FlowCon S-JUST Betriebsanleitung

Installation and Operation Instruction

FlowCon S-JUST

Setting Kv (m3/hr) Cv (GPM)

1.0 0.00 0.00

1.1 0.14 0.16

1.2 0.29 0.34

1.3 0.43 0.50

1.4 0.57 0.66

1.5 0.72 0.84

1.6 0.86 1.0

1.7 1.0 1.2

1.8 1.1 1.3

1.9 1.3 1.5

2.0 1.4 1.6

2.1 1.6 1.9

2.2 1.7 2.0

2.3 1.9 2.2

2.4 2.0 2.3

2.5 2.2 2.6

2.6 2.3 2.7

2.7 2.4 2.8

2.8 2.6 3.0

2.9 2.7 3.1

3.0 2.9 3.4

3.1 3.0 3.5

3.2 3.2 3.7

3.3 3.3 3.8

3.4 3.4 3.9

3.5 3.6 4.2

3.6 3.7 4.3

3.7 3.9 4.5

3.8 4.0 4.6

3.9 4.2 4.9

4.0 4.3 5.0

4.1 4.5 5.2

4.2 4.6 5.3

4.3 4.7 5.5

4.4 4.9 5.7

4.5 5.0 5.8

4.6 5.2 6.0

4.7 5.3 6.1

4.8 5.5 6.4

4.9 5.6 6.5

5.0 5.7 6.6

The FlowCon S-JUST insert is used with

FlowCon AB valve housings DN15-25 (1/2”-1”):

Insert Setting and Installation

Prior to installing the FlowCon S-JUST insert

(supplied from factory in setting 1.8) in the valve

housing, the system should be properly flushed.

Blank valve covers are available to be installed

during flushing.

It is recommended to grease the O-rings located

around the S-JUST with silicone grease before

installing the insert in the valve housing.

The desired Kv is set by adjusting the insert with

a special adjustment key. Scale setting is located

on the ‘neck’ of the insert where the white digits

printed on black, numbered 1 to 5, indicate full

turns and the top white digits printed on the red

counter wheel, numbered 0 to 9, indicate 1/10

of full turn.

Kv setting may be done either before or after

the insert is installed in the valve housing and

based on measured differential pressure on the

p/t plugs and Kv setting, flow is calculated:

Q (m

/hr) = Kv * √ΔP(kPaD) *100

FlowCon S-JUST

1B95097 - 03/2021

This paper is a supplement to the FlowCon General Instruction

Latest release of any FlowCon material is available on www.owcon.com

Page 1 of 2

Figure 1

General Assembly Drawing

FlowCon S-JUST

A: Valve housing

B: S-JUST insert

C: Adjustment key

D1: P/t plug (2 pcs.)

D2: T-piece (1 pc)

This paper is a supplement to the FlowCon General Instruction

Latest release of any FlowCon material is available on www.owcon.com

FlowCon S-JUST

1B95097 - 03/2021

Page 2 of 2

FlowCon International assumes no responsibility for mistakes, if any, in any printed material.

Inhaltsverzeichnis

Andere FlowCon Steuereinheit Handbücher

FlowCon

FlowCon ABM Betriebsanleitung

FlowCon

FlowCon Green.3 Series Betriebsanleitung

FlowCon

FlowCon AHU Wafer Betriebsanleitung

FlowCon

FlowCon DPCV Betriebsanleitung

FlowCon

FlowCon SM 50-250mm Betriebsanleitung

FlowCon

FlowCon EVS Bedienungsanleitung

FlowCon

FlowCon UniQ Betriebsanleitung

FlowCon

FlowCon SM.3.0 Bedienungsanleitung

FlowCon

FlowCon PIM-DP Bedienungsanleitung

FlowCon

FlowCon SM.1.1 Betriebsanleitung

FlowCon

FlowCon SH series Betriebsanleitung

FlowCon

FlowCon Green Betriebsanleitung

FlowCon

FlowCon Green.3 DN40 Betriebsanleitung

FlowCon

FlowCon FlowCon Green Series Betriebsanleitung

FlowCon

FlowCon Green Betriebsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung