full clockwise position

for “full-wet” reverse effect.

Classic modern reverb effect with

octave-up pitch shift in loop between

reverb input and output. Successive

octaves are added as reverb decays,

imparting a blooming, atmospheric effect.

Controls amount of regeneration into octave-up reverb effect,

which determines how much of the octave is heard and how

much octaves will “stack.”

Controls reverb tail shape. At full counterclockwise, shape is a

typicaldecaying taper. At noon produces a gated shape; at full

clockwise produces reverse reverb.

Controls reverb modulation depth

(modulation rate ﬁxed at 0.1 Hz).

Controls amount of low-frequency rolloff in reverb decay. Turn

EXTRA knob counter-clockwise for more bass in reverb tail;

clockwise for less (similar to a bass cut).

“Extra” Knob Function

Extra

Modiﬁes an “extra” algorithm-speciﬁc parameter. On “Hall” and

“Room”reverb settings it controls “tilt” between high and low

frequency decay times. On Special “Shimmer” setting (see

“Variation Switch” below) it controls regeneration of cascading octaves.

On Special “Gated/Reverse” setting (see “Variation Switch” below) it

controls reverb tail shape, and on Special “Modulated” setting it controls

modulation depth.

Type Switch

Toggle among Hall, Room and Special reverb types

Variation Switch

Toggles among three different variations for each reverb type:

REVERB CONTROLS

Delay Bypass Footswitch & LED

Footswitch bypasses delay effect. LED Illuminates when delay is active.

Delay Tap Tempo Footswitch & LED

Set delay time by tapping two or more times at desired rate. LED ﬂashes in

sync with delay time.

Time

Turn Time control knob to set delay time from 10ms to 1 second. To select

various rhythmic subdivisions, press and hold Tap footswitch while turning

Time control knob. Select rhythmic subdivisions including (clockwise): 16th

note, dotted 16th note, 8th note, 8th note (triplet), dotted 8th note, quarter

note, half note. After selection, release Tap footswitch.

Feedback

Controls number of delay repeats.

Mix

Controls blend between main delay and secondary delay tap deﬁned by

SUBD toggle switch (see “SUBD Switch” below). At minimum setting, main

delay only is heard. Secondary delay tap becomes increasingly audible as

knob is turned. At maximum setting, secondary delay tap only is heard.

Level (Delay)

Controls “wet/dry” delay signal mix.

Rate

Controls modulation speed.

Rate LED

Flashes in time with modulation speed.

Depth

Controls modulation depth.

Type Switch

Toggle among Digital, Analog or Tape delay types.

Subdivision Switch

Enables selection of rhythmic subdivision for second delay tap (secondary

delay time is a subdivision of main delay time). Rhythmic subdivision values

are: 50% (8th note relative to quarter note), 66% (quarter note triplet

relative to quarter note) and 75% (dotted 8th note relative to quarter note).

Quality Switch

Enables selection of 3 distinct delay repeat types (useful as progressive

reduction in delay repeat quality).

Delay Type Switch

DIGITAL

1: Crystal-clean delay.

2: Some audible signal degradation similar to lo-ﬁ digital hardware.

3: Grunge with less high end and the sound of old-school signal processors.

1: Softer repeats and less highs and lows than digital.

2: Less ﬁdelity and slightly more distortion than NOS mode.

3: The highest amount of bass and treble cut, the most distortion, and

even some artifacts from the bucket-brigade sampling process.

1: The sound of a 15 ips studio tape echo unit.

2: Lower degree of ﬁdelity and higher degree of tape saturation

than NOS mode.

3: Even lower degree of ﬁdelity and higher degree of tape saturation than NOS

and classic modes. Use DEPTH and RATE control knobs (especially with RATE

at full clockwise) for realistic wow and ﬂutter of old tape.

ANALOG

TAPE

ECHO

Variation SwitchDescription

Authentic digital delay emulation with three

modes available via the Quality switch.

Analog (bucket brigade) delay emulation with

three modes available via the Quality switch.

Authentic tape-echo emulation with three

modes available via the Quality switch:

DELAY CONTROLS

REAR PANEL CONTROLS

Left Input Jack

High-impedance input suitable for electric guitar, bass, acoustic guitars with pickup systems, keyboards and other instruments.

Right Input Jack

High-impedance input suitable for electric guitar, bass, acoustic guitars with pickup systems, keyboards and other instruments.

Left Output Jack

Low-impedance output jack connects to amp or to next effect pedal in signal chain.

Right Output Jack

Low-impedance output jack connects to amp or to next effect pedal in signal chain.

Tap Footswitch Jack

For connecting a momentary footswitch to set tap tempo remotely.

DC Power Connector

Standard center-negative 9VDC jack for use with appropriate power supplies.

Bypass Type Switch

Enables selection of “Trails” (DSP bypass) or relay-based “True” bypass.

LEDs Switch

Turns control-knob illumination on and off.

USB Port

Connection point for ﬁrmware updates (when available).

A PRODUCT OF:

FENDER MUSICAL INSTRUMENTS CORPORATION

CORONA, CALIFORNIA, USA

Fender® is a registered trademark of FMIC.

P/N 7717100000 - REV 2

Important Safety Instructions

•WARNING: To prevent damage, ﬁre or shock hazard, do not expose the unit or its AC

power to rain or moisture.

•Do not alter the AC plug of the connected power adapter

•Do not drip or splash liquids on the unit.

•No user serviceable parts inside, refer servicing to qualiﬁed personnel only.

• WARNING: The unit must only be connected to a safety agency certiﬁed, regulated,

power source (adapter), approved for use and compliant with applicable local and

national regulatory safety requirements.

• Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth

for cleaning and then wait until the unit is completely dry before reconnecting it to power.

• Ampliﬁers and loudspeaker systems, and ear/headphones (if equipped) are capable

of producing very high sound pressure levels which may cause temporary or permanent

hearing damage. Use care when setting and adjusting volume levels during use.

Additional Languages

Manual available in additional languages at:

www.fender.com/support

Product speciﬁcations subject to change without notice

Speciﬁcations

IMPEDANCES:

POWER SUPPLY:

POWER REQUIREMENTS:

DIMENSIONS:

WEIGHT:

INPUT: 1MΩ OUTPUT: 600Ω

9VDC regulated adapter,

5.5 x 2.1 mm barrel connector, center negative

250mA @ 9VDC

6.7” x 4.9” x 2.5” (170mm x 124.5mm x 63.5mm)

1.5lbs (.68kg)

THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO

THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL

INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,

INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

NOTES:

Inhaltsverzeichnis

Andere Fender Musikpedal Handbücher

Fender

Fender HAMMERTONE FLANGER Bedienungsanleitung

Fender

Fender TREAD-LIGHT 0234555000 Bedienungsanleitung

Fender

Fender Pinwheel Bedienungsanleitung

Fender

Fender TRE-VERB Bedienungsanleitung

Fender

Fender MTG: LA Bedienungsanleitung

Fender

Fender THE TRAPPER Bedienungsanleitung

Fender

Fender ACOUSTIC PREVERB Bedienungsanleitung

Fender

Fender HAMMERTONE OVERDRIVE Bedienungsanleitung

Fender

Fender MTG Bedienungsanleitung

Fender

Fender COMPUGILIST Bedienungsanleitung

Fender

Fender MUSTANG FLOOR Bedienungsanleitung

Fender

Fender EXP-1 Bedienungsanleitung

Fender

Fender MUSTANG FLOOR Bedienungsanleitung

Fender

Fender Smolder Acoustic Overdrive Bedienungsanleitung

Fender

Fender DUEL PUGILIST DISTORTION Bedienungsanleitung

Fender

Fender HAMMERTONE FUZZ Bedienungsanleitung

Fender

Fender Blender Custom Bedienungsanleitung

Fender

Fender MUSTANG FLOOR Bedienungsanleitung

Fender

Fender Bubbler Chorus Bedienungsanleitung

Fender

Fender PT-100 023-9994-000 Bedienungsanleitung

Fender

Fender TREAD-LIGHT VOL/EXP PEDAL Bedienungsanleitung

Fender

Fender HAMMERTONE REVERB Bedienungsanleitung

Fender

Fender WAYLON JENNINGS PHASER Bedienungsanleitung

Fender

Fender HAMMERTONE DISTORTION Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung