6│ Installing the FOREST SHUTTLE®iOn battery motor v1.1
Advanced settings
Explanation of the menu settings:
1 & 2: Speed Setting
Standard speed setting is 14cm/s. This can be increased to 17cm/s. Press the configuration button 2 times. To confirm, press and
hold the button down a 3rd time for at least 4 seconds; the led will blink 3 times and turn OFF.
3: Pairing / Erasing mode for 433MHz RF remote
Programming Forest RF remote channel: Press the configuration button 3 times and hold it down the 4th time for 4 seconds -
LED will start blinking for 10 seconds - Within these 10 seconds press the OPEN button on the selected channel on the remote to
pair the remote with the Shuttle® iOn motor.
Erasing a RF remote channel: Same procedure as mentioned above but press CLOSE instead of OPEN to erase the paired RF
remote channel.
4: Reset / setting end limits
To reset the end limits: Make sure the curtain is in the open position first. Now press the configuration button 4 times and hold
it down the 5th time for 4 seconds until the led blinks 3 times and turns OFF. Remove the battery and after 5 seconds re-insert
the battery. Now the limits have been erased; for setting the limits again refer to page 3 section 7 of this manual.
5, 6 & 7: Dry contact input modes
Default mode is Pulse contact. To switch to continuous or single switch mode, press configuration button 6 or 7 times
respectively; press and hold once more for 4 seconds until the led blinks 3 times and turns OFF. Please see page 5 for detailed
explanation on input modes. Make sure the contact is dry / free of potential (no power on the cable).
8, 9 & 10: Touch Impulse modes
The Shuttle® iOn recognizes when the curtain is pulled by hand to open or close. The Shuttle® iOn will then open or close the
curtain all the way. Default setting is high sensitive. Touch Impulse can be set to less sensitive or off, with 9 or 10 presses
respectively. To confirm, press and hold once more for 4 seconds until the led blinks 3 times and turns OFF.
14: Adjust open position (stack back)
Press the button 14 times and hold it down the 15th time for 4 seconds. This function creates a 10 second timeframe in which
the open position of the curtain can be adjusted. This is particularly easy when the curtains are too tightly squeezed together.
15: Reverse Motor direction
This function easily reverses the motor direction when the motor opens instead of closes, after having given the close command
on the remote control. To do so, press the configuration button 15 times and hold it down the 16th time for 4 seconds.
16: Factory Reset
For a full reset of all settings, press configuration button 16 times and hold it down the 17th time for 4 seconds until the led
blinks 3 times and turns OFF. Remove the battery and after 5 seconds re-insert the battery.
