FMI C32GO Gebrauchsanweisung
For more information, visit www.fmiproducts.com
C32GO Corner Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
IMPORTANT: Read entire instruction sheet be-
fore assembling or installing mantel kit.
These mantels are only approved for use with
any FMI PRODUCTS, LLC 32'' electric and gas
replace systems. Do not use mantel with any
other product.
• Thismantelkitcontainsthefollowing:
#1Base
#2RightSideAssembly
#3LeftSideAssembly
#4Header
#5Top
#6TopTriangle
#7TopLeftSupport
#8TopRightSupport
#9TopCenterSupport
#10BaseSupport
#11VerticalSupport
RightTopTrimStrip
LeftTopTrimStrip
• HardwarePackage
36-11/4"WoodScrews114325-01
8-1"FinishingNails114295-04
4-2"WoodScrews122447-01
*Extrahardwaremaybeincluded
Toolsrequired:
• PowerScrewdriverwith#2PhillipsBit
• Hammer
• NailSet
Ifanywoodpiecesaremissingordamaged,contactthedealer
whereyoupurchasedthismantelforreplacement.Ifhardware
is missing or damaged, contact FMI PRODUCTS, LLC at
1-866-328-4537 for referral information. You can also visit
FMIPRODUCTS,LLC’swebsiteatwww.fmiproducts.com.
Note: Gather all mantel pieces together before assembling
mantel.
WARNING: Only use 1 1/4" screws to as-
semble mantel. Damage to mantel will result if
other screws are used for this purpose.
www.fmiproducts.com 123755-01B
2
ASSEMBLING MANTEL
IMPORTANT: More than one person is required
to lift assembled mantel. Lift mantel by leg
assemblies. Lifting by header or mantel top
could damage mantel.
Usethefollowingillustrationstoassemblemantel.Useonly
screwsprovided.
Figure 1 - Installing Base Support
Figure 3 - Installing Mantel Base
Figure 4 - Mantel Top Assembly
Figure 2 - Installing Header
1¼''Screws
BaseSupport#10
Base#1
IMPORTANT:Alignmantellefttorightonbasebeforeinstalling.
Cornerofmantellegsmustbeushwithbackofmantelbase
beforeinstallation(seeFigure6,page3).Useatapemeasure
toinsureaccuracy.
IMPORTANT:Use2"screwsonlyontopcentersupport.Using
2"screwsinanyotherlocationwilldamagemantel.
TopCenter
Support#9
MantelTop#5
TopLeft
Support#7 TopTriangle#6 TopRight
Support#8
2''Screws
1¼''Screws
Header#4
RightLeg
Assembly#2
LeftLeg
Assembly#3
1¼''Screws
Headerinto
GrooveonLegs
Header
Assembly
Block
LeftLeg
Assembly
#3
1¼''Screws
Base#1
RightLeg
Assembly
#2
www.fmiproducts.com
123755-01B 3
Figure 6 - Installing Mantel Top
Figure 7 - Installing Gas Fireplace
FIREPLACE INSTALLATION
1. Fireplace should be fully assembled. See Assembling
Fireplaceinreplaceowner’smanual.
2. Mantelmustbeinstalledushwithtwowalls.Remove
baseboardalongwallswheremantelistobeinstalled.
Baseboardwillpreventproperinstallationofmanteland
base.
3. Placemantelbaseclosetoinstallationlocation.Seere-
placeowner’smanualforinstallationclearances.Leave
enoughroomtoinsertreplacefrombackofmantel.
4. Ifinstallinggasreplace,installgasline.SeeConnecting
to Gas Supplyinreplaceowner’smanual.Rememberto
leaveaccesstogasshutoffvalvesomewhereonmantel
baseorwhereitisaccessibletouser.Checkforleaks.
See Checking Gas Connections in replace owner’s
manual.
5. Position replace inside mantel through back opening
(seeFigure7).Carefullypositiongaslinesifapplicable.
IMPORTANT:Usecautionwhenpositioningreplaceon
base.Basemayscratcheasily.Makesurereplaceisin
properpositionwithinmantelopeningbeforecontinuing
withinstallation.
6. Gas replace with louver door: Lower bottom louver
door.Usetwoscrewsprovidedinreplacehardwarekit
andattachreplacetowoodenbase.Closelouverdoor.
Gas replace with xed louver:Beforeinstallinglogs
orburnerassembly(seeowner’smanual)removescrews
securingoortoassembly.Liftoorforaccess to bot-
tomofreplace. Use twoscrews provided inreplace
hardwarekitandattachreplacebasetowoodenbase.
Reinstalloorwithscrewsremovedpreviously.
IMPORTANT:Alignmanteltoplefttorightbeforeinstalling.
Backcornerofmantellegmustbeushwithedgeofmantel
topbeforeinstallation.
IMPORTANT:Ifinstallingagasreplace,verticalsupportwill
beinstalledtomantelassemblyaftergasreplacehasbeen
installed.Ifinstallingelectricreplace,rstinstallverticalsup-
portandinstallreplacefromfrontofmantel.Donotputany
weightonmanteltopuntilverticalsupporthasbeeninstalled.
Figure 5 - Installing Heat Reector Strip
IMPORTANT: Make sure heat reector strip is ush against
header and spacers are on bottom side. Heat strip should
NOT be ush with leg side but should have 1" clearance on
both ends.
Header#4
HeatReector
Strip
1¼''Screws
MantelTop
Assembly
Assembly
Blocks
Assembly
Blocks
Corner
ofMantel
LegsMust
beFlush
withedge
ofMantel
Top
Mantel
LegsFlush
withMantel
Base
1¼''
Screws
123755-01
Rev.B
10/11
2701S.HarborBlvd.
SantaAna,CA92704
1-866-328-4537
www.fmiproducts.com
ELECTRIC FIREPLACE INSTALLATION
ThismantelcanbeusedwithFMIPRODUCTS,LLCelectric
replaces.Electricreplacesinstallfromthefrontofmantel.
Toinstallelectricreplaceseereplaceinstructionmanual.
Vertical Support Installation
Installverticalsupport(seeFigure8).
MANTEL INSTALLATION
1. Carefullypushmantelandbaseintopositionincorner
andushagainstbothwalls.Checkoperationofreplace
beforeproceeding.
2. Placerighttrimstriponrightsideoftopandlefttrimonleft
sideoftop.Alignbothpiecessoanygapsbetweenmantel
andwallarecoveredaswellaspossibleandfrontoftrim
stripsareushwithsideoftop.Withonepersonholding
trimstripsinplace,naileachstriptomantleusingnishing
nailsincludedinhardwarekitandnailset.
Figure 8 - Installing Vertical Support
Figure 9 - Installing Mantel Trim
FinishingNails
TrimStrips
BaseSupport#10
Vertical
Support
#11
1¼''Screws
1¼''Screws
Top
Center
Support
Andere FMI Kamin im Innenbereich Handbücher
FMI
FMI SACMO Gebrauchsanweisung
FMI
FMI UVC-ST 36 Kurzanleitung
FMI
FMI L32HN Bedienungsanleitung
FMI
FMI 36EMW-RBC Kurzanleitung
FMI
FMI (V)CB36N Montageanleitung
FMI
FMI COMPACT HEAT MAJIC FMH26TP Kurzanleitung
FMI
FMI VDVC36 Kurzanleitung
FMI
FMI DVFH34 Kurzanleitung
FMI
FMI T32N-A Kurzanleitung
FMI
FMI CD36MCN-LS Kurzanleitung
FMI
FMI COMPACT HEAT MAJIC Kurzanleitung
FMI
FMI (V)B42 Kurzanleitung
FMI
FMI UV32C Kurzanleitung
FMI
FMI 36ECD Bedienungsanleitung
FMI
FMI S36 Series Bedienungsanleitung
FMI
FMI C36 Kurzanleitung
FMI
FMI EL36LD Bedienungsanleitung
FMI
FMI VSGF33PRC Bedienungsanleitung
FMI
FMI (V)KC36NE series Kurzanleitung
FMI
FMI Outland Living 525 Bedienungsanleitung
