Thank you for purchasing a FIRMAN product. This manual contains safety information to make
you aware of the hazards and risk associated with this product and how to avoid them. It is
important that you read and understand these instructions thoroughly before attempting to
use this product. Save this manual for future reference.
All information in this publication is based on the latest production information available at the
time of approval of printing. The manufacture reserves the right of change, alter or otherwise
improve this product and this documentation at any time without prior notice.
ELECTRICAL RATING
12/3 SJTW 125V 15 AMP 1875 W
01
This product has a 3 prong polarized input power cord plug. Never attempt to bypass this safety
feature by removing the ground pin. This plug will fit into a grounded outlet only one way. If the
plug does not fit into the outlet fully, contact a qualified electrician. Never use with a two wire
extension cord.
OPERATION
MOUNTING INSTRUCTIONS
Mounts to wall or ceiling or easily remove cord reel from bracket for portable use.
1. Select a mounting location within 2 feet (0.6M) of a properly grounded electrical outlet. The
outlet for a garage door opener is ideal.
2. Drywall will not hold the weight of the cord reel. It is necessary to locate a ceiling joist or wall stud.
3. Press button located on the center of the mounting bracket to separate the two pieces.
6. Insert one side of the cord reel into the mounted bracket and support the weight while sliding
the second half of the mounting bracket into place until it locks, securing the cord reel.
WARNING! Handling the cord on this product will expose you to lead and lead compounds, a
chemical known to the State of California to cause cancer, and birth defects or other reproductive
harm. Wash hands after handling. For more information, go to www.P65Warnings.ca.gov.
1. Check cord operation by slowly pulling out cable. A "clicking" noise will be heard every half
revolution.
2. To latch the cord reel, pull out the cable and allow it to retract after hearing two or three clicks.
3. To unlatch the cord, slowly pull out the cable and after two or three clicks allow it to slowly
retract until the stopper rests against the cable guide.
4. Extend cord fully prior to each use.
5. Plug into a 120V/60Hz grounded outlet. The LED light, in the triple tap, indicates power to the
cord.
6. When reel is not in use, retract cord and store indoors.
7. If cord reel is overloaded, the thermal circuit breaker will automatically open. Remove any
devices plugged into the cord and push the reset button on the cord reel housing to restore
power. Once power is restored the triple tap light will turn on.
4. Using the separate installation template provided or the longer mounting bracket half, mark the
four mounting screw locations. Make sure the marked screw locations are centered on ceiling joist
or wall stud selected.
5. Line up the mounting bracket holes over the marked screw locations and secure long mounting
bracket half to ceiling joist or wall stud using suitable screws .
7. If cable stopper adjustment is desired, pull cable from reel and allow the cord to latch at the
desired length. Loosen stopper screw and slide stopper to desired position. Tighten stopper screw.
Register your product using the QR code provided or at
www.firmanpowerequipment.com .
REGISTER YOUR PRODUCT
