Fortress Technologies P2EF Bedienungsanleitung

P2EF

Deluxe Quick-Access Dual Firearm Safety Device with Biometric Fingerprint Lock

Instruction Manual

Welcome Guide

Features:

BACK

Emergency keyhole Biometric scanner

Buttons Battery compartment

Pneumatic rod Reset button

IMPORTANT SAFEGUARDS

Read these instructions carefully and retain them for future use. If this product is

passed to a third party, then these instructions must be included.

When using electrical appliances, basic safety precautions should always be followed to reduce the

risk of ﬁre, electric shock, and/or injury to persons including the following:

Battery Warnings

• Always insert batteries correctly with regard to polarity (+ and –) as marked on the battery and

the product.

• Exhausted batteries should be immediately removed from product and properly disposed.

SAVE THESE INSTRUCTIONS

Before First Use

• Check for transport damages.

• Clean the product before ﬁrst use.

Risk of suffocation! Keep any packaging materials away from children – these

materials are a potential source of danger, e.g. suffocation.

Opening the Safety Device the First

Time

• Insert the emergency key and turn it clockwise. The safety device is now open.

Battery Installation

• After opening the door using the emergency key, install 4 X AA batteries (not included). To install

the batteries, locate the battery compartment (5). Clip in the batteries and place in the battery

compartment. Pay attention to the “+” and “-” signs. Replace battery compartment cover.

Repeat above steps for battery replacement.

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,

etc) batteries.

Use, care and maintenance information, as well as disposal of batteries information.

DANGER

WARNING

Registering Fingerprints (Maximum

Storage of 50 Fingerprints)

To register your ﬁngerprint, locate the “Reset” button (6).

a. Press and hold the reset button until all lights ﬂash blue once with a beep.

b. Press your ﬁnger to the biometric scanner, then remove your ﬁnger after the scanner light

ﬂashes blue once with a beep.

c. Repeat step B 3 times. Then the scanner light will ﬂash blue twice with two beeps. Now your

ﬁngerprint has been successfully registered.

d. If the scanner light ﬂashes red 5 times with 5 beeps, it means registration has failed and you

must repeat the above steps.

You cannot register more than 50 ﬁngerprints. If the red light ﬂashes 5 times

with 5 beeps when you press the reset button, it means the ﬁngerprint storage

capacity is full.

Deleting the Registered Fingerprint

1. Press and hold the reset button.

2. You will hear a beep together with all lights ﬂash blue once.

3. Keep holding the reset button until you hear another two beeps with the scanner light ﬂashes

twice, then release it.

4. Now all registered ﬁngerprints are erased.

Programming Security Code

The safety device will accept a 4 to 6 digit code. To program your personal code locate the “Reset”

button (6).

a. Press and hold the reset button until all lights ﬂash blue once with a beep.

b. Enter your 4 to 6 digit personal code and press the “Reset” button again to store your new

personal code.

c. If your new personal code has been accepted, the button lights will ﬂash blue twice and then

turn off. You will also hear two audible beeps.

d. If the button lights ﬂash red 5 times with 5 beeps, it means the safety device failed to set the

new personal code. Repeat the steps above until successful.

Please record your new personal code in a safe place.

NOTICE

Opening Safety Device with Security

Code

• With your correct personal code entered (factory pre-set code is 1-2-3-4), the button lights will

light up blue and the safety device will automatically open. If the code is entered incorrectly, the

button lights will ﬂash red ﬁve times with ﬁve audible beeps.

Opening Safety Device with Registered

Fingerprint

• Press your registered ﬁnger to the biometric scanner, the scanner light will light up blue and the

safety device will automatically open. If the ﬁngerprint is invalid, the scanner light will ﬂash red

ﬁve times with ﬁve audible beeps.

Entering the Wrong Code or Invalid

Fingerprint

• If the wrong code or invalid ﬁngerprint is entered ﬁve consecutive times, the safety device will go

into a lock-down mode for ﬁve minutes. During this period all lights will ﬂash red when pressing

any buttons and the electronic keypad will be temporarily disabled. The safety device may still

be opened using the emergency key override. After a ﬁve-minute period the safety device will

automatically resume normal operation.

Turning off the Audible Sound

• To silence the audible sound of the electronics, hold the button “1” until all lights ﬂash blue

once. To unmute the keypad, repeat above step.

Low Battery Warning

• If the 4 AA batteries drop below the required voltage, after entering the correct personal code

or valid ﬁngerprint, the lights will light up blue once when the door is open, then ﬂash yellow ﬁve

times with ﬁve beeps.

• In this case, you will need to replace the batteries.

Securing the Safety Device

Select a stable, dry and secure location for your safety device.

If bolting to the concrete surface:

1. Place the safety device on the selected location. Use a pencil to mark the mounting holes on

the surface.

2. Move the safety device and drill 1.6-inch- deep mounting holes (~40mm) using a 9mm drill bit.

3. Insert the plastic fasteners (included) inside the mounting holes.

4. Move the safety device back in place, aligning the safety device over the holes. Then secure the

safety device with the tapping screws (included).

If bolting to the wooden surface

1. Place the safety device on the selected location.

2. Secure the safety device by driving the tapping screws (included) through the mounting holes.

MADE IN CHINA V2020-01

Inhaltsverzeichnis

Andere Fortress Technologies Sicher Handbücher

Fortress Technologies

Fortress Technologies P1EF Bedienungsanleitung

Beliebte Sicher Handbücher anderer Marken

Squire

Squire Stronghold Keysafe Bedienungsanleitung

Phoenix

Phoenix FS0352C Produktinformationsblatt

Phoenix

Phoenix KS0030E Series Bedienungsanleitung

Vaultek

Vaultek 10 Series Technisches Datenblatt

Arregui

Arregui CLASS Bedienungsanleitung

Beaumont

Beaumont SMART KEYBOX Bedienungsanleitung

Honeywell

Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Bedienungsanleitung

Hornady

Hornady SnapSafe Trunk Safe II Bedienungsanleitung

SPORTS AFIELD

SPORTS AFIELD SA-HD5-BIO Bedienungsanleitung

Honeywell

Honeywell 5912 Bedienungsanleitung

Phoenix

Phoenix FS1280F Bedienungsanleitung

Phoenix

Phoenix SS0992K Produktinformationsblatt

Technomax

Technomax Trony Series Handbuch

SPORTS AFIELD

SPORTS AFIELD INSTINCT BIOMETRIC Series Bedienungsanleitung

RICHTER CZECH

RICHTER CZECH LA Bedienungsanleitung

Olymp

Olymp GOsafe 110 Bedienungsanleitung

Phoenix

Phoenix SS0100E Produktinformationsblatt

Clarke

Clarke Strong-Arm CS1000K Bedienungsanleitung