SETTING UP THE POPNETSERVER 2000
FIA POPnetserver 2000 User’s Guide
Chapter 2: Setting up the POPnetserver 2000
The POPnetserver 2000 was specifically designed to allow for quick and
easy setup. Even those with minimal technical expertise can be up and
running in a matter of minutes.
What you Need
Before you begin, make sure you have all the following minimum
requirements:
•Client system with an Ethernet card installed.
•Management console system running Microsoft Windows
95, 98, Me, NT 4.0 or 2000, or Microsoft Internet Explorer
version 5.0 or later web browser.
•If you plan to use the POPnetserver on a network, there
must be a network hub with an available port.
If You Don't have a Network
If your primary system isn’t part of a network, you can still attach the
POPnetserver to it. You will need an Ethernet card in your computer
system, the appropriate network drivers installed and either a standard
network hub or crossover cable.
The gray category 5 (CAT 5) cable included with your POPnetserver
should only be used with a network hub. If you do not have a hub, you
may connect the POPnetserver directly to your primary computer system
with the red network crossover cable included with your POPnetserver.
