Area of application
The flexyPage displays were designed for use in lifts. They can be installed in new
constructed buildings and in context of modernisation measures for lifts of all manufacturers.
The displays can be used in both the lift’s cabin and on the landings.
The flexyPage LT-Line display is an open-frame display for back-wall mounting into indicator
boards and panels. It is available in different sizes, resolutions and optionally with a touch
sensor. Please find the requirements concerning power supply and environmental conditions
attached.
Safety instructions and restrictions
Precisely follow this document’s instructions, as well as the ones you will find on
the device. An exclamation mark inside a warning triangle points out that
warnings and hints are available, whose disregard may lead to danger or material
damage.
The flash with an arrow leads your attention to dangerous voltage. Disregarding
this warning can be life-endangering.
Installation and setup is limited to professionals after having read the whole product
documentation!
Restoration of damaged assemblies is only permitted for the ELFIN support. An autonomous
opening of the housing may damage the device which automatically leads to the loss of the
warranty claim. If the device is already damaged when delivered, do not connect it to the
power supply and contact the ELFIN support!
Do not use any caustic cleaning material and avoid installing sharp devices to the glass.
Heat accumulation may cause an overheating of the flexyPage monitor controller and
displays, which may lead to damages. The internal electricity is cooled passively using the
housing. If this includes louvers, ensure that these are always unobstructed, so that a
sufficient air circulation is provided. Wetness and liquids can also cause bypasses or
electrical shocks. Therefore, only make use of and connect the device inside a building.
Ensure that liquids and carrying elements do not come in touch with the device.
© ELFIN GmbH technology flexyPage.de 6
