Franke FTC 922 XS AU Bedienungsanleitung

Instructions for use and installation

Cooker Hood

FTC 922 XS AU

INDEX

RECOMMENDATIONS AND SUGGESTIONS..................................................................................................................... 3

CHARACTERISTICS.............................................................................................................................................................6

INSTALLATION...................................................................................................................................................................... 7

USE........................................................................................................................................................................................ 9

MAINTENANCE...................................................................................................................................................................10

SAFETY INFORMATION

For yo r safety and correct operation of the appliance, read this man al

caref lly before installation and se. Always keep these instr ctions

with the appliance even if yo move or sell it. Users m st f lly know the

operation and safety feat res of the appliance.

The wire connection has to be done by specialized technician.

•The man fact rer will not be held liable for any damages res lting from

incorrect or improper installation.

•The minim m safety distance between the cooker top and the extractor

hood is 650 mm (some models can be installed at a lower height,

please refer to the paragraphs on working dimensions and installation).

•If the instr ctions for installation of the gas hob specify a greater

distance, this m st be respected.

•Check that the mains voltage corresponds to that indicated on the

rating plate fixed to the inside of the hood.

•Means for disconnection m st be incorporated in the fixed wiring in

accordance with the wiring r les.

•For Class I appliances, check that the domestic power s pply

g arantees adeq ate earthing.

•Connect the extractor to the exha st fl e thro gh a pipe of minim m

diameter 120 mm. The ro te of the fl e m st be as short as possible.

•Reg lations concerning the discharge of air have to be f lfilled.

•Do not connect the extractor hood to exha st d cts carrying

comb stion f mes (boilers, fireplaces, etc.).

•

If the extractor is sed in conj nction with non-electrical appliances (e.g. gas

b rning appliances), a s fficient degree of aeration m st be g aranteed in

the room in order to prevent the backflow of exha st gas. When the cooker

hood is sed in conj nction with appliances s pplied with energy other than

electric, the negative press re in the room m st not exceed 0,04 mbar to

prevent f mes being drawn back into the room by the cooker hood.

•The air m st not be discharged into a fl e that is sed for exha sting f mes

from appliances b rning gas or other f els.

•If the s pply cord is damaged, it m st be replaced from the man fact rer or

its service agent.

•Connect the pl g to a socket complying with c rrent reg lations, located in

an accessible place.

•With regards to the technical and safety meas res to be adopted for f me

discharging it is important to closely follow the reg lations provided by the

local a thorities.

WARNING: Before installing the Hood, remove the protective films.

•Use only screws and small parts supplied with the hood.

WARNING: Fail re to install the screws or fixing device in accordance with

these instr ctions may res lt in electrical hazards.

•Allow disconnection of the appliance from the s pply after installation. The

disconnection may be achieved by having the pl g accessible or by incorpo-

rating a switch in the fixed wiring in accordance with the wiring r les.

•Do not look directly at the light thro gh optical devices (binoc lars, magnify-

ing glasses…).

•Do not flambè nder the range hood; risk of fire.

•This appliance can be sed by children aged from 8 years and above and

persons with red ced physical, sensory or mental capabilities or lack of ex-

perience and knowledge if they have been given s pervision or instr ction

concerning se of the appliance in a safe way and nderstand the hazards

involved. Children shall not play with the appliance. Cleaning and ser

maintenance shall not be made by children witho t s pervision.

•

This appliance is not intended for se by persons (incl ding children)

with red ced physical, sensory or mental capabilities, or lack of

experience and knowledge, nless they have been given s pervision or

instr ction concerning se of the appliance by a person responsible for

their safety.

•Children sho ld be s pervised to ens re that they do not play with the

appliance.

Accessible parts may become hot when sed with cooking appliances.

•Clean and/or replace the Filters after the specified time period (Fire

hazard). See paragraph Care and Cleaning.

•There shall be adeq ate ventilation of the room when the range hood is

sed at the same time as appliances b rning gas or other f els (not

applicable to appliances that only discharge the air back into the room).

•The symbol

on the prod ct or on its packaging indicates that this

prod ct may not be treated as ho sehold waste. Instead it shall be

handed over to the applicable collection point for the recycling of

electrical and electronic eq ipment. By ens ring this prod ct is

disposed of correctly, yo will help prevent potential negative

conseq ences for the environment and h man health, which co ld

otherwise be ca sed by inappropriate waste handling of this prod ct.

For more detailed information abo t recycling of this prod ct, please

contact yo r local city office, yo r ho sehold waste disposal service or

the shop where yo p rchased the prod ct.

“In case of replacement with halogen lamp se only self-shielded

t ngsten halogen lamps or self-shielded metal halide lamps.”

EN 6

CHARACTERISTICS

Dimensions

Components

Ref. Q.ty Product Components

11 Hood Body, complete with: Controls, Light, Blower,

Filters

81 Directional Air Outlet grille

91 Flange ø 150 mm

10a 1 Flange ø 120 mm

10b 1 Adapting ring ø 120-125 mm (optional)

20 1 Closing element

Ref. Q.ty Installation Components

12a 4 Screws 3,5 x 16

12e 2 Screws 2,9 x 12,7

12f 5 Screws 2,9 x 9,5

Q.ty Documentation

1 Instruction Manual

12e

12a

12f

10a

10b

EN 7

162

INSTALLATION

Drilling the Support surface and Fitting the Hood

• The Hood can be fitted directly on the lower

surface of the wall furniture units (650 mm min.

above the Cooker Top) using the snap-on Side

Supports.

• Make an opening on the lower surface inside

the furniture unit, as indicated (fig.1); the X-

measure has to be 523 mm (60 and 90 cm

hoods) and 493 mm in case of 55 cm hood

(available for the Swiss market).

• Choose the correct flange measure basing on

the air outlet diameter and insert it to the upper

air outlet opening. (fig.2)

• Screw the closing profile 20 onto the rear part

of the hood, using the screws 12f (2.9 x 9.5)

provided. (fig.3)

• Open the sliding suction panel.

• Remove the metal grease filters one by one af-

ter having disconnected the relative fastening

elements.

• Close the sliding suction panel again.

• Insert the Hood until the snap-on side supports

click into place. (fig.4)

• Open the sliding suction panel.

• Lock in position by tightening the screws Vf

from underneath the Hood. (fig.4)

• If necessary, adjust the whole filter holder unit

and proceed as follows:

• Loosen the four adjustment screws Vr and

close the sliding panel again. (fig.5)

• Move the entire filter holder unit until it is

properly aligned with the wall unit. (fig.6)

• Keeping the hood canopy still, remove the

sliding panel and lock the adjustment

screws again. (fig.5)

• The hood can now be fastened to the wall

unit using the four screws 12a (3.5 x 16)

provided. (fig.7)

• Replace the metal grease filters.

• Close the sliding suction panel again.

12a

10a

10b

EN 8

Connections

DUCTING VERSION AIR EXHAUST SYSTEM

When installing the hood in ducting version, a rigid or a

flexible pipe with the diameter corresponding to the

flange diameter is used in order to connect the hood to

the air outlet piping.

• Fix the pipe with an adequate quantity of pipe

clamps (not supplied).

• Remove possible charcoal filters.

RECIRCULATION VERSION AIR OUTLET

• Cut a hole ø 125 mm in any shelf that may be posi-

tioned over the hood.

• Insert the flange 10a on the hood body outlet.

• Connect the flange to the outlet on the shelf over the

hood using a flexible or rigid pipe ø120 mm.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Fix the directional grille 8on the recirculation air

outlet using the 2 screws 12e (2,9 x 12,7) provided.

• Ensure that the activated charcoal filters have been

inserted.

12e

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole switch having a contact gap of at least 3

mm..

EN 9

USE

By pulling out the sliding panel it is possible to automatically activate all the hood functions.

By simply closing the sliding panel all the functions are switched off.

SWITCH FUNCTIONS

LLight Switches the lighting system on and off

MMotor Switches the extractor motor on and off

1. Low speed, used for a continuous and silent air change in the presence

of light cooking vapour.

2. Medium speed, suitable for most operating conditions, thanks to an op-

timum relation between hood performance and noise.

3. Maximum speed, suitable when the highest cooking vapour emission

has to be eliminated for longer periods.

i. Intensive speed, suitable for the strongest cooking vapours and odours.

EN 1

MAINTENANCEGrease filters

CLEANING METAL CASSETTE GREASE FILTERS

• The filters must be cleaned every 2 months, or more frequently

in case of particularly heavy use of the hood. Filters can be

washed in a dishwasher.

• Pull out the sliding suction panel.

• Remove the filters one by one, after having disconnected the

relative fastening elements.

• Wash the filters, taking care not to bend them. Let them get dry

before refitting them. (The colour of the filter surface may

change throughout the time but this has no influence to the fil-

ter efficiency).

• When refitting the filters, make sure that the handle is visible

on the outside.

• Close the sliding suction panel.

Charcoal filter (Recycling version)

REPLACING CHARCOAL FILTERS

Warning: Turn the lights off and wait until the lamps cool down

before you change the odour filter.

• These filters are not washable and cannot be regenerated, and

must be replaced approximately every four months or more

frequently by particularly heavy use.

• Pull out the sliding suction panel.

• Remove the grease filters.

• Remove the saturated carbon filter by releasing the fixing

hooks

• Fit the new filter by hooking it into its seating.

• Replace the grease filters.

• Close the sliding suction panel.

Inhaltsverzeichnis

Andere Franke Dunstabzugshaube Handbücher

Franke

Franke Frames by Franke FS DW 866 XS Bedienungsanleitung

Franke

Franke FKU 908-H I TC Bedienungsanleitung

Franke

Franke FCR 935 BK/XS I Bedienungsanleitung

Franke

Franke FMY 905 HE Bedienungsanleitung

Franke

Franke ATMOS 604 Bedienungsanleitung

Franke

Franke FVAS A80 BK/2 Bedienungsanleitung

Franke

Franke FDF EG6 60 Bedienungsanleitung

Franke

Franke MARIS FREE 80 Bedienungsanleitung

Franke

Franke FMPL 606 BK B Bedienungsanleitung

Franke

Franke Faber Stilo Glass STGL30SSV Bedienungsanleitung

Franke

Franke FCUD 904 C WH RF UD Bedienungsanleitung

Franke

Franke FCFL 1206 Bedienungsanleitung

Franke

Franke FTU 3807 I XS 77H Bedienungsanleitung

Franke

Franke FPJ 625 V BK/SS Bedienungsanleitung

Franke

Franke FPJ 605 V Bedienungsanleitung

Franke

Franke FMA 2.0 PLUS 907 Bedienungsanleitung

Franke

Franke FAR 625 XS Bedienungsanleitung

Franke

Franke OPAL 762-14 Bedienungsanleitung

Franke

Franke FGL 605-P XS LED0 Bedienungsanleitung

Franke

Franke FDW 908 IB XS Bedienungsanleitung

Franke

Franke FPJ 625 V WH/SS Bedienungsanleitung

Franke

Franke Frames FS TS 906 I XS Bedienungsanleitung

Franke

Franke FSMS F42 SS/BK MATT Bedienungsanleitung

Franke

Franke FGAS/3 E FX 1000 CE XS WM Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch