WARNING
The equipment described in this manual is capable of causing property
damage, severe injury, or death. It is the responsibility of the owner or operator
to ensure that the equipment described is installed, operated and commissioned in
compliance with the manufacturer’s instructions and all applicable codes and regulations.
When this equipment is tted to an appliance, due regard must also be given to the requirements of that
appliance.
Before attempting to install, commission, or operate this equipment, all relevant sections of this document must
be read and fully understood. If in doubt about any requirements consult your supplier.
Installation, commissioning or adjustment of this product MUST be carried out by suitably trained engineers or
personnel qualied by training and experience.
The manufacturer of this equipment accepts no liability for any consequences resulting from inappropriate,
negligent or incorrect installation, commissioning or adjustment of operating parameters of the equipment.
Before attempting any work on this equipment or any equipment controlled by or connected to this equipment, all
related electrical supplies or batteries MUST be isolated.
DO NOT energize or use the device, unless the area is known to be non-hazardous and free of explosive gases.
These paragraphs indicate a risk of potential serious personal injury, unless these instructions are followed
carefully.
This device and its accessories are designed to operate in extreme environments and temperatures.
Do not attempt to work on this device until it has reached a safe handling temperature.
Do not operate a device that has damaged threads, components or one that has been disassembled.
Explosion hazard. Do not disassemble, connect or disconnect when energized.
The High Energy Portable Igniter (or any part thereof) is not intended for climbing or standing on.
Electromagnetic interference may occur during the ignition period.
Compliance with the permissible ambient temperatures must be checked.
During ignition, 2000 VDC is applied to the ignition electrode. There is a danger to life if touched!
The portable High Energy Igniter may only be operated with the spark tip inside the combustion chamber, with the
lid of the ignition unit closed, undamaged components, and a complete ignition electrode installed.
The portable High Energy Igniter requires at least 120 seconds for a complete discharge.
Opening the unit or touching any of the internal components during this discharging may result in elec-
trick shock or injury.
!
