WALL-MOUNTED ELECT IC FI EPLACE/HEATE
BFM EUROPE LTD Page 2
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION AND/OR
USE OF THIS ELECTRIC FIRE AND RETAIN FOR FUTURE REFERENCE.
WHEN USING ELECT ICAL APPLIANCE, BASIC P ECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO EDUCE THE ISK OF FI E, ELECT IC SHOCK AND INJU Y TO PE SONS,
INCLUDING THE FOLLOWING IMPO TANT SAFETY ADVICE.
EAD ALL INST UCTIONS BEFO E USING THIS APPLIANCE.
egarding installation of the appliance;
· This appliance is supplied with a rewira le plug fitted with
a 13A fuse. Should the fuse or plug need replacing, and
you are competent to do so, it must e replaced with a
13A fuse and the plug muse e a 13amp BS1363A
approved fitted with a 13A fuse.
· Connect this appliance to single-phase AC supply of the
voltage specified on the rating plate.
· This heater must e earthed. If in any dou t consult a
suita le competent person.
· Ensure that the plug socket-outlet connection for this appliance is accessi le.
It MUST e readily accessi le for easy electrical isolation in the event of servicing and replacing
components etc.
· This appliance MUST NOT e located immediately elow an electrical socket-outlet.
· Avoid the use of an extension cord as this may overheat and cause a risk of fire.
· Running this appliance on heat setting 2 (1800W) with another piece of electrical equipment on the
same circuit may cause the fuse of this appliance to low, or your circuit reaker to turn off the power
supply. If this occurs reconnect one of the appliances to another circuit.
· This appliance is fitted with an automatic thermal cut out to reduce the risk of damage in the event of
a normal operation e.g. when covered. If the heater stops operating whilst the flame effect continues
normally this indicates that the cut out is in operation. If this occurs disconnect the power supply at the
plug socket-outlet and ensure that any o structions to the fan heater outlet or fan lades etc. are
removed. The heater will automatically reset when cool enough. The thermal cut out WILL NOT
ESET unless the o struction is removed and the appliance cools. If the heater is still not operating
after 10 minutes disconnect the appliance and seek expert advice.
· If the supply cord is damaged it must e replaced y the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard. The ca le used MUST e capa le of handling 2.5kW of
power at 240V and MUST contain an earth wire.
· To completely shut this appliance off turn all the controls to OFF and remove the plug from the socket-
outlet.
· Use the heater in a well-ventilated area.
egarding persons operating the appliance;
· This appliance is not intended for use y persons (including children) with reduced physical, sensory or
learning disa ilities, or lack of experience and knowledge, unless given supervision or instruction
concerning use of the appliance y a person responsi le for their safety.
· Children should e supervised at all times to ensure that they do not play with the appliance.
· Extreme caution is necessary when any heater is used y or near children, invalids or elderly persons
and whenever the heater is left operating and unattended.
IMPO TANT INST UCTIONS
