Foxfury Lighting Solutions Taker B70 Bedienungsanleitung

PRODUCT MANUAL

480-600 | 480-670

TAKERTAKER B70

TABLE OF CONTENTS

INTRODUCTION

Taker B70 Reference Guide 3

Physical Characteristics & Warnings 4

BATTERIES

Battery Installation and Replacement 5

Battery Life 6

OPERATION

Operational Modes 6

FEATURES

Ambidextrous Light Activation 7

Pressure Switch 7

Individual LED Rows 8

Dual Settings 8

WARRANTY 9

CONTACT FOXFURY 10

TAKER B70 REFERENCE GUIDE

LIGHT HEAD

(FRONT)

HANDLE

(BACK SIDE)

LEDs (6)

POWER/MODE

SWITCH (2)

BATTERY

CAP (2) GRIP

HANDLE

(FRONT SIDE)

PRESSURE

SWITCH

PORT

GRIP

KILL SWITCH

PHYSICAL CHARACTERISTICS

Please read below before using the Taker B70 as it relays beneficial operating

and safety information.

LIGHT HEAD

DIMENSIONS (WxH) 8.1 x 1.1 x 3.0 in (206 x 28 x 76 mm)

WEIGHT 11.64 oz (330 g)

HANDLE

DIMENSIONS (WxH) 9.8 x 3.5 x 3.3 in (250 x 88 x 83 mm)

WEIGHT 10.75 oz (304.8 g)

WARNINGS

Do not stare into LEDs for long periods of time or from a close range

(less than 2 ft/ 0.6 m).

FoxFury’s Turbo-Strobe™is purposely designed to induce disorientation.

Prolonged viewing may produce vertigo or even vomiting.

Do NOT attempt to charge the batteries by using the Pressure Switch

Port.

INCLUDED

Taker B70 Shield Light Head

Taker B70 Handle & Square Pressure Switch

BATTERY INSTALLATION AND REPLACEMENT

1. Twist the Battery Cap (at both ends of the handle) in a counter-clockwise

direction to remove them.

2. Insert three (3) batteries (with the negative end first) into either side of the

handle (respect appropriate polarity when installing).

If installing six (6) batteries (doubling battery life), then repeat step 2

one more time on the opposite side of the handle.

3. Re-install the Battery Cap(s) by twisting in a clockwise direction (make

sure the Battery Cap(s) are tightly sealed).

Test the light’s performance and function by activating the Power/

Mode Switch (located under the Grip).

BATTERIES

The Taker B70 uses three (3) or six (6) CR123 batteries. As long as there

are at least three (3) installed, the light will function.

Using three (3) CR123 batteries decreases the battery life by half, but

does not effect the light intensity.

Mixing of new and used, or different brand batteries is not recommended

as this could lead to leakage or explosion.

OPERATIONAL MODES

BATTERY LIFE

MODE BATTERY LIFE LUMENS

MOMENTARY 2 hrs 1,200

CONTINUOUS ON 2 hrs 1,200

TURBO-STROBE™ 4 hrs 1,200

*Battery life may vary according to mode selected, battery quality and prevailing ambient conditions.

For MOMENTARY mode: Press and hold the Power/Mode Switch. While

the Switch is depressed, the light will operate continuously. When the user

removes pressure from the Switch, the light will turn OFF.

For CONTINUOUS ON mode: Press the Power/Mode Switch two (2)

times in rapid succession. The light will remain ON.

For TURBO-STROBE™: Press the Power/Mode Switch three (3) times in

rapid succession.

For OFF or EXIT a mode: Press the Power/Mode Switch once. Then,

continue following the directions above to progress to desired mode.

The Taker B70 has a KILL SWITCH located on the right side of the

Handle behind the Power/Mode Switch. This mechanism is a safety

precaution to make sure the light does not turn on when not intended to.

NOTE: The light does not retain the mode in memory. Once you turn the light

ON, you will have to re-select the mode you desire.

FEATURES

AMBIDEXTROUS LIGHT ACTIVATION

The Taker B70 includes two (2) Power/Mode Switches on both the left and

right sides of the Handle. This allows users to toggle between modes using

either hand.

PRESSURE SWITCH (INCLUDED)

The Taker B70 includes a Square Pressure Switch that allows the user to

place it anywhere on the shield. This makes it easier to access the Power/

Mode Switch. The Pressure Switch can easily be attached to the shield or

Handle via Velcro®or glue.

POWER/MODE

SWITCH

POWER/MODE

SWITCH

PRESSURE

SWITCH PORT

SQUARE PRESSURE SWITCH

HANDLE

(BACK SIDE)

HANDLE

(FRONT SIDE)

KILL SWITCH

CABLE TIE

HOLE (4)

FEATURES (CONT’D)

INDIVIDUAL LED ROWS

The LEDs of the Taker B70 operate on separate circuits, allowing a single row

of LEDs to continue functioning if the other row is damaged.

DUAL SETTINGS

The Taker B70 includes two mode settings: the ON/OFF SETTING and the

TACTICAL SETTING. The ON/OFF SETTING simply allows the Light Head to

turn ON and OFF. The TACTICAL SETTING allows you to choose from three

(3) different Operational Modes: Momentary, Continuous On, and

Turbo-Strobe™. The Taker B70 is shipped in the TACTICAL SETTING.

To change from the TACTICAL SETTING to the ON/OFF SETTING:

With the light turned OFF, press the Power/Mode Switch twice in rapid

succession and hold for 10 seconds. The light should begin to flash. Once

it begins flashing, it is now in the ON/OFF SETTING.

To change from the ON/OFF SETTING to the TACTICAL SETTING:

With the light turned OFF, press and hold the Power/Mode Switch for 10

seconds. The light should begin to go through a slow Turbo-Strobe™ cycle

and then turn OFF. It is now in the TACTICAL SETTING.

PRODUCT DURABILITY

CARE/CLEANING

Your FoxFury product is a professional

tool. Regular maintenance and care of

your light will maximize performance for

you. As needed, wash your FoxFury

product using a soft washcloth, clean

water and a mild soap. Be sure that all

parts are reassembled securely before

washing. When done, pat dry with a

damp cloth.

WARNINGS

FoxFury, LLC is not responsible for the

incorrect use of any FoxFury Lighting

product.

Lights are strong enough to cause

damage to the human eye.

Do not stare into LEDs for long

periods of time or from a close

range (less than 2 ft/ 0.6m).

FoxFury, LLC is not responsible

for any injury or damage caused

during the use of this product.

Usage of this product must be

supervised by an adult when it is

being used by a minor.

Any FoxFury product should be

operated at speeds safe enough

to maneuver around surrounding

obstacles.

Do not use under the influence

of drugs or alcohol.

WARRANTY AND OTHER

INFORMATION

LIMITED WARRANTY

FoxFury, LLC (“FoxFury”) warrants

to the purchaser of this product

(“Buyer”) that for a period of two

years following purchase, this product

will be free from defects in material

and workmanship and will function in

substantial compliance with FoxFury’s

written specifications for this product

as specified in the instruction manual

or on FoxFury’s website located at

www.FoxFury.com. Buyer’s exclusive

remedy shall, in any case, be limited,

at FoxFury’s election, to: A) repair or

replacement of the defective product;

or B) refund of the purchase price for

this product.

THE FOREGOING WARRANTY IS

THE ONLY WARRANTY MADE

BY FOXFURY WITH RESPECT TO

THIS PRODUCT. TO THE EXTENT

ALLOWED BY APPLICABLE LAW,

THERE ARE NO REPRESENTATIONS

OR WARRANTIES OF ANY KIND

BY THE FOXFURY, EXPRESS OR

IMPLIED, WITH RESPECT TO THE

CONDITION OR PERFORMANCE OF

THIS PRODUCT, INCLUDING, BUT

NOT LIMITED TO, MERCHANTABILITY

OR FITNESS FOR A PARTICULAR

PURPOSE.

THIS LIMITED WARRANTY SHALL

NOT APPLY IF THIS PRODUCT IS

NOT STORED, HANDLED, INSTALLED

OR USED IN STRICT ACCORDANCE

WITH MANUFACTURER’S

SPECIFICATIONS AND INSTRUCTION

MANUALS, OR WHICH HAS BEEN

SUBJECT TO MISUSE, ALTERATION,

NEGLIGENCE OR ACCIDENT.

1. The damaged part or product must

be returned to FoxFury PRIOR TO

any repair or replacement. Shipping

costs are the responsibility of the

claimant.

2. You must obtain a return

authorization (RMA) number from

FoxFury prior to returning products.

FoxFury is not responsible for any

damage incurred while in transit.

3. Buyer will be required to

show proof of purchase—NO

EXCEPTIONS.

4. Any modifications to light, cable or

battery pack automatically voids all

warranties on this product.

All warranty inquiries should be directed

to FoxFury’s Customer Service

Department at Service@FoxFury.com

to handle all warranty/repair-related

inquiries.

TO THE EXTENT ALLOWED BY

APPLICABLE LAW: (A) IN NO EVENT,

WHETHER DUE TO BREACH OF

WARRANTY HEREUNDER OR ANY

OTHER CAUSE WHATSOEVER,

SHALL FOXFURY BE LIABLE FOR

OR OBLIGATED IN ANY MANNER TO

PAY CONSEQUENTIAL, INCIDENTAL

OR INDIRECT DAMAGES, INCLUDING,

BUT NOT LIMITED TO, LOSS OF

PROFITS, COST OF SUBSTITUTE

PRODUCTS AND PERSONAL

INJURY OR PROPERTY DAMAGE,

WHETHER SUCH CLAIM IS BASED

ON CONTRACT OR TORT OR ANY

OTHER THEORY OF LAW, AND

(B) FOXFURY’S ONLY DUTIES IN

CONNECTION WITH THE SALE

OF THIS PRODUCT SHALL BE TO

HONOR THE LIMITED WARRANTY

SET FORTH HEREIN. TO THE

EXTENT THAT THIS LIMITED

WARRANTY IS INCONSISTENT WITH

APPLICABLE LAW, THIS STATEMENT

SHALL BE DEEMED MODIFIED

TO BE CONSISTENT WITH SUCH

APPLICABLE LAW.

CONTACT FOXFURY

FoxFury, LLC

Oceanside, CA 92056 USA

Toll-Free: 844-FOXFURY

Tel: 760.945.4231

Fax: 760.433.3650

Email: Service@FoxFury.com

Web: FoxFury.com

All FoxFury products are designed in

Oceanside, CA. All FoxFury products

are manufactured with the highest

quality USA and foreign parts. Products

are assembled in either FoxFury’s

controlled plant in Asia or the USA,

under strict quality control.

Andere Handbücher für Taker B70

Inhaltsverzeichnis

Andere Foxfury Lighting Solutions Beleuchtungsausrüstung Handbücher

Foxfury Lighting Solutions

Foxfury Lighting Solutions TAKER B30 Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions Breakthrough series Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions NOMAD NOW Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad N32 Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions EXOLANDER 700-XLS-IIE Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions MF Series Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Prime Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions NOMAD 360 Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions 750-500 Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Transformer Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Prime Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions RUGO 700-300 Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions SIDESLIDE SERIES Bedienungsanleitung

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Transformer Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung