3
SAFETY
8. Always switch off at the mains before
disconnecting any plug, cable connector or
extension cable.
9. Switch off, remove plug from mains and
examine electric supply cable for damage
or ageing before winding cable for storage.
Do not repair a damaged cable, replace it
with a new one. Use only Flymo
replacement cable.
10. Always wind cable carefully, avoiding
kinking.
11. Never pull on the cable to disconnect any of
the plugs.
12. Use only on AC mains supply voltage
shown on the product rating label.
13. Flymo products are double insulated to
EN60335. Under no circumstances should
an earth be connected to any part of the
product.
Preparation
1. Always wear suitable clothing, gloves, and
stout shoes. The use of eye protection is
recommended. Do not wear loose clothing
or jewellery which can be caught in moving
parts.
2. Thoroughly inspect the area where the
Power Hoe is to be used and remove all
wires and other foreign objects.
3. Before using always visually inspect to see
that the tine is not worn or damaged.
Use
AVOID ACCIDENTAL STARTING. WHEN
CLEARING DEBRIS FROM THE TINE AREA,
REMOVE PLUG FROM MAINS AND KEEP
FEET AWAY FROM THE SWITCH LEVER.
1. Use the Power Hoe only in daylight or good
artificial light.
2. Ensure that shoe laces are tied correctly
and are kept clear of the rotating tine.
3. Do not use the Power Hoe when it is raining
or in damp and wet areas.
4. Never use the Power Hoe in or near water
or ponds.
5. Take extra care when working near shrubs
and bushes to prevent the tine becoming
entangled.
6. Know how to stop the Power Hoe quickly in
an emergency.
7. On slopes, be extra careful of your footing
and wear non-slip footwear.
8. Always start the Power Hoe carefully with
feet well away from the tine.
9. Never pick up or carry the Power Hoe by
the cable.
10. Keep the tine below waist level.
11. Avoid operating while people, especially
children, are nearby.
12. Keep cable away from tine at all times. If
cable becomes entangled, remove plug
from mains and carefully inspect cable for
damage. If in doubt, contact your local
Dealer.
13. Remove the plug from the mains :-
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be
sure the Power Hoe is in safe working
condition.
2. Replace worn or damaged parts for safety.
3. Be careful during adjustment of the Power
Hoe to prevent entrapment of the fingers
between moving and fixed parts of the
machine.
4. After use the Power Hoe should be stored
in a safe place where it is protected from
damage.
- before leaving the Power Hoe
unattended for any period;
- before clearing a blockage;
- before checking, cleaning or working
on the appliance;
- if you hit an object. Do not use the
Power Hoe until you are sure that the
entire Power Hoe is in a safe operating
condition;
- if the Power Hoe starts to vibrate
abnormally. Check immediately.
Excessive vibration can cause injury.
