Installation and peration Manual
FoamPro warrants to the original purchaser, each new pump, system or other product of its own manufacture, for a period of one year from the
date of shipment from the factory, to be free from defects in material and workmanship under normal use and service. “Normal use and service”
means not in excess of recommended maximum speeds, pressures, and temperatures, or handling fluids not compatible with components
materials, as noted in applicable FoamPro product catalogs, technical literature, and instructions. This warranty shall not apply to any pump,
system or other product which shall have been repaired or altered to adversely affect the performance or reliability of the pump, system or other
product.
Neither this warranty nor any implied warranty apply to damage or harm caused by any or all of the following: (1) Freight damage; (2) Freezing
damage; (3) Damage caused by parts and/or accessories or components not obtained from or approved by FoamPro; (4) ANY CONSEQUENTIAL
OR INCIDENTAL DA AGES, OTHER THAN INJURY TO THE PERSON, ARISING FRO THE USE OF ANY PU P OR OTHER PRODUCT
ANUFACTURED BY FOA PRO EXCEPT in states that do not allow the exclusion or limitation of incidental or consequential damages; (5)
Damage due to misapplication and/or misuse; (6) Normal wear of moving parts or components affected by moving parts.
The liability of FoamPro under the foregoing warranty is limited to the repair or replacement at FoamPro’s option without charge for labor or
materials of any parts upon return of the entire pump, system or other product or of the particular part to the FoamPro factory within the warranty
period, at the sole expense of the purchaser, which part shall upon examination appear to FoamPro’s satisfaction to have been defective in
material and workmanship.
The liability of FoamPro under any theory of recovery (except any express warranty where the remedy is set forth in the above paragraph) for loss,
harm or damage, shall be limited to the lesser of the actual loss, harm or damage or the purchase price of the involved pump, system or other
product when sold by FoamPro to its customer.
FoamPro expressly warrants its pumps and other products as above stated. THERE ARE NO OTHER EXPRESS WARRANTIES. ANY I PLIED
WARRANTIES, INCLUDING I PLIED WARRANTY OF ERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE, ARE LI ITED
IN DURATION TO ONE YEAR FRO THE DATE OF PURCHASE BY THE ORIGINAL PURCHASER EXCEPT in states that do not allow time
limitations on implied warranties. THERE IS NO I PLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE OR ERCHANTABILITY
WHEN THIS PRODUCT IS PUT TO RENTAL USE.
No person including any dealer or representative of FoamPro is authorized to make any representation or warranty concerning FoamPro products
on behalf of FoamPro, or to assume for FoamPro the obligations contained in this warranty. FoamPro reserves the right to make changes in
design and other changes and improvements upon its products without imposing any obligations upon itself to install the same, upon its existing
products then in process or manufacture.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
IMP RTANT N TICE
It is imperative to package all FoamPro components properly, before shipment (with Return Goods Authorization attached) back to FoamPro. The
FoamPro contains electronic components that may receive damage from improper shipping procedures! All FoamPro components shipped back to
FoamPro will pass through Quality Control Inspection, and will be photographed after the box is opened. Any shipping damage, such as superficial
scratches, nicks, etc., to the unit makes it unusable (even after the internal warranty problem is repaired) and thus must be refinished to “like-new”
condition during the warranty process.You are responsible for any physical damage occurring to FoamPro components at your facility and during
shipment back to FoamPro.
Package the FoamPro, complete with all the recommended parts the Customer Service representative requires (i.e., Digital Display control with all
premolded wire cables etc.) in its original carton with the Styrofoam and other packaging materials, as it was received at your facility.
FoamPro appreciates your attention in this matter, as we feel it will help us to serve you in a better fashion, while keeping the cost of the FoamPro
product competitive. Thank you.
4Warranty
375 Fifth Avenue NW •New Brighton, Minnesota 55112 USA
Phone: (651) 766-6300 •800-533-9511 •Fax: (651) 766-6614
foampro@pentair.com •www.foampro.com
