8
INSTALLATION
INSTALLING MODULE
1. Remove the display electronics from the front of the turbine.
NOTE: If you are installing more than one module at a time, take care to keep the
proper electronics paired with the original turbine.
2. If your display currently has batteries installed, you will need to remove them to
enable the scaled pulse output to function.
3. Disconnect 2-pin coil connector from display. Make sure coil remains firmly attached to
meter body (DO NOT pull on wires or attempt to remove from meter body).
4. Connect the module to the 10-pin connector located on the backside of the computer
electronics (see Figure 2).
5. Reconnect the coil connector to the 2-pin terminal block on the other end of the
computer backside. Once the cables are installed on the display, the housing of the
display can be placed on top of the module (see Figure 2).
6. Install the computer electronics to the front side of the turbine. Tighten the four screws
snugly.
Module shown installed on G2 1” stainless steel flowmeter
Figure 2
